VRG8666-901-1S [AEROFLEX]
Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant;型号: | VRG8666-901-1S |
厂家: | AEROFLEX CIRCUIT TECHNOLOGY |
描述: | Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant |
文件: | 总6页 (文件大小:559K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Datasheet
Standard Products
VRG8666
Voltage Regulator, 1.0 Amp, Positive
Ultra Low Dropout (ULDO), Adjustable
Radiation Tolerant
www.aeroflex.com/voltreg
February 29, 2016
FEATURES
Manufactured using
Space Qualified RH3080 die
Radiation performance
Total dose: 100 krads(Si), Dose rate = 50 - 300 rads(Si)/s
ELDRS:
50 krads(Si), Dose rate <
0.01 rads(Si)/s
Current Limit with Foldback and Over-temperature protection
Output voltage adjustable: 0V to 36V
Outputs may be paralleled for higher current
Post Radiated Dropout voltage:
0.60V @ 1.0Amps
0.39V @ 0.5Amps
Output current: 1.0Amps
Packaging – Hermetic Ceramic
Hermetic Surface Mount Power
5 Pads, .545"L x .296"W x .120"Ht
Weight - 2.0 gm max
Designed for aerospace and high reliability space applications
Aeroflex Plainview’s Radiation Hardness Assurance Plan is DLA Certified to MIL-PRF-38534, Appendix G.
DESCRIPTION
The Aeroflex Plainview VRG8666 consists of a Positive Adjustable (RH3080) ULDO voltage regulator
capable of supplying 1.0Amps over the output voltage range as defined under recommended operating
conditions. The VRG8666 offers excellent line and load regulation specifications and ripple rejection.
The VRG8666 serves a wide variety of applications including SCSI-2 Active Terminator, High Efficiency
Linear Regulators, Post Regulators for Switching Supplies, Constant Current Regulators, Battery Chargers
and Microprocessor Supply.
The VRG8666 has been specifically designed to meet exposure to radiation environments and is configured
for an SMD power package. It is guaranteed operational from -55°C to +125°C. Available screened to
MIL-STD-883, the VRG8666 is ideal for demanding military and space applications.
Dropout (VIN - VOUT) decreases at lower load currents.
Input capacitance is required for load regulation. 1uF is recommended on Vin and Vcontrol. For stable
operation, a 0.1uF capacitor should be placed on Vset and a low ESR capacitor on Vout. See Figure 5.
For detailed performance characteristic curves, applications information and typical applications see the
latest
Linear Technology Corporation ® data sheets for their RH/LT3080, which is available
on-line at www.linear.com.
3
SET
OUT
VCONTROL
5
4
RH3080
Positive Regulator
SENSE
IN
2
1
FIGURE 1 – BLOCK DIAGRAM / SCHEMATIC
SCD8666 Rev L
ABSOLUTE MAXIMUM RATINGS
Parameter
Rating
+40, -0.3
1.2
Units
VDC
A
Input Voltage, VCONTROL (Voltages are Relative to VOUT)
Output Current
Lead temperature (soldering 10 Sec)
Input Output Differential
°C
300
26
VDC
VDC
V
Output Voltage
+36
ESD 1/
2,000 - 3,999
-55 to +150
-65 to +150
5
Operating Junction Temperature Range
Storage Temperature Range
Thermal Resistance (Junction to Case) JC
°C
°C
°C/W
1/ Meets ESD testing per MIL-STD-883, method 3015, Class 2.
NOTICE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are
stress rating only; functional operation beyond the "Operation Conditions" is not recommended and extended exposure
beyond the "Operation Conditions" may effect device reliability.
RECOMMENDED OPERATING CONDITIONS
Parameter
Range
Units
Output Voltage Range
VDC
0 to 35
Input Output Differential
VDC
°C
V
0.5 to 26
-55 to +125
1 to 36
Case Operating Temperature Range
Input Voltage (Voltages are Relative to VOUT)
VCONTROL (Voltages are Relative to VOUT)
1.6 to 36
V
ELECTRICAL PERFORMANCE CHARACTERISTICS
Unless otherwise specified: -55°C < Tc < +125°C.
Parameter
Symbol
M i n
M a x U n i ts
Conditions (P < PMAX)
1.0mA < ILOAD < 1.0A, (VIN - VOUT) = 1.6V
VIN = 1V, VCONTROL = 2V, ILOAD = 1mA
Set Pin Current
IREF
1
9.85 10.35
9.85 10.35
µA
µA
IREF
2
Set Pin Current 1/
Output Offset Voltage
(VOUT - VSET) 1/
VOS
VIN = 1V, VCONTROL = 2V, ILOAD = 1mA,
-9.0
9.0
mV
1V < VIN < 26V, 2V < VCONTROL < 26V,
ILOAD = 1mA
Line Regulation 1/
Load Regulation 1/
-0.15 0.15 mV/V
VOS
VOS
(VIN - VOUT) = 3V, ILO AD = 1mA to 0.1A
ILOAD = 1.0A
-1.4
1.4
1.60
1.60
0.5
0.25
-
mV
V
-
VCONTROL Dropout Voltage 2/ VCDROP
ILOAD = 0.1A 1/, 4/
-
ILOAD = 1.0A
-
-
VIN Dropout Voltage 2/
VINDROP
V
ILOAD = 0.1A 1/, 4/
Current Limit 3/
IMAX
IMIN
VIN = VCONTROL = +5V, VSET = 0V , VOUT = 0.1V
VIN = VCONTROL = 26V, VOUT = 0.1V
1.1
-
A
Minimum Load Current 1/, 4/
0.9
mA
ILOAD = 0.2A, (VIN - VOUT) = 3V, f = 120Hz,
COUT = 2.2µF, CSET = 0.1µF
Ripple Rejection
Thermal Regulation
Notes:
-
-
60
-
-
dB
30ms pulse, TC = +25°C
0.03 %/W
1/ Specification derated to reflect Total Dose exposure to 100 Krad (Si) @+25°C.
2/ Dropout results from either minimum control voltage, VCONTROL, or minimum input voltage, VIN, both specified with respect to
VOUT. These specifications represent the minimum input-to-output differential voltage required to maintain regulation.
3/ Pulsed @ <10% duty cycle @ +25°C for characterization only. (See note 1/).
4/ Not tested. Shall be guaranteed to the specified limits.
SCD8666 Rev L 2/29/16
Aeroflex Plainview
2
FIGURE 2 – MAXIMUM POWER vs CASE TEMPERATURE
The maximum Power dissipation is limited by the thermal shutdown function of the regulator chip in the VRG8666.
The graph above represents the achievable power before the chip shuts down. The line in the graph represents the
maximum power dissipation of the VRG8666 This graph is based on the maximum junction temperature of 150°C
and a thermal resistance (JC) of 5°C/W.
SCD8666 Rev L 2/29/16
Aeroflex Plainview
3
FIGURE 3 – RH3080 TYPICAL CURRENT LIMIT
FIGURE 4 – RH3080 TYPICAL DROPOUT
VOLTAGE CURVE, VCONTROL > 1.6V
FIGURE 5 – BASIC VRG8666 ADJUSTABLE REGULATOR APPLICATION
SCD8666 Rev L 2/29/16
Aeroflex Plainview
4
.095
4 Places
.301
MAX
Pin 1
Epoxy Dot
(on side)
R.025 MAX
6 Places
.030 MIN
.005
.120
4 Places
4
1
.030
MIN
.550
5
.200
.005
MAX
.030
MIN
3
2
.150
.286
.005
.005
4X R.020
NOTES:
.015
3 Places
.127
MAX
1. Package & Lid are electrically isolated from signal pads
FIGURE 6 – PACKAGE OUTLINE — SURFACE MOUNT
SCD8666 Rev L 2/29/16
Aeroflex Plainview
5
ORDERING INFORMATION
Model
DLA SMD #
Screening
Package
VRG8666-7
-
Commercial Flow, +25°C testing only
VRG8666-201-1S
VRG8666-201-2S
VRG8666-901-1S
VRG8666-901-2S
5962-1120501KYC
5962-1120501KYA
5962R1120501KYC
5962R1120501KYA
In accordance with DLA SMD
SMD
Power Pkg
In accordance with DLA Certified RHA Program Plan to RHA
Level "R", 100krads(Si)
For detailed performance characteristic curves, applications information and typical applications see the latest
datasheet for their RH3080, which is available on-line at www.linear.com.
EXPORT CONTROL:
This product is controlled for export under the Export Administration Regulations (EAR), 15 CFR Parts 730-774.
A license from the Department of Commerce may be required prior to the export of this product from the United States.
w w w . a e r o f l e x . c o m / H i R e l
i n f o - a m s @ a e r o f l e x . c o m
Datasheet Definitions:
Advanced
Preliminary Shipping Non-Flight Prototypes
Datasheet Shipping QML and Reduced HiRe
Product in Development
l
Aeroflex Plainview, Inc. reserves the right to make changes to any products and
services described herein at any time without notice. Consult Aeroflex or an authorized
sales representative to verify that the information in this data sheet is current before
using this product. Aeroflex does not assume any responsibility or liability arising out
of the application or use of any product or service described herein, except as expressly
agreed to in writing by Aeroflex; nor does the purchase, lease, or use of a product or
service from Aeroflex convey a license under any patent rights, copyrights, trademark
rights, or any other of the intellectual rights of Aeroflex or of third parties.
Our passion for performance is defined by three attributes.
Solution-Minded
Performance-Driven
Customer-Focused
LT, LTC,
, Linear Technology and the Linear logo are registered trademarks and RH3080 is copyright Linear Technology Corporation.
SCD8666 Rev L 2/29/16
6
相关型号:
VRG8666-901-2S
Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8667
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8667-7
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8667-901-1S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8667-901-2S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8667-S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8668
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8668-7
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8668-901-1S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8668-901-2S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8668-S
Dual Voltage Regulator, 1.0 Amp, Positive Ultra Low Dropout (ULDO), Adjustable Radiation Tolerant
AEROFLEX
VRG8684
Voltage Regulator, 3.0 Amp, Positive Low Dropout (LDO), Adjustable Radiation Tolerant
AEROFLEX
©2020 ICPDF网 联系我们和版权申明