QQ-94 [AEROFLEX]
RF/Microwave Phase Shifter, 16000 MHz - 17000 MHz, 45 deg - 45 deg RF/MICROWAVE DIGITALLY CONTROLLED PH SHFTR;
| 型号： | QQ-94 |
| 厂家： | 
AEROFLEX CIRCUIT TECHNOLOGY |
| 描述： | RF/Microwave Phase Shifter, 16000 MHz - 17000 MHz, 45 deg - 45 deg RF/MICROWAVE DIGITALLY CONTROLLED PH SHFTR 射频 微波 |
| 文件： | 总1页 (文件大小：128K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
DIGITALLY CONTROLLED ANALOG
PHASE SHIFTERS
SERIES QQ
8, 10, OR 12 BITS
GENERAL INFORMATION
0.25[6,4]
ITT CANNON
DA-15P OR
EQUIV.
0.125[3,18]
KDI/Triangle Corp. digitally controlled phase shifters vary the phase of
a microwave signal in response to a TTL compatible logic input signal.
The unit consists of an analog phase shifter, Series PQ, plus a digital
to analog converter. (See Figure 1)
E
DIA. THRU
3 MTG. HOLES
PIN
1
PIN
9
NOTE: EITHER
RF CONNECTOR
MAY BE USED
FOR INPUT
B
D
A balanced stripline configuration keeps the VSWR and amplitude
change to a minimum for all values of phase.
F
RF
Standard units operate with 8 bits allowing 256 discrete values of
phase. If 10 bits are required add –10 to Model No. (e.g., QQ-12-10). If
12 bits are required add –12 to Model No. (e.g., QQ-12-12).
C
0.10[2,5]
0.38[2.65] TYP.
0.19
[4,826]
SMA
FEMALE
TYP.
1.00
[25,4]
A
ANALOG
PHASE
SHIFTER
RF
RF
ELECTRICAL PERFORMANCE
Phase Shift Insertion
Amplitude
+15
–15
D/A
CONVERTER
Frequency
Range
GHz
Note 4
Minimum
Degrees
45
Loss
Maximum
dB
Ripple
Maximum
dB
Model
No.
QQ-12
VSWR
Out-
FG. 1
Figure 1
Maximum line
0.1–0.2
0.6
0.15
1.35
1.35
1.70
1.50
1.75
1.80
1.60
1.90
1.50
1.90
2.50
2.20
1.75
1.75
2.50
1.65
4
4
2
1
5
5
6
3
6
1
4
1
4
4
1
4
GENERAL SPECIFICATIONS
QQ-16
QQ-17
QQ-27
QQ-28
QQ-34
QQ-44
QQ-45
QQ-49
QQ-60
QQ-65
QQ-66
QQ-72
QQ-73
QQ-74
QQ-94
0.25–0.5
0.25–0.5
0.5–1.0
0.5–1.0
1.0–2.0
2.0–4.0
2.0–4.0
2.2–2.3
4.0–8.0
6.0–18.0
7.0–12.4
8.0–12.4
8.0–10.0
8.0–18.0
16.0–17.0
45
360
180
360
360
180
360
180
360
180
360
60
0.6
4.5
0.15
1.25
0.40
1.25
1.50
0.50
1.50
0.30
1.50
2.0
Frequency Coverage:
RF Impedance:
RF Power:
0.1 to 18.0 GHz
50 OHMS.
3.0
10 mW peak or CW, operating. Destruct
level is 1 W, CW, 100 W peak.
4.5
4.5
Temperature Information: The units can be used over a –55°C to
+85°C temperature range. However, the
phase will change either ±5° or ±5%,
whichever is greater. If temperature com-
pensation is required, this can be done
on request. With compensation, the vari-
ation can be held to ±1° or ±1%,
whichever is greater, from –55°C to
+85°C. Compensation increases the cost
by 10%. The size remains the same. If
compensation is desired, add a suffix T
to the model number, e.g. (QQ-17T).
3.0
5.0
2.0
8.0
12.0
12.0
2.0
2.0
0.25
1.0
180
360
45
4.5
17.0
2.0
3.5
Connectors:
SMA. Mating multipin connector is sup-
plied with each unit; ITT Cannon DA-15S
or equiv.
0.20
MECHANICAL OUTLINES
Notes:
A
in
B
in
C
in
D
in
[mm]
1.800
E
in
[mm]
4.500
F
in
[mm]
0.50
1. The voltages required are Ϯ15 volts at 50 mA.
2. Switching speed of all models is 200 nanosec. Higher speeds on
request. For 12 bits speed is 2 microsec.
Outline
1
[mm]
5.00
[mm]
2.00
[mm]
N/A
3. Monotonicity is guaranteed for all models.
4. Phase Flatness: The phase shift varies with frequency at any volt-
age setting. This variation, referred to 0° at logic 0 for each fre-
quency, is approximately Ϯ15% for octave models, Ϯ10% for
models with 25% bandwidth, and Ϯ7.5% for models with a 10%
bandwidth.
[127,0]
7.75
[50,8]
2.50
4 holes
N/A
[45,7]
2.300
[58,42]
1.800
[45,7]
1.800
[45,7]
2.300
[58,42]
1.800
[45,7]
[114,3]
7.250
[12,7]
0.75
2
3
4
5
6
[196,9]
6.50
[63,5]
2.00
4 holes
N/A
[184,15]
6.000
[19,1]
0.25
5. In order to determine the step size (least significant bit) of any
phase shifter, divide the listed value of phase shift by the number
[165,1]
3.00
[50,8]
2.00
4 holes
1.50
[152,4]
2.500
[6,4]
0.30
of steps.
POWER LOGIC
PIN CONNECTIONS
[76,2]
7.75
[50,8]
2.50
[38,1]
N/A
[63,5]
[7,6]
0.25
# Bits
8
10
# Steps
256
1024
4096
PIN*
1–12
13
14
15
FUNCTION
Logic Inputs
+15 VDC
–15 VDC
GND
7.250
[196,9]
5.00
[63,5]
2.00
4 holes
N/A
[184,15]
4.500
[6,4]
0.25
12
[127,0]
[50,8]
4 holes
[114,3]
[6,4]
*PIN 1 is least significant bit
KEY: Inches[Millimeters] .XX .ꢀ0 .XXX .ꢀꢁꢀ [.X ꢀ.ꢂ .XX ꢀ.ꢃ2]
60 South Jefferson Road, Whippany, NJ 07981
Tel: 973-887-8100 • Fax: 973-884-0445
email: sales@aeroflex-kdi.com
See us on the web @ www.aeroflex-kdi.com
8-10-07
©2020 ICPDF网 联系我们和版权申明