FTS-FR125 [CONNOR-WINFIELD]
Eval Board Quick Start Guide;
| 型号： | FTS-FR125 |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | Eval Board Quick Start Guide |
| 文件： | 总2页 (文件大小：3024K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
FTS/FR125
Available at Digi-Key
www.digikey.com
Eval Board Quick Start Guide
2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: 630-851-4722
Fax: 630-851-5040
www.conwin.com
Q
U
I
C
K
S
T
A
R
T
General Instructions
1)ꢀ InsertꢀtheꢀunitꢀintoꢀtheꢀevalꢀboardꢀLIFꢀsockets
•ꢀ Pinꢀ1ꢀofꢀtheꢀunitꢀwillꢀbeꢀplacedꢀinꢀtheꢀtopmostꢀpositionꢀofꢀLIFꢀreceptacleꢀJ12.ꢀ
•ꢀ Pinꢀ1ꢀisꢀindicatedꢀonꢀtheꢀevaluationꢀboardꢀwithꢀaꢀlargeꢀsilkscreenꢀ“1”.
•ꢀ Pressꢀtheꢀunitꢀdownꢀfirmly-ꢀthereꢀshouldꢀbeꢀnoꢀmetalꢀpinsꢀexposed.
2)ꢀ DIPꢀSwitchꢀManualꢀControlꢀUsingꢀSW1
•ꢀ VerifyꢀthatꢀallꢀtheꢀDIPꢀswitchesꢀareꢀturnedꢀ“On”ꢀ(rightmostꢀposition).
•ꢀ “Off”ꢀpositionꢀappliesꢀaꢀlogicꢀlowꢀtoꢀtheꢀunit,ꢀ“On”ꢀpositionꢀappliesꢀaꢀlogicꢀhigh.
G
U
I
D
E
SwitchꢀLabelꢀ
Function
Sync1ꢀ
Sync2ꢀ
Disableꢀ
ꢀ
ꢀ
ꢀ
ControlsꢀDUTꢀpinꢀ19ꢀ“SYNC1ꢀcontrol”
ControlsꢀDUTꢀpinꢀ20ꢀ“SYNC2ꢀcontrol”
ControlsꢀDUTꢀpinꢀ21ꢀ(/Disable)
BootꢀSelectꢀ ꢀ
Resetꢀ
ControlsꢀDUTꢀpinꢀ8ꢀ(/Bootsel)ꢀ-ꢀOnlyꢀusedꢀforꢀWi125ꢀsoftwareꢀupdates/revisions
ControlsꢀDUTꢀpinꢀ10ꢀ(/Reset)
ꢀ
3)ꢀ ConnectꢀtheꢀBNCsꢀ(centerꢀpositive)
•ꢀ DoꢀnotꢀapplyꢀvoltagesꢀhigherꢀthanꢀindicatedꢀorꢀtheꢀDUTꢀand/orꢀtestꢀboardꢀcouldꢀbeꢀdamaged.
•ꢀ Connectꢀ3.3VꢀtoꢀJ1ꢀtoꢀpowerꢀtheꢀtestꢀboard.
•ꢀ Connectꢀ3.3VꢀtoꢀbothꢀJ2ꢀandꢀJ3ꢀtoꢀpowerꢀtheꢀFTS125.ꢀꢀUseꢀseparateꢀsuppliesꢀforꢀJ2ꢀ“DUTꢀ
Bulletin
ꢀ
Vcc1”ꢀandꢀJ3ꢀ“DUTꢀVcc2”ꢀotherwiseꢀphaseꢀnoiseꢀperformanceꢀwillꢀbeꢀdegraded.
SG169
1 of 2
P02
30 Sept 2011
Page
•ꢀ Connectꢀ3-12VꢀtoꢀJ4ꢀtoꢀpowerꢀanꢀactiveꢀantennaꢀthroughꢀtheꢀFTS125'sꢀMCXꢀantennaꢀ
Revision
ꢀ
ꢀ
connector.ꢀIfꢀaꢀdifferentꢀantennaꢀisꢀusedꢀotherꢀthanꢀthatꢀsuppliedꢀwithꢀtheꢀFTS125ꢀEvalꢀ
Board,ꢀconsultꢀthatꢀantenna'sꢀdocumentationꢀforꢀtheꢀrequiredꢀvoltage.
Date
2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: 630-851-4722
Fax: 630-851-5040
General Instructions continued
Designator/Labelꢀ
Inputꢀ/ꢀ
Outputꢀ
Voltageꢀ/ꢀ
LogicꢀType
Functionꢀ
ꢀ
ꢀ
ꢀ J1:ꢀ“3.3V”ꢀ
Inputꢀ
Inputꢀ
Inputꢀ
Inputꢀ
Inputꢀ
Inputꢀ
Outputꢀ
3.3Vꢀ+/-ꢀ5%ꢀ
LVCMOS/LVTTLꢀ
LVCMOS/LVTTLꢀ
Betweenꢀ3-12Vꢀ
3.3Vꢀ+/-ꢀ5%ꢀ
Evalꢀboardꢀpower
www.conwin.com
ꢀ J6:ꢀ“10MHzꢀExt”ꢀ
ꢀ J5:ꢀ“1PPSꢀExt”ꢀ
ꢀ J4:ꢀ“3-12VꢀANT”ꢀ
ꢀ J2:ꢀ“DUTꢀVCC1”ꢀ
ꢀ J3:ꢀ“DUTꢀVCC2”ꢀ
Externalꢀ10MHzꢀreferenceꢀsignalꢀtoꢀDUTꢀPinꢀ9
Externalꢀ1PPSꢀreferenceꢀsignalꢀtoꢀDUTꢀPinꢀ12
AntennaꢀsupplyꢀvoltageꢀforꢀDUTꢀPinꢀ14
SupplyꢀvoltageꢀforꢀDUTꢀPinꢀ16
SupplyꢀvoltageꢀforꢀDUTꢀPinꢀ17
1PPSꢀsignalꢀfromꢀDUTꢀPinꢀ26ꢀ
US Headquarters:
630-851-4722
European Headquarters:
+353-61-472221
3.3Vꢀ+/-ꢀ5%ꢀ
LVCMOSꢀ
ꢀ J16:ꢀ“1PPSꢀOut”ꢀ
ꢀ orꢀProbeꢀJackꢀJ19
ꢀ J15:ꢀ“10MHzꢀCMOSꢀOut”ꢀ Outputꢀ
ꢀ orꢀProbeꢀJackꢀJ18
ꢀ J14:ꢀ“10MHzꢀSINEꢀOut”ꢀ Outputꢀ
ꢀ orꢀProbeꢀJackꢀJ17
LVCMOSꢀ
SINEꢀ
10MHzꢀCMOSꢀsignalꢀfromꢀDUTꢀPinꢀ28ꢀ
10MHzꢀSINEꢀsignalꢀfromꢀDUTꢀPinꢀ32ꢀ
4)ꢀ ConnectꢀtheꢀfemaleꢀDB9ꢀconnectorꢀ“P3”ꢀtoꢀaꢀcomputerꢀserialꢀportꢀ(optional).
•ꢀ UsedꢀtoꢀmonitorꢀNMEAꢀ0183ꢀdataꢀstream.
•ꢀ NS3KViewꢀsoftwareꢀisꢀrecommendedꢀforꢀuseꢀandꢀcanꢀbeꢀprovidedꢀperꢀrequest.
•ꢀ BaudꢀRate:ꢀ38400.
•ꢀ ReferꢀtoꢀtheꢀWi125ꢀGPSꢀReceiverꢀUserꢀManualꢀforꢀmoreꢀinformationꢀonꢀNMEAꢀandꢀtheꢀꢀ
ꢀ
proprietaryꢀmessagesꢀandꢀcommands.
5)ꢀ ConnectꢀaꢀfullꢀskyꢀviewꢀGPSꢀantennaꢀtoꢀtheꢀDUT’sꢀfemaleꢀMCXꢀconnector.
6)ꢀ Powerꢀtheꢀunitꢀon.
7)ꢀ LEDꢀFunction
•ꢀ Antenna Fault Statusꢀ(D7)ꢀRedꢀLEDꢀturnsꢀonꢀifꢀaꢀfaultꢀconditionꢀisꢀindicatedꢀonꢀDUTꢀPinꢀ25.ꢀ
ꢀ
ꢀ
AnꢀantennaꢀfaultꢀconditionꢀisꢀdefinedꢀasꢀanꢀovercurrentꢀonꢀDUTꢀPinꢀ14ꢀ(AntennaꢀSupplyꢀVoltage).ꢀꢀ
Thisꢀfaultꢀstatusꢀisꢀself-clearingꢀonceꢀtheꢀfaultꢀconditionꢀgoesꢀaway.ꢀ
•ꢀ Holdover Statusꢀ(D6)ꢀAmberꢀLEDꢀturnsꢀonꢀifꢀtheꢀunitꢀisꢀinꢀautomaticꢀorꢀforcedꢀholdoverꢀasꢀ
indicatedꢀbyꢀDUTꢀPinꢀ23ꢀ“HoldoverꢀStatus”.ꢀ
•ꢀ Lock Statusꢀ(D5)ꢀGreenꢀLEDꢀturnsꢀonꢀifꢀtheꢀunitꢀisꢀtightlyꢀlockedꢀtoꢀtheꢀselectedꢀinputꢀasꢀindicatedꢀ
byꢀDUTꢀPinꢀ24ꢀ“LockꢀStatus”.
ꢀ
ꢀ
Available at Digi-Key
www.digikey.com
Specificationsꢀsubjectꢀtoꢀchangeꢀwithoutꢀnotice.ꢀꢀAllꢀdimensionsꢀinꢀinches.ꢀꢀ©ꢀCopyrightꢀ2011ꢀTheꢀConnor-WinfieldꢀCorporation
相关型号：
©2020 ICPDF网 联系我们和版权申明