RHD5900 [AEROFLEX]
RadHard-by-Design RHD5900 Quad Operational Amplifier;
| 型号： | RHD5900 |
| 厂家： | 
AEROFLEX CIRCUIT TECHNOLOGY |
| 描述： | RadHard-by-Design RHD5900 Quad Operational Amplifier |
| 文件： | 总6页 (文件大小：281K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Standard Products
RadHard-by-Design
RHD5900 Quad Operational Amplifier
www.aeroflex.com/RHDseries
April 8, 2013
FEATURES
Single power supply operation (3.3V to 5.0V) or dual power supply operation (±1.65 to ±2.5V)
Radiation performance
- Total dose:
>1Mrad(Si); Dose rate = 50 - 300 rads(Si)/s
- ELDRS Immune
- SEL Immune
>100 MeV-cm2/mg
- Neutron Displacement Damage >1014 neutrons/cm2
Rail-to-Rail input and output range
Short Circuit Tolerant
Full military temperature range
Designed for aerospace and high reliability space applications
Packaging – Hermetic ceramic SOIC
- 16-pin, .411"L x .293"W x .105"Ht
- Weight - 0.8 grams max
Aeroflex Plainview’s Radiation Hardness Assurance Plan is DLA Certified to MIL-PRF-38534, Appendix G.
GENERAL DESCRIPTION
Aeroflex’s RHD5900 is a radiation hardened, single supply, quad operational amplifier in a 16-pin SOIC
package. The RHD5900 design uses specific circuit topology and layout methods to mitigate total ionizing
dose effects and single event latchup. These characteristics make the RHD5900 especially suited for the
harsh environment encountered in Deep Space missions. It is guaranteed operational from -55°C to
+125°C. Available screened in accordance with MIL-PRF-38534 Class K, the RHD5900 is ideal for
demanding military and space applications.
ORGANIZATION AND APPLICATION
The RHD5900 amplifiers are capable of rail-to-rail input and outputs. Performance characteristics listed are
for general purpose operational 5V CMOS amplifier applications. The amplifiers will drive substantial
resistive or capacitive loads and are unity gain stable under normal conditions. Resistive loads in the low
kohm range can be handled without gain derating and capacitive loads of several nF can be tolerated.
CMOS device drive has a negative temperature coefficient and the devices are therefore inherently tolerant
to momentary shorts, although on chip thermal shutdown is not provided. All inputs and outputs are diode
protected.
The devices will not latch with SEU events to above 100 MeV-cm2/mg. Total dose degradation is minimal
to above 1Mrad(Si). Displacement damage environments to neutron fluence equivalents in the mid 1014
neutrons per cm2 range are readily tolerated. There is no sensitivity to low-dose rate (ELDRS) effects. SEU
effects are application dependent.
SCD5900 Rev G
VCC
4
3
+IN_A
-IN_A
1
A
OUT_A
OUT_B
OUT_C
OUT_D
2
5
+IN_B
-IN_B
7
B
6
12
+IN_C
-IN_C
10
16
C
D
11
14
+IN_D
-IN_D
15
13
VEE
FIGURE 1: BLOCK DIAGRAM
OUT_A
-IN_A
+IN_A
VCC
1
2
3
4
5
6
7
8
OUT_D
-IN_D
+IN_D
VEE
16
15
14
RHD590013
+IN_B
-IN_B
OUT_B
N/C
+IN_C
-IN_C
OUT_C
N/C
12
11
10
9
16-Pin SOIC
FIGURE 2: PACKAGE PIN-OUT
Notes:
1. Package and lid are electrically isolated from signal pads.
2. It is recommended that N/C or no connect pins (pins 8 and 9) and lid be grounded. This eliminates or minimizes any ESD or static buildup.
SCD5900 Rev G 4/8/13
Aeroflex Plainview
2
ABSOLUTE MAXIMUM RATINGS
Parameter
Range
Units
Case Operating Temperature Range
Storage Temperature Range
Junction Temperature
-55 to +125
-65 to +150
+150
°C
°C
°C
V
Supply Voltage VCC - VEE
+6.0
VCC +0.4
VEE -0.4
Input Voltage
V
Lead Temperature (soldering, 10 seconds)
300
°C
°C/W
V
Thermal Resistance, Junction to Case,jc
7
ESD Rating (MIL-STD-883, Method 3015, class 2)
Power @25°C
2,000 - 3,999
200
mW
NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress rating only;
functional operation beyond the “Operation Conditions” is not recommended and extended exposure beyond the “Operation Conditions” may affect
device reliability.
RECOMMENDED OPERATING CONDITIONS
Symbol
Parameter
Typical
Units
+VCC
VCM
Power Supply Voltage
3.3 to 5.0
V
V
Input Common Mode Range
VCC to VEE
ELECTRICAL PERFORMANCE CHARACTERISTICS
(TC = -55°C TO +125°C, +VCC = +5.0V -- UNLESS OTHERWISE SPECIFIED)
Parameter
Symbol
Conditions
Min
Typ
Max
Units
Quiescent Supply Current 1/
Input Offset Voltage 1/
Input Offset Current 1/
ICCQ
VOS
IOS
No Load
4.7
0.80
10
5.5
3
mA
mV
pA
-3
-100
-100
-1000
70
100
100
1000
TC = +25°C, -55°C 1/
TC = +125°C
10
Input Bias Current
IB
pA
100
90
Common Mode Rejection Ratio
Power Supply Rejection Ratio
Output Voltage High
CMRR
PSRR
VOH
dB
dB
90
70
ROUT=3.6K to GND
ROUT=3.6K to VCC
VOUT to VCC
V
4.9
Output Voltage Low
VOL
0.1
-75
55
V
IO(SINK)
IO(SOURCE)
SR
mA
mA
V/uS
dB
-30
45
2.0
90
4
Short Circuit
Output Current 2/
VOUT to VEE
Slew Rate 1/
RL = 8K, Gain = 1
No Load
3.3
100
6.5
Open Loop Gain 1/
AOL
Unity Gain Bandwidth 1/
Channel Separation 2/
Input-Referred Voltage Noise 2/
UGBW
RL = 10K
MHz
dB
RL = 2K, f = 1.0KHz
F = 5 kHz
84
en
15
nV/
Hz
m
Phase Margin 2/
Notes:
TC 25 °C, No Load
Deg
30
1/ Specification derated to reflect Total Dose exposure to 1 Mrad(Si) @ +25°C.
2/ Not Tested. Shall be guaranteed by design, characterization, or correlation to other test parameters.
SCD5900 Rev G 4/8/13
Aeroflex Plainview
3
RHD5900 QUAD OPERATIONAL AMPLIFIER APPLICATION NOTES
APPLICATION NOTE 1: DUAL POWER SUPPLY AMPLIFIER
Inverting Amplifier
Non Inverting Amplifier
R2
R1
R2
R1
VOUT= –VIN ------
VOUT= VIN 1 + ------
+2.5V
-2.5V
R1
R2
VIN
VIN
VOUT
+2.5V
-2.5V
R2
R1
VOUT
APPLICATION NOTE 2: SINGLE POWER SUPPLY AMPLIFIER
Inverting Amplifier
Non Inverting Amplifier
R2
R1
R2
R1
VOUT= –VIN ------
VOUT= VIN 1 + ------
R2
+5V
R3
V
R1
R3
+5V
+5V
V
IN
VIN
BIAS
VOUT
VOUT
V
BIAS
+5V
R4
R2
R1
R4
Note: For VOUT DC @ mid range of common mode voltage range, VBIAS = 2.5/(1+R2/R1), VBIAS = +5*R4/(R3+R4)
SCD5900 Rev G 4/8/13
Aeroflex Plainview
4
APPLICATION NOTE 3: DIFFERENTIAL INPUT AMPLIFIER
Differential Input Amplifier
R4
R3 + R4
R2
R2
R1
VOUT = V2 -------------------- 1 + ------ – V1------
R1
R2
R1
V1
V2
VCC
VOUT
R3
VEE
R4
Note: Package and lid are electrically
isolated from signal pads.
FIGURE 3: PACKAGE OUTLINE
SCD5900 Rev G 4/8/13
Aeroflex Plainview
5
ORDERING INFORMATION
Model
DLA SMD #
Screening
Package
RHD5900-7
Commercial Flow, +25°C testing only
-
Military Temperature, -55°C to +125°C
Screened in accordance with the individual Test Methods
of MIL-STD-883 for Space Applications
RHD5900-S
-
16-pin
SOIC Package
RHD5900-201-1S
RHD5900-201-2S
RHD5900-901-1S
RHD5900-901-2S
5962-1024101KXC
5962-1024101KXA
5962H1024101KXC
5962H1024101KXA
In accordance with DLA SMD
In accordance with DLA Certified RHA Program Plan to
RHA Level "H", 1Mrad(Si)
EXPORT CONTROL:
EXPORT WARNING:
This product is controlled for export under the International Traffic in
Arms Regulations (ITAR). A license from the U.S. Department of
State is required prior to the export of this product from the United
States.
Aeroflex’s military and space products are controlled for export under
the International Traffic in Arms Regulations (ITAR) and may not be
sold or proposed or offered for sale to certain countries. (See ITAR
126.1 for complete information.)
PLAINVIEW, NEW YORK
INTERNATIONAL
NORTHEAST
Tel: 603-888-3975
Fax: 603-888-4585
Toll Free: 800-THE-1553
Tel: 805-778-9229
Fax: 516-694-6715
Fax: 805-778-1980
SE AND MID-ATLANTIC
Tel: 321-951-4164
WEST COAST
Tel: 949-362-2260
CENTRAL
Tel: 719-594-8017
Fax: 321-951-4254
Fax: 949-362-2266
Fax: 719-594-8468
w w w . a e r o f l e x . c o m
i n f o - a m s @ a e r o f l e x . c o m
Aeroflex Microelectronic Solutions reserves the right to
change at any time without notice the specifications, design,
function, or form of its products described herein. All
parameters must be validated for each customer's application
by engineering. No liability is assumed as a result of use of
this product. No patent licenses are implied.
Our passion for performance is defined by three
attributes represented by these three icons:
solution-minded, performance-driven and customer-focused
SCD5900 Rev G 4/8/13
6
相关型号：
©2020 ICPDF网 联系我们和版权申明