W30-38E-2-S [AMPHENOL]
General Eastern Liquid Differential Pressure Transmitters;型号: | W30-38E-2-S |
厂家: | Amphenol |
描述: | General Eastern Liquid Differential Pressure Transmitters |
文件: | 总4页 (文件大小:70K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Modus W Series
General Eastern Liquid
Differential Pressure
Transmitters
The Modus W Series pressure transmitters are
designed to measure low differential pressures
of liquids or gases. A wide selection of standard
pressure ranges and electrical ratings is available.
The transmitters are housed in a compact,
heavy duty, gasketted, cast aluminum
enclosure designed to IP 65 of IEC 529
standards and Type 4. The die cast aluminum
enclosure incorporates a recessed neoprene
gasket to prevent the ingress of moisture or
dust. Wall mounting holes are enclosed in
the cast aluminum box and concealed by the
cover. The wall mounting holes and the cover
attaching screws are outside the gasketted
area.
These transmitters feature no moving parts
to wear out, a proven long term stability of
piezoresistive devices, only 316 stainless steel
in contact with the fluid, and an all-welded
construction.
Modus W Series transmitters are an excellent
choice for many HVAC, process and automation
monitoring requirements. Typical applications
include measurement of differential pressure
across flow elements, heat exchangers, pumps
and filters, liquid level monitoring and other
demanding differential pressure measurement
and control applications.
Access to the electrical terminals are made
through knockouts on the front of the box. A
choice of two knockouts and three hole sizes
are available to accommodate usage of 0.5
in (12.7 mm) conduit or metric sizes PG11 and
PG13.
Pluggable terminal block connectors are
provided with wire protection and captive
terminal screws.
The Modus W Series includes one model:
Model W30.
Amphenol
Advanced Sensors
This model is available with the following power and
signal configuration:
Operation
The pressure transmitter consists of two high accuracy
piezoresistive sensors with stainless steel isolation
diaphragms. Both sensors measure static pressure, and
the difference between these two measurements is
computed electronically. The use of high accuracy and
stable sensors makes this measurement possible. Since
each sensor measures the full static pressure, there is
no possibility of over-pressurizing the transmitter if one
sensor is disconnected from the line. No complex and/
or expensive balancing valves are needed.
Model W30
• Two-wire
• DC Voltage In
• 4 to 20 mA out
The span or zero adjustment is performed with a
20-turn potentiometer for fine resolution. A 50%
adjustment in output is possible.
The Series W transmitters comply with the European
requirements of Council Directive 2004/108/EC.
Electrical Connectors
W Series
Polarized Euro plug/connectors.
Specifications
Connections
Pluggable terminal block for wire 14 to 26 AWG.
Mating connector is supplied
Performance
Accuracy
Connection to enclosure ground is provided.
1/2% of differential pressure range (includes non-
linearity and hysteresis) or 1% for 6 psid (50 kPA)
range
Connector rating
10 Amps/300 V
Effect of Static Pressure on Differential Pressure
Material
Glass-filled polyester
Measurement
Less than 0.25% for static pressure change from 0 to
100% or 0.5% for 6 psid (50 kPa) range
Physical
Calibration
Traceable to National Institute of Standards and
Technology (NIST)
Dimensions
3.56 in x 4.54 in x 2.18 in (90 mm x 115 mm x 55 mm)
Enclosure material
Aluminum Alloy #A380
Environmental
Process wetted surfaces are 316 stainless steel.
Cover screws
M4 stainless steel non-magnetic
Operating Temperature Range
32°F to 122°F (0°C to 50°C)
Finish
Black epoxy paint
Storage Temperature
-20°F to 160°F (-30°C to 70°C)
Knockout
• Choice of 2 holes
Effect of Temperature
• On zero: 0.05%/°C or 0.1%/°C for 6 psid (50 kPa)
• Hole sizes are offered in a choice of 1/2 in (12.7 mm)
conduit or metric sizes of PG11 or PG13.
• Cable glands not included.
range
• On span: 0.03%/°C or 0.06%/°C for 6 psid (50 kPa)
range
Pressure port connections
1/8-28 female NPT
Operating Humidity Range
10% to 90% RH, non-condensing
Weight
1.2 lb (540 g)
Shock Resistance
10 G (11 ms)
Vibration Resistance
5 G 3 to 50 Hz
W30 Series
Specifications
Electrical
Supply Voltage
11 to 32 VDC (See diagram for maximum loop
resistance)
Operating
Region
0
10
20
30
Output
Two-wire/4 to 20 mA output
Power Supply Voltage
*Loop resistance = wire resistance + receiver resistance
Protected against reversal of polarity. Output limited
to approximately 3.85 mA at low end of span and
approximately 25 mA at upper end of span.
Power Supply
11
1
2
3
4
Enclosure
Ground
Standard Pressure Ranges for Modus
W Series
+
Receiver
-
Wire
-
US Units
0 to 1050 W
Wire
+
Differential Pressure
Range, psid
Operating Static
Pressure, psi
Pressure Code
31E
32E
33E
34E
35E
36E
37E
38E
0 to 6 psi
Metric Units, Pascal
0 to 10 psi
0 to 15 psi
0 to 30 psi
0 to 60 psi
0 to 100 psi
0 to 150 psi
0 to 200 psi
0 to 100 psi
0 to 300 psi
Differential Pressure
Range, kPa
Operating Static
Pressure, kPa
Pressure Code
31P
32P
33P
34P
35P
36P
37P
38P
0 to 50 Pa
0 to 75 Pa
0 to 700 kPa*
0 to 100 Pa
0 to 200 Pa
0 to 500 Pa
0 to 750 Pa
0 to 1000 Pa
0 to 1500Pa
0 to 2000 kPa
Metric Units, Millimeters of Water
Differential Pressure
Range, k mm H2O
Operating Static
Pressure, k mm H2O
Pressure Code
31M
0 to 5.0 k mm H20
0 to 7.5 k mm H20
0 to 10 k mm H20
0 to 20 k mm H20
0 to 50 k mm H20
0 to 75 k mm H20
0 to 100 k mm H20
0 to 150 k mm H20
32M
0 to 70 k mm H20
Ordering Information
Record selected option in blank indicated at bottom of form.
W30
33M
34M
35M
Code
X
Pressure Range (PPP)
See Standard Pressure Ranges Tables
36M
0 to 200 k mm H20
Code
2
Knockout Quantity (KQ)
Two holes
37M
38M
Code
Knockout Size (KS)
R
S
1/2 in (12.7 mm) conduit
PG 11
W30 -
___
-
___
-
___
Typical model number.
www.amphenol-sensors.com
© 2014 Amphenol Corporation. All Rights Reserved. Specifications are subject to change without notice.
Other company names and product names used in this document are the registered trademarks or
trademarks of their respective owners.
Amphenol
Advanced Sensors
AAS-920-301B-03/2014
相关型号:
W30-38M-2-R
General Eastern Liquid Differential Pressure TransmittersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
AMPHENOL
W30-38M-2-S
General Eastern Liquid Differential Pressure TransmittersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
AMPHENOL
W30-38P-2-R
General Eastern Liquid Differential Pressure TransmittersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
AMPHENOL
W30-38P-2-S
General Eastern Liquid Differential Pressure TransmittersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
AMPHENOL
W30-48S1.5
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S1.8
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S12
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S15
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S2.5
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S3.3
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W30-48S5
DC/DC MODULESWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
INTRONICS
W3000
W3000 PLL Dual-Band Frequency SynthesizerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
AGERE
©2020 ICPDF网 联系我们和版权申明