PVM2YXX [ETC]
6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator; 6垫无铅表面贴装或4引线通孔PECL压控晶振型号: | PVM2YXX |
厂家: | ETC |
描述: | 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator |
文件: | 总2页 (文件大小:49K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Pl tronics, Inc.
.
19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
PVB, PVM PECL VCXO Series
Differential PECL Output with Enable/Disable
–
1.00 MHz 650.00 MHz
6 Pad Leadless Surface Mount or
Consult factory for higher frequencies
4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator
Standard Specifications
Overall Frequency Stability
± 50 PPM, ± 25 PPM, ± 20 PPM over Operating Temperature Range
Operating Temperature Range 0 to +70°C is standard, but can be extended to - 40 to +85°C
Storage Temperature Range
Supply Voltage (Vcc)
Supply Current (Icc)
- 55 to +125°C
3.3 volts ± 5% standard, but 5.0 volts or 2.5 volts also available. See Test Cirucit 5.
< 250 MHz = 90 mA maximum, 250 MHz and above = 100 mA maximum
Output High Level
2.275 V minimum referenced to Ground, Vcc = 3.300V,
0.975 V minimum referenced to termination voltage,
- 1.025 V minimum referenced to Vcc
Output Low Level
1.680 V maximum referenced to Ground, Vcc = 3.300V,
0.380 V maximum referenced to termination voltage,
- 1.620 V maximum referenced to Vcc
Output Symmetry
Output Rise & Fall (Tr & Tf)
Jitter
E/D Internal Pullup
V disable
45/55% referenced to 50% of amplitude
1.0 nS maximum when Vth is 10% and 90% of waveform
6 pS RMS maximum measured from 12 kHz to 20 MHz from output frequency
50 kohm minimum to Vcc
0.3 Vcc maximum referenced to Ground
V enable
0.7 Vcc minumum referenced to Ground
Linerarity
± 10% typical
Slope
Positive and montonic
Control Voltage Range (CVR)
Pullability
For 5.0 Vcc, CVR = 0.5 to 4.5 V, For 3.3 Vcc, CVR = 0.0 to 3.3 V, For 2.5 Vcc, CVR = 0.0 to 2.5 V
Pull range is defined as absolute pull range. This is the pull range about the specified oscillator frequency,
independent of supply, temperature range and load. Typical values are ± 25, ± 50 and ± 100 PPM.
PVB Output Enable/Disable (E/D)
Output Enable Time
100 nS maximum
Output Disable Time
When Disabled
100 nS maximum
Q Output = Logic Low, QN Output = Logic High. Both Outputs are active
Part Numbering Guide
Portions of the part number that appear after the frequency may not be marked on part (C of C provided)
PVB 5 V B V - 100.0M - XXX (Internal Code or blank)
Packaging
Model
PVM = Tube
PVB = Tube or
24mm tape
16mm pitch
Frequency in MHz
PVB = B Pkg
PVM = Metal
Frequency Deviation (Pullability) Absolute Pull Range
V: ± 50 PPM
W = ± 100 PPM
Frequency Stability
5 = ± 50 PPM
4 = ± 25 PPM
2 = ± 20 PPM
Operating Temperature Range
B: 0 to +70°C
F: - 40 to +85°C
Supply Voltage
Y = 5.0 volts ±10%
V = 3.3 volts ±5%
W = 2.5 volts ±5%
Mar 2004
Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.
Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load
(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com
20
Pl tronics, Inc.
Pl tronics, Inc.
.
19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
PVB, PVM PECL VCXO Series
inches (mm)
Mechanical:
not to scale
Solder Pads
Due to part size and factory abilities, part marking may vary from lot to lot and may contain our part number or an internal code.
PVB Series
0.200 (5.08)
5
2
4
3
6
1
4
3
5
6
1
2
0.560 (14.23) MAX
0.200 (5.08)
0.195 (4.95)
MAX
0.055 0 .145
(1.4) (3.68)
PIN SIGNAL
1
2
3
4
5
6
Vcon
E/D
GND
Q OUT
QN OUT
Vcc
PVM Series
.200 (5.08) MAX
.031 (0.8)
.600 (15.24)
.807 (20.5) MAX
8
7
14
.020
(.51)
1
PIN SIGNAL
.250 (6.35) MAX
1
7
Vcon
GND
OUT
Vcc
8
14
Mar 2004
See page 6 for Layout Guidelines
20A
(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com
Pl tronics, Inc.
相关型号:
©2020 ICPDF网 联系我们和版权申明