PM671 [ARTESYN]
Single and dual output 0.5 to 1 Watt Nominal input DC/DC converters; 单和双输出0.5至1瓦标称输入DC / DC转换
| 型号： | PM671 |
| 厂家： | 
ARTESYN TECHNOLOGIES |
| 描述： | Single and dual output 0.5 to 1 Watt Nominal input DC/DC converters |
| 文件： | 总2页 (文件大小：65K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
PM600 SERIES
Single and dual output
• 24 pin DIP package
• 1.25 x 0.8 x 0.4 inch package
• Tight regulation
• Pi input filter
• 20mV pk-pk ripple and noise
• Short circuit protection
The PM6.. Series are a broad line of low cost% high perforꢀance single and
dual output D°/D° converters packaged in an I° coꢀpatible 2ꢃ pin DIP
configuration5 These ꢀiniature converters are ideal for use on high density P°
boards% or wherever low power% isolated and regulated outputs are required5 A
self contained input Pi network filter% available on all ꢀodels% ꢀiniꢀizes reflected
ripple current for critical applications5 This feature eliꢀinates the need for
eꢁternal filters thus reducing overall systeꢀ cost5 The PM6.. series ꢀaintain
±.5ꢂ0 line and ±.5ꢃ0 load regulation% and require no derating over the
specified operating teꢀperature range5 Other specifications include: output
voltage accuracy% ±±5.0ꢆ ripple and noise% 2.ꢀV pk-pkꢆ isolation% ꢂ..VD°5
PM6.. series D°/D° converters are intended for a wide variety of industrial
applications% especially where tight regulation is required5
[ 2 YEAR WARRANTY ]
SPECIFICATION All specifications are typical at nominal input, full load at 25ꢅC unless otherwise stated
OUTPUT SPECIFICATIONS
GENERAL SPECIFICATIONS
Efficiency
Voltage accuracy
±±5.0% ꢀaꢁ5
±.5ꢂ0
±.0 typical
ꢂ..VD°
Line regulation
Load regulation
Ripple and noise
LL to HL
Isolation voltage
NL to FL
±.5ꢃ0
Switching frequency
°ase ꢀaterial
Variable
ꢃ.kHz to 7.kHz
2.MHz BW
See Note ±
2.ꢀV pk-pk% ꢀaꢁ5
UL9ꢃV-.
Non-conductive
black plastic
Transient response
Overshoot for
ꢄ.0 to 9.0 FL
±.5ꢄ0% typical
Weight
ꢄꢃg (.5±oz)
MTBF
(7±0 FL)
Single Outputs
Dual Outputs
ꢃꢂꢃ%... hours
268%... hours
Teꢀperature coefficient
±.5.ꢄ0ꢅ°% typical
Short circuit protection Output therꢀal
liꢀited
°ontinuous
ENVIRONMENTAL SPECIFICATIONS
autoꢀatic recovery
Therꢀal perforꢀance
Operating aꢀbient
–2±ꢅ° to +7ꢄꢅ°
INPUT SPECIFICATIONS
Non-operating aꢀb5% –ꢃ.ꢅ° to +ꢄ2±ꢅ°
°ase
Derating
°ooling
+9±ꢅ°% ꢀaꢁ5
None required
Input voltage range
±VD°% See Note ꢄ.
ꢄ2VD°% See Note ꢄ. ꢄ.58 to ꢄꢂ52VD°
ꢃ5± to ±5±VD°
Free air convection cooled
Input filter
See Note 8
Pi network
Relative huꢀidity
Altitude
Non-condensing
2.0 to 9±0 RH
Fault current ꢀode
ꢄ±.0 of FL
input current
Operating
Non operating
ꢄ.%... feet ꢀaꢁ5
ꢃ.%... feet ꢀaꢁ5
Vibration
±Hz to ±..Hz
25±G rꢀs (approꢁ5)
PAGE 1
SPECIAL APPLICATION MODELS
| 0.5-1W DC/DC
0.5 to 1 Watt
Nominal input DC/DC converters
INPUT
OUTPUT
VOLTAGE
OUTPUT
INPUT
CURRENT (1)
TYPICAL
REGULATION
LINE (2)
MODEL
VOLTAGE
CURRENT
EFFICIENCY
LOAD (3)
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
±.5ꢃ0
NUMBER
±VD°
±VD°
±VD°
ꢄ2VD°
ꢄ±VD°
±ꢄ2VD°
±ꢄ±VD°
±VD°
ꢄ..ꢀA
8.ꢀA
26.ꢀA
ꢂ8.ꢀA
ꢂ8.ꢀA
ꢂ8.ꢀA
ꢂ8.ꢀA
ꢄ..ꢀA
ꢄꢃ±ꢀA
ꢄꢃ±ꢀA
±.0
±.0
±.0
±.0
±.0
±.0
±.0
±.0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
±.5ꢂ0
PM62ꢄ
PM62ꢂ
±VD°
6±ꢀA
PM62ꢃ
±VD°
±ꢃ.ꢀA
±ꢂꢂꢀA
ꢄ..ꢀA
±ꢃ.ꢀA
±ꢂꢂꢀA
PM67ꢄ (ꢃ%6)
PM672 (ꢃ%6)
PM6ꢂꢄ
±VD°
ꢄ2VD°
ꢄ2VD°
ꢄ2VD°
±ꢄ2VD°
±ꢄ±VD°
PM68ꢄ (6)
PM682 (6)
Notes
CASE F
ꢄ
2
ꢂ
ꢃ
Maꢁiꢀuꢀ figure% at full load5
Measured froꢀ high line to low line5
Measured as load changes froꢀ no load to ꢄ..0 full load5
.5.2 DIA5
(.5±)
The PM67ꢄ is available with optional voltage balance pin% and is
designated by suffiꢁ letter ‘P’5 For connection inforꢀation% see case
drawing5 In addition% both the PM67ꢄ and PM672 are available with
alternate pin-out (including balance pin) designated by suffiꢁ letter ‘R’5 See
case drawing5 If not required% the balance pin can be left floating5
Measured with a ꢄ±µF tantaluꢀ capacitor across each output5
On dual output ꢀodels the four coꢀꢀon pins are internally connected5
The outputs can be returned through one pin while the others reꢀain
floating5
.5.8 (25.)
2ꢃ
2ꢂ
22
ꢄ
2
ꢂ
±
6
ꢄ52±
(ꢂꢄ58)
7
Standard specifications are conservative and can be optiꢀized for specific
applications5 In particular% converter start-up at lower than specified
teꢀperature% wider input voltage range and output voltage adjustꢀent are
all relatively siꢀple ꢀodifications to the standard product5 °onsult factory
for details5
Fiꢁed frequency design provides for easier input filtering and better noise
perforꢀance5
.5ꢄ.
(25±ꢃ)
9
ꢄ.
ꢄꢄ
ꢄ2
(OPT5)
ꢄ±
ꢄꢃ
ꢄꢂ
8
9
Units are tested with resistive load only5
ꢄ. Output current derates to . at ꢄꢄ.0 noꢀinal Vin5
ꢄꢄ NOTI°E: Soꢀe ꢀodels do not support all options5 Please contact your
local Artesyn representative or use the on-line ꢀodel nuꢀber search tool
at http://www5artesyn5coꢀ/powergroup/products5htꢀ to find a suitable
alternative5
.5ꢄ±
(ꢂ58)
.56.
(ꢄ±52)
.5ꢃ.
(ꢄ.52)
.58.
(2.5ꢂ)
ALL DIMENSIONS IN IN°HES (ꢀꢀ)
PIN CONNECTIONS
SINGLE
OUTPUT
MODELS
DUAL
ALTERNATE PIN-OUT
SUFFIX R (4)
PIN
OUTPUT
NUMBER
MODELS (6)
°onnect R as required to
ꢄ
Balance Pin
°onnection:
2ꢃ
2ꢂ
22
ꢄ
2
ꢂ
ꢄ
2
ꢂ
+V Input
Do not connect
Do not connect
+V Input
–V Output
°oꢀꢀon
+V Input
+V Input
+V Input
balance outputs when
I + V I > I - V
I
out
out
Rꢄ
or
°onnect R as required to
2
9
No Pin
–V Output
+V Output
–V Input
Balance (opt)*
°oꢀꢀon
No Pin
°oꢀꢀon
ꢄ.
ꢄꢄ
ꢄ2
balance outputs when
+V Output
–V Input
°oꢀꢀon
(Opt5)
9
ꢄ.
ꢄꢄ
ꢄ2
I - V I > I + V
I
out
out
ꢄ±
ꢄꢃ
ꢄꢂ
Do not connect
R2
Input to balance pin: ±±ꢀA%
ꢀaꢁ5 R or R : ꢂK Ohꢀ% ꢀin5
ꢄꢂ
ꢄꢃ
ꢄ±
–V Input
+V Output
–V Output
–V Input
+V Output
°oꢀꢀon
–V Output
Balance
+V Output
ꢄ
2
22
2ꢂ
2ꢃ
Do not connect
Do not connect
+V Input
°oꢀꢀon
–V Output
+V Input
–V Input
–V Input
–V Input
* PM67ꢄP5
Datsheet © Artesyn Technologies
® 2..±
The inforꢀation and specifications contained in this datasheet are believed to be correct at tiꢀe of publication5 However% Artesyn Technologies accepts no responsibility for consequences arising
froꢀ printing errors or inaccuracies5 Specifications are subject to change without notice5 No rights under any patent accoꢀpany the sale of any such product(s) or inforꢀation contained herein5
http://www.artesyn.com
PAGE 2
相关型号：
©2020 ICPDF网 联系我们和版权申明