CWX825-14.31818MHZ [CONNOR-WINFIELD]

HCMOS Output Clock Oscillator, 14.31818MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN;
CWX825-14.31818MHZ
型号: CWX825-14.31818MHZ
厂家: CONNOR-WINFIELD CORPORATION    CONNOR-WINFIELD CORPORATION
描述:

HCMOS Output Clock Oscillator, 14.31818MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN

机械 振荡器
文件: 总2页 (文件大小:66K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
5.0V HCMOS Surface Mount  
Crystal Clock Oscillator  
CWX825  
Features:  
1 MHz to 156.25 MHz  
5.0V Operation  
XO  
2111 Comprehensive Drive  
RoHS Compliant  
Aurora, Illinois 60505  
The Connor-Winfield CWX825 is a RoHS compliant  
5.0V, HCMOS, 7.5x5mm, surface mount, oscillator (XO).  
This fixed frequency crystal oscillator is designed for  
use in applications requiring high stability and low jitter.  
The surface mount package is designed for high-  
density mounting and is optimum for mass production.  
Frequency Tolerance: ±50ppm  
Temperature Range: -20 to 70°C  
Low Jitter: <1 pS RMS  
Tri-State Enable / Disable  
Ceramic Surface Mount Package  
Tape and Reel Packaging  
Phone: 630-851-4722  
Fax: 630- 851- 5040  
www.conwin.com  
US Headquarters:  
630-851-4722  
European Headquarters:  
+353-61-472221  
Absolute Maximum Ratings  
Parameter  
Minimum  
-55  
Nominal  
Maximum  
125  
Units  
°C  
Vdc  
Notes  
Storage Temperature  
Supply Voltage (Vcc)  
-
-
-0.5  
7.0  
Operating Specifications  
Parameter  
Minimum  
Nominal  
Maximum  
Units  
MHz  
MHz  
ppm  
°C  
Notes  
Frequency Range (Fo)  
Additional Frequencies Available 106.25, 125.00, 155.52 and 156.25  
Frequency Tolerance  
Operating Temperature Range  
Supply Voltage (Vdd)  
1.00  
-
100.00  
-50  
-20  
4.5  
-
-
-
50  
70  
5.5  
45  
1
5.0  
-
Vdc  
mA  
Supply Current (Icc)  
Input Characteristics  
Parameter  
Minimum  
Nominal  
Maximum  
Units  
Vdc  
Vdc  
Notes  
Enable Voltage - (Vih)  
Disable Voltage - (Vil)  
2.2  
-
-
-
-
2
0.8  
HCMOS Output Characteristics  
Parameter  
Minimum  
Nominal  
Maximum  
Units  
Notes  
Load  
-
-
50  
pF  
High (Voh)  
Voltage  
4.5  
-
-
-
-
Vdc  
Low (Vol)  
0.4  
High (loh)  
Current  
-8  
-
-
-
-
mA  
Low (lol)  
8
Duty Cycle at 50% of Vcc  
Rise / Fall Time 10% to 80%  
Start-Up Time  
40  
-
-
50  
2
-
60  
6
10  
%
nS  
mS  
Jitter  
(BW=10Hz to 20MHz)  
(BW=12kHz to 20MHz)  
-
-
-
-
5
1
pS RMS  
Package Characteristics  
Package  
Hermetically sealed ceramic package  
Notes:  
1. Inclusive of calibration @ 25°C , frequency vs temperature stability, supply voltage change, load change, shock and vibration, 10 years aging.  
2. Oscillator output is enabled with no connection on pad 1  
Standard Frequencies Available (MHz)  
1.544  
6.48  
1.8432  
10  
2.048  
11.0592  
16.896  
27  
3.6864  
4
12.288  
20  
5
14.31818  
24  
12  
15.36  
24.576  
32.768  
48  
16  
19.44  
29.498928  
36  
25  
29.4912  
40  
30  
Bulletin  
Sm109  
33  
33.33  
50  
44.736  
75  
Page  
1 of 2  
49.152  
100  
60  
66  
Revision  
02  
80  
106.25  
125  
155.52  
156.25  
Date  
07 Oct 2005  
Specifications subject to change without notice. All dimensions in inches. © Copyright 1998 The Connor-Winfield Corporation  
2111 Comprehensive Drive  
Aurora, Illinois 60505  
Phone: 630-851-4722  
Fax: 630- 851- 5040  
www.conwin.com  
Environmental Characteristics  
Suggested Pad Layout  
Temperature Cycle  
Hermetical  
The specimen shall meet electrical characteristics after  
.200  
(5.08mm)  
tested 5 cycles of -55°C / 30 minutes and +125°C / 30 minutes  
No bubbles appear in Flourinert (FC-43) at 125°C 5°C for 5 minutes  
VDD  
OUTPUT  
3
4
Solvent Resistance  
Marking will withstand immersion in  
Isopropyl Alcohol or Trichloroethylene  
.165  
(4.2mm)  
C-by  
GROUND  
Soldering  
1
2
General Conditions  
260°C max x 10 sec max x 2 times max or  
E/D  
230°C max x 180 sec max x 1 time  
.078 TYP  
(2.0mm)  
.070 TYP  
(1.8mm)  
Typical Operation Data  
(Vapor phase reflow)  
20 to 100 sec up to 215°C, 50 sec at 215°C,  
then down to room temperature per 1 to 5°C / sec  
Bypass capacitor. C–by, should be  
ceramic capacitor .01uf.  
Mechanical Characteristics  
Free Drop  
Vibration  
The specimen shall meet electrical characteristics after tested 3 times,  
Dimensional Tolerance: ±.02" (.508mm)  
±.008"(0.2mm)  
Free Drop testing on the hard wooden board from a height of 75 cm.  
The specimen shall meet electrical characteristics after tested  
by the following conditions: 10-55Hz 1.5mm Amplitude,  
55-2000 Hz 20 G's, 2 hours for each plane  
After applied Thermal Shock of 260°C  
max x 10 sec max x 2 times, or 230°C max x 180 sec max,  
the specimen shall meet electrical characteristics  
Test Circuit  
Thermal Shock  
Solderability  
OSCILLOSCOPE  
A
PROBE  
(EIAJ-RCX-0102.101 Condition 1a)  
1) Flux: MIL-F-14256 (WW Rosin=25%, Isopropyl Alcohol = 75%)  
2) Solder: QQ-S-571 (Sn = 63%, Pb = 37%)  
POWER  
SUPPLY  
3
4
V
OSC  
.01uf  
3) Solder bath temperature: 235°C 5°C  
CL  
4) Depth of immersion: Up to electrical terminal  
5) Immersing time: Within 2 sec 0.5 sec into solder bath  
1
2
FREQ  
COUNTER  
After performing the above procedures, a newly soldered coverage shall be greater than 90%  
INPUT for E/D  
.189 .ꢀꢀ7  
ꢂ4.8 ꢀ.2mmꢃ  
.1ꢀ2  
ꢂ2.6ꢀmmꢃ  
Pad Connection  
1: Enable / Disable  
2: Ground  
Enable/Disable Function  
Pin 1 Open  
Output  
.ꢀ4 .ꢀꢀ4  
ꢂ1.ꢀ .115mmꢃ  
Pin 3 Active  
Pin 3 Active  
2
3
Pin 1 2.2V  
.2ꢀꢀ  
ꢂ5.ꢀ8mmꢃ  
.287 .ꢀꢀ7  
ꢂ7.3 ꢀ.2mmꢃ  
.ꢀ55  
ꢂ1.4ꢀmmꢃ  
3: Output  
Pin 1 0.8V  
Pin 3 High Impedence  
4: Vcc  
1
4
OutputWaveform  
Dimensional Tolerance: .ꢀ2ꢁ  
ꢂ ꢀ.5mmꢃ  
.ꢀꢀ8ꢁ ꢂ ꢀ.2mmꢃ  
T
T
F
R
"1" LEVEL  
+2.3Vdc  
90% Vcc  
Tape and Reel Dimensions  
+1.65Vdc  
50% Vcc  
10% Vcc  
+0.3Vdc  
0.0Vdc  
PIN 1  
"0" LEVEL  
.69  
(17.5mm)  
SYMMETRY  
.31  
(7.9mm)  
.08  
(2.0mm)  
.08  
8.46 DIA  
(216mm DIA)  
(2.0mm)  
.21  
(5.4mm)  
Ordering Information  
9.84 DIA  
(250mm DIA)  
.157  
(4.0mm)  
CWX825 - 44.736 MHz  
.08  
(2.0mm)  
CLOCK  
SERIES  
CENTER  
FREQUENCY  
3.15  
(80mm)  
3.15  
(80mm)  
.06 DIA  
(1.5mm DIA)  
1.00 DIA  
(25mm DIA)  
Bulletin  
Page  
Sm109  
2 of 2  
.295 (7.5mm)  
.07 (1.75mm)  
.83 (16.0mm)  
Revision  
Date  
02  
MEETS EIA-481A and EIAJ-1009B  
2,000 PCS/REEL  
07 Oct 2005  
Specifications subject to change without notice. All dimensions in inches. © Copyright 1998 The Connor-Winfield Corporation  

相关型号:

CWX825-15.36M

OSC XO 15.36MHZ HCMOS SMD
CONNOR-WINFIE

CWX825-15.36MHZ

HCMOS Output Clock Oscillator, 15.36MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN
CONNOR-WINFIE

CWX825-156.250M

HCMOS Output Clock Oscillator, 156.25MHz Nom, ROHS COMPLIANT, HERMETIC SEALED, CERAMIC, SMD, 4 PIN
CONNOR-WINFIE

CWX825-156.25M

Oscillator, 1MHz Min, 156.25MHz Max, 156.25MHz Nom
CONNOR-WINFIE

CWX825-16.0M

OSC XO 16.000MHZ HCMOS SMD
CONNOR-WINFIE

CWX825-16.384M

Surface Mount CMOS Clock Oscillator Series
CONNOR-WINFIE

CWX825-16.896MHZ

HCMOS Output Clock Oscillator, 16.896MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN
CONNOR-WINFIE

CWX825-18.432M

OSC XO 18.432MHZ HCMOS SMD
CONNOR-WINFIE

CWX825-19.44M

OSC XO 19.44MHZ HCMOS SMD
CONNOR-WINFIE

CWX825-19.44MHZ

HCMOS Output Clock Oscillator, 19.44MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN
CONNOR-WINFIE

CWX825-2.048MHZ

HCMOS Output Clock Oscillator, 2.048MHz Nom, ROHS COMPLIANT, CERAMIC, 4 PIN
CONNOR-WINFIE

CWX825-20.0M

OSC XO 20.000MHZ HCMOS SMD
CONNOR-WINFIE