TRV-150S024ST [ETC]

Switch Mode LED Drivers;
TRV-150S024ST
型号: TRV-150S024ST
厂家: ETC    ETC
描述:

Switch Mode LED Drivers

文件: 总2页 (文件大小:617K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
150W TRV-150 Series  
Switch Mode LED Drivers  
Constant Voltage  
Aluminum Housing  
Electrical Specifications  
Input Voltage Range:  
100 - 277 Nom. Vac (90 - 305 V Min/Max)  
Frequency:  
50/60 Hz Nom. (47-63 Hz Min/Max)  
0.90 @ 75-100% load, 100-277V  
<_ 20% @ 75-100% load, 100-277V  
Power Factor:  
THD:  
Inrush Current:  
Input Current:  
Maximum Power:  
Line Regulation:  
Load Regulation:  
Leakage Current:  
Typical Efficiency  
Turn-on Delay:  
Ripple and Noise:  
Protection:  
65 Amps maximum @ 230 Vac, cold start 25ºC  
1.75 A max 100Vac, 0.8 A max 220Vac  
150W  
± 1%  
± 2%  
1 mA 277 Vac 60Hz  
92.5%-93.5% at 220Vac  
0.9S typical 110Vac, 0.5S typical 220Vac  
2% Vo  
Total Power: 150 Watts  
• Input Voltage: 100-277 Vac Nom.  
• UL Dry & Damp Location Rated  
• IP67  
Over-Voltage (latch mode), Over-Temperature (110°C),  
Over-Current (hiccup mode), Lightning, and  
Short Circuit Protection with Self Recovery  
• Ultra-high Efficiency  
• High Power Factor  
• UL8750  
Environmental Specifications  
Minimum Starting Temp: -35ºC  
Maximum Case Temp.  
Storage Temperature:  
Humidity:  
90°C  
-40ºC to +85ºC  
5% to 100%  
Convection  
Class A  
Cooling:  
Sound Rating:  
MTBF:  
260,000 Hours @ 110Vac input, 80% load and 25ºC  
ambient conditions per MIL-HDBK-217F  
Lifetime:  
Weight:  
77,200 Hours @ 220Vac, 80% load and Tc=60ºC  
2.2 lbs. (1.0 kg)  
Output Voltage Output Current Max. Output  
Typical  
Efficiency  
Model Number  
New Surge Protection and HI-POT Testing  
(Vdc ±5%)  
Range (mA)  
Power (W)  
TRV-150S012ST  
TRV-150S020ST  
TRV-150S024ST  
TRV-150S036ST  
TRV-150S048ST  
TRV-150S054ST  
12  
20  
24  
36  
48  
54  
0-12.5  
150  
92%  
92%  
93%  
93%  
93%  
93%  
0-7.50  
150  
0-6.25  
150  
0-4.17  
150  
Metal Lock Sheet  
0-3.13  
150  
Nut  
0-2.78  
150  
Safety and EMC Compliance  
UL8750, Compliance to UL1012, UL935,  
CAN/CSA-C22.2 No. 0, CSA-C22.2 No. 107.1-01, CSA-C22.2 No. 250.0  
HI-POT Test  
Normal Application  
UL/CUL  
The new design of this LED driver provides 1.4KV surge protection. To properly  
HI-POT test this unit, the surge protection must be disconnected. The screw, nut, and  
metal lock sheet on the input side of the driver provide for this. To test, first remove  
the nut and lock sheet as shown. After testing, secure the nut and lock sheet to  
provide line-to-earth protection.  
C E  
EN 61347-1, EN61347-2-13  
EN 55015  
Conducted emission Test & Radiated emission Test  
EN 61000-3-2 Harmonic current emissions  
This HI-POT test feature is available on product manufactured after August 15, 2015.  
EN 61000-3-3 Voltage fluctuations & flicker  
EN 61000-4-2 Electrostatic Discharge (ESD): 8 kV air discharge, 4 kV contact discharge  
EN 61000-4-3 Radio-Frequency Electromagnetic Field Susceptibility Test-RS  
EN 61000-4-4 Electrical Fast Transient / Burst-EFT  
EN 61000-4-5 Surge Immunity Test: AC Power Line: line to line 4 kV, line to earth 6 kV  
EN 61000-4-6 Conducted Radio Frequency Disturbances Test-CS  
EN 61000-4-8 Power Frequency Magnetic Field Test  
E332160  
EN 61000-4-11 Voltage Dips  
Note:  
EN 61547  
Electromagnetic Immunity Requirements Applies to Lighting Equipment  
LED drivers are designed and intended to operate LED loads only.  
Non-LED loading may be outside the specified design limits of our  
LED drivers, and therefore cannot be covered by any warranty.  
If you desire to use our LED drivers to operate non-LED loads  
please contact us to discuss compatibility.  
Specifications subject to change without notice.  
Rev 8-28-15  
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com  
TRV-150 Series  
SSL Solutions Faster Than The Speed Of Light®  
Pg 2 of 2  
226  
199  
195  
INPUT  
Black (L)  
White (N)  
Green (GND)  
OUTPUT  
Red (+)  
Black (-)  
Tc = 90°C max  
20.6  
Ø 7.8±0.2  
Ø 7.3±0.2  
220±20  
50±3  
50±3  
650±20  
25  
39.5  
125  
8
WIRE SPECS:  
AC Input: UL SJTW #18AWG  
DC Output: UL SJTW #18AWG  
209  
213  
TRV-150S012ST:  
Note, Two DC output cables are connected in parallel internally, because one AWG #18 wire can only carry 10A.  
In application, connect the two red wires together and two black wires together, or ensure that each cable carries same current.  
226  
199  
195  
OUTPUT  
Red (+)  
Black (-)  
INPUT  
Black (L)  
White (N)  
Green (GND)  
Tc = 90°C max  
20.6  
Ø 7.8±0.2  
50±3  
Ø 7.3±0.2  
220±20  
50±3  
650±20  
25  
39.5  
125  
8
209  
213  
Lifetime / Case Temperature  
Derating Curve  
Derating Curve  
135  
100  
100  
120  
105  
90  
75  
60  
45  
30  
15  
0
80  
60  
40  
20  
0
80  
60  
40  
20  
0
-35  
-20  
-5  
10  
25  
40  
55  
70  
90  
120  
150  
180  
210  
240  
270  
300  
330  
30  
40  
50  
60  
70  
80  
90  
Ambient Temperature (°C)  
Input Voltage (V)  
Case Temperature (°C)  
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com  

相关型号:

TRV-150S036ST

Switch Mode LED Drivers
ETC

TRV-150S048ST

Switch Mode LED Drivers
ETC

TRV-150S054ST

Switch Mode LED Drivers
ETC

TRV-160

Electrically insulating PVC heat shrinkable tubing
TE

TRV-1900

Electrically insulating PVC heat shrinkable tubing
TE

TRV-200S012ST

Switch Mode LED Drivers
ETC

TRV-200S024ST

Switch Mode LED Drivers
ETC

TRV-200S036ST

Switch Mode LED Drivers
ETC

TRV-200S048ST

Switch Mode LED Drivers
ETC

TRV-200S054ST

Switch Mode LED Drivers
ETC

TRV-240

Electrically insulating PVC heat shrinkable tubing
TE

TRV-250S024ST

Switch Mode LED Drivers
ETC