FDBP3G1 [ETC]
Distinctive features and specifications;型号: | FDBP3G1 |
厂家: | ETC |
描述: | Distinctive features and specifications |
文件: | 总4页 (文件大小:828K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
FD series
Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching
Distinctive features and specifications
FD1506-A
K
K
K
K
K
Double icon actuator
Snap-in and threaded bushing models
Suited for integrated designs
Large but lightweight
Sealed to IP69K (threaded bushing version)
ELECTRICAL SPECIFICATIONS
MATERIALS
• Max. current/voltage rating with resistive load :
- silver contacts (code 2) : 4A 12VDC
- gold plated contacts (code 4) : 200mA 12VDC
• Initial contact resistance : 50 mΩ max.
• Insulation resistance : 1 GΩ min. at 500VDC
• Dielectric strength : 1.000 Vrms 50 Hz min.
• Electrical life at full load :
- Momentary models : 1 million cycles (gold plated contacts)
400.000 cycles (silver contacts)
- Latching models : 200.000 cycles
• Case : PA46
• Actuator : PA12
• Bushing/ bezel : PA66
• Contacts : silver (code 2)
or silver, gold plated (code 4)
WIRING DIAGRAM
Flat
+
©
POLE 2
LED
GENERAL SPECIFICATIONS
• Front panel sealing :
- Threaded bushing version : IP69K according to DIN 40050-9
- Snap-in version : IP54 according to IEC 60529 with panel gasket and
2 mm panel thickness
• Panel thickness :
-
LED
- Snap-in version : 1,5 (.059) to 2 mm (.078) with panel gasket
2 (.078) to 2,5 mm (.885) without panel gasket
- Threaded bushing version :1(.039) to 18 mm (.708) max.
• Total travel : 2,5 mm 0,5 mm
POLE 1
• Typical operating force : 8N 2N
• Low level or mechanical life :
- Momentary models : 1 million cycles
- Latching models : 200.000 cycles
• Torque : 3 Nm max. applied to nut
• Operating temperature : -40°C to +75°C
The company reserves the right to change specifications without notice.
APEM
www.apem.com
1
FD series
Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching
Overview
FD
SERIES
Actuator
Electrical function
Terminals
P
Round, flat
1
3
OFF - ON
Normally open (NO)
1
Solder lugs
Models
A
B
Threaded bushing,
dia. 24 mm
Snap-in, dia. 26 mm
LED control and No of poles
C
D
F
Independent LED, 1 pole
Independent LED, 2 poles
LED linked to actuator, green if switch
in ON position, single pole
G
LED linked to actuator, red if switch
in ON position, single pole
F and G for OFF - ON models only.
Contact material
Actuator color
Bezel color
LED colors
Red/green
LED resistor
Symbols
2
Silver
8
Smoke black
2
Black
F
0
No resistor
supplied
12V resistor
24V resistor
See end of series
4
Silver, gold
plated
1
2
ABOUT THIS SERIES
On the following pages, you will find successively :
model structure of switches and options in the same order as in above chart
Dimensions : first dimensions are in mm while inches are shown as bracketed numbers.
NOTICE : please note that not all combinations of above numbers are available.
Refer to the following pages for further information.
Mounting accessories : Standard hardware supplied : 1 hex nut (threaded bushing version) and 1 panel gasket
Packaging unit : 20 pieces
2
www.apem.com
APEM
FD series
Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching
• Solder lugs
• Flat actuator
To order a product, replace • with one of the codes selected under “LED control
and number of poles” below, then add the desired options.
MODEL
STRUCTURE
Flat
©
Mounting by threaded bushing - Ø 24 mm
LATCHING
FDAP1•1
OFF
ON
MOMENTARY (NO)
FDAP3•1
Flat
©
Snap-in mounting - Ø 26 mm
LATCHING
FDBP1•1
OFF
ON
MOMENTARY (NO)
FDBP3•1
LED CONTROL AND NUMBER OF POLES
Complete the model numbers above with one of the following codes.
Function 1 (latching) Function 3 (momentary)
Function 1 (latching)
Green LED
in ON position
single pole
Independent LED
single pole
dotted line = jumper to
be wired by the user.
LED- has to be wired to
one pin of pole 2.
C
F
Red LED
in ON position
single pole
Independent LED
double pole
D
G
APEM
www.apem.com
3
FD series
Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching
Options
CONTACT MATERIALS
2
4
Silver
Silver, gold plated
ACTUATOR COLOR
8
Smoke black
BEZEL COLOR
2
Black
LED COLOR
F
Red/green
LED RESISTOR
0
1
2
No resistor supplied
12V resistor
24V resistor
SYMBOLS
START (green) / STOP (red)
with ring
3
4
5
Flat
©
©
ON (green) / OFF ( red)
with ring
I (green) / O ( red)
with ring
4
www.apem.com
APEM
相关型号:
FDC-37P(05)
D Subminiature Connector, 37 Contact(s), Male, IDC Terminal, Locking, Plug, ROHS COMPLIANT
HRS
©2020 ICPDF网 联系我们和版权申明