Electronic Components Datasheet Search
English 中文版
Manufacturer Upload
Part Name:
 
Description:
CLK15_6P Cyclone III Device Handbook
Prototype PCB
Part No.:   CLK15_6P
Download: Download   Right selection Save Target As
View Datasheet (Html)   No need to install PDF reader software
Description:   Cyclone III Device Handbook
File Size :   7302 K    
Page : 274 Pages
Logo:   
Maker   ALTERA [ ALTERA CORPORATION ]http://www.altera.com
Buy Now :   
  CLK15_6P Datasheet PDF page 151 CLK15_6P Datasheet PDF page 152 CLK15_6P Datasheet PDF page 153 CLK15_6P Datasheet PDF page 154 CLK15_6P Datasheet PDF page 156 CLK15_6P Datasheet PDF page 157 CLK15_6P Datasheet PDF page 158 CLK15_6P Datasheet PDF page 159  
100%
Chapter 8: External Memory Interfaces in the Cyclone III Device Family
Cyclone III Device Family Memory Interfaces Features
8–13
f
For more information about Cyclone III device family IOE registers, refer to the
chapter.
shows how the second output enable register extends the
DQS
high-impedance state by half a clock cycle during a write operation.
Figure 8–6. Extending the OE Disable by Half a Clock Cycle for a Write Transaction
System clock
(outclock for DQS)
OE for DQS
(from logic array)
DQS
Write Clock
(outclock for DQ,
-90
o
phase shifted
from System Clock)
datain_h
(from logic array)
datain_I
(from logic array)
OE for DQ
(from logic array)
DQ
D0
D1
D2
D3
90
o
Delay
by
Half
a Clock
Cycle
Preamble
Postamble
D0
D2
D1
D3
Note to
(1) The waveform reflects the software simulation result. The
OE
signal is an active low on the device. However, the Quartus II software implements
the signal as an active high and automatically adds an inverter before the A
OE
register D input.
OCT
Cyclone III device family supports calibrated on-chip series termination (R
S
OCT) in
both vertical and horizontal I/O banks. To use the calibrated OCT, you must use the
RUP and RDN pins for each R
S
OCT control block (one for each side). You can use
each OCT calibration block to calibrate one type of termination with the same V
CCIO
for that given side.
f
For more information about Cyclone III device family OCT calibration block, refer to
the
chapter.
PLL
When interfacing with external memory, the PLL is used to generate the memory
system clock, the write clock, the capture clock and the logic-core clock. The system
clock generates the
DQS
write signals, commands, and addresses. The write-clock is
shifted by -90° from the system clock and generates the
DQ
signals during writes. You
can use the PLL reconfiguration feature to calibrate the read-capture phase shift to
balance the setup and hold margins.
July 2012
Altera Corporation
Cyclone III Device Handbook
Volume 1
Home - IC Supply - Link
Copyright© 2001 - 2014 ICPDF All Rights Reserved ICPDF.COM

粤公网安备 44030402000629号


粤ICP备13051289号-7