MZ-6WHG-K-U-0H [FUJITSU]
Power/Signal Relay;型号: | MZ-6WHG-K-U-0H |
厂家: | FUJITSU |
描述: | Power/Signal Relay 继电器 |
文件: | 总8页 (文件大小:500K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Non-promotional not for new designs
MINIATURE RELAY
1 POLE - 1 to 2 A (For Signal Switching)
MZ Series
n FEATURES
l Subminiature size
l Standard and high sensitivity types available
l UL, CSA recognized
l FCC rules and regulations part 68
- Dielectric strength 1,500 V between coil and contacts
l High reliability-bifurcated contacts available
l DIL pitch terminals
l Plastic sealed type
l RoHS compliant.
Please see page 7 for more information
n PARTNUMBER INFORMATION
MZ
(a) (b)
F
- 12
W
HG - K - U
(f) (g)
[Example]
(c) (d) (e)
(a)
(b)
Relay type
MZ
: MZ-Series
Dielectric function
Coil rated voltage
Contact configuration
Nil
F
: Standard type
: High dielectric strength type
(c)
12
: 1.5.....48 VDC
Coil rating table at page 3
(d)
Nil
D
W
: 1A single
: 2A single (without MZF)
: 1A bifurcated
(e)
(f)
Coil type
HG
HS
: Standard type (without MZ-D) (450-500mW)
: High sensitivity type (without MZF / MZ-D) (190-270mW)
Enclosure
Nil
K
: Flux free type
: Plastic sealed type
(g)
UL, CSA standard
Nil
U
: Non UL, CSA approved
: UL, CSA approved
Note: For movable and stationary contact with gold overlay type, add suffix “–OH”.
1
MZ SERIES
n SPECIFICATION
Item
Standard type
Single
High sensitivity type
Bifurcated
Single
Bifurcated
MZ - ( ) D
MZ- ( ) HG MZ-( ) WHG MZ - ( ) HS
MZ-( ) WHS
Contact Data Configuration
1 form C (SPDT)
Gold-overlay
silver nickel
Material
Gold overlay silver-palladium
Resistance (initial)
Max. 100 mΩ at 6 VDC, 1A
2A, 24VDC
1A, 120VAC
1A, 24VDC
0.5A, 120VAC
Contact rating (resistive)
Max. carrying current
Max. switching voltage
Max. switching power
Max. switching current
2A
120VAC, 60VDC
120VA / 48W 60VA / 24W
2A
1A
0.1mA,
100 mVDC
0.1mA,
100 mVDC
Min. switching load*
1mA, 1 VDC
1mA, 1VDC
Approximately 0.8 pF (between open contacts, adjacent contacts)
Approximately 7.5 pF (between coil and contacts)
Min. 20 x 106 operations
Capacitance (at 10 MHz)
Mechanical
Life
1A, 120VAC:
min. 100 x
103 ops.
0.5A, 120VAC: min. 200 x 103 operations
1A, 24VAC: min. 500 x 103 operations
Electrical
2A, 24VDC:
min. 200 x
103 ops. min.
Coil Data
Rated power (at 20 °C)
450 - 500 mW
220 - 250 mW
190 - 270 mW
100 - 130 mW
Operate power (at 20 °C)
Operating temperature range
-30 °C to +55 °C (no frost)
Max. 6 ms
-30 °C to +75 °C
Timing Data Operate (at nominal voltage)
Release (at nominal voltage)
Max. 3 ms
Insulation
Isolation (initial)
Dielectric strength
Min. 100MΩ at 500VDC
Standard: 500VAC, 1min.
High Isolation: 1,000VAC, 1min.
Open contacts
Standard: 500VAC, 1min.
High Isolation: 1,500VAC, 1min.
Contacts to coil
Surge strength
Coil to contacts
Misoperation
Endurance
1,500V / 1 x 40µs standard wave
10 to 55Hz double amplitude 3.28 mm
10 to 55Hz double amplitude 3.28 mm
Min. 100m/s² (11 ± 1ms)
Other
Vibration resistance
Misoperation
Endurance
Shock
Min. 1,000m/s² (6 ± 1ms)
Weight
Approximately 3.5 g
* Minimum switching loads mentioned above are reference values. Please perform the confirmation test with actual
load before production since reference values may vary according to switching frequencies, environmental conditions
and expected reliability levels.
2
MZ SERIES
n COIL RATING
Standard type
Rated Coil
Voltage
(VDC)
Must Operate
Voltage
Must Release
Voltage
Coil
Code
Coil Resistance
+/- 10% (Ohm)
Rated Power
(mW)
(VDC) *
(VDC) *
1.5
3
1.5
3
5
20
1.05
2.1
0.08
0.15
0.23
0.25
0.3
4.5
5
4.5
5
45
3.15
3.5
56
450
500
6
6
80
4.2
9
9
180
320
720
1,280
4,600
6.3
0.45
0.6
12
18
24
48
12
18
24
48
8.4
12.6
16.8
33.6
0.9
1.2
2.4
High sensitive type
Rated Coil
Voltage
(VDC)
Must Operate
Voltage
Must Release
Voltage
Coil
Code
Coil Resistance
+/- 10% (Ohm)
Rated Power
(mW)
(VDC) *
(VDC) *
1.5
3
1.5
3
12
45
1.05
2.1
0.08
0.15
0.23
0.25
0.3
190
4.5
5
4.5
5
100
3.15
3.5
120
6
6
180
4.2
200
9
9
400
6.3
0.45
0.6
12
15
18
24
48
12
15
18
24
48
700
8.4
1,100
1,600
2,800
8,500
10.5
12.6
16.8
33.6
0.75
0.9
1.2
2.4
270
Note: All values in the table are valid for 20°C and zero contact current.
* Specified operate values are valid for pulse wave voltage.
n SAFETY STANDARDS
Type
UL
Compliance
Contact rating
UL 508, UL 60950-1
Flammability: UL 94-V0 (plastics)
[1A]
E 45026
0.5A, 120VAC (resistive)
1A, 24VDC (resistive)
[2A]
CSA
C22.2 No. 14
LR 35579
1A, 120VAC (resistive)
2A, 30VDC (resistive)
3
MZ SERIES
n CHARACTERISTIC DATA
n REFERENCE DATA
4
MZ SERIES
5
MZ SERIES
n DIMENSIONS
l
Schematics
(BOTTOM VIEW)
l
PC board mounting
hole layout
l
Dimensions
(BOTTOM VIEW)
MZ (F) type (Flux free type)
MZ (F)-K type (Plastic sealed type)
Unit: mm
6
MZ SERIES
RoHS Compliance and Lead Free Information
1. General Information
l
l
l
l
All relays produced by Fujitsu Components are compliant with RoHS directive 2011/65/EU including
amendments.
Cadmium as used in electrical contacts is exempted from the RoHS directives.
As per Annex III of directive 2011/65/EU.
All relays are lead-free. Please refer to Lead-Free Status Info for older date codes at:
http://www.fujitsu.com/downloads/MICRO/fcai/relays/lead-free-letter.pdf
Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified.
This material has been verified to be compatible with PbSn assembly process.
2. Recommended Lead Free Solder Condition
l
Recommended solder Sn-3.0Ag-0.5Cu.
Flow Solder Condition:
Pre-heating:
maximum 120˚C
within 90 sec.
Soldering:
dip within 5 sec. at
255˚C ± 5˚C solder bath
Relay must be cooled by air immediately
after soldering
Solder by Soldering Iron:
Soldering Iron 30-60W
Temperature:
Duration:
maximum 350-360˚C
maximum 3 sec.
We highly recommend that you confirm your actual solder conditions
3. Moisture Sensitivity
l
Moisture Sensitivity Level standard is not applicable to electromechanical relays, unless otherwise indicated.
4. Tin Whiskers
l
Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length
whisker was found by our in house test.
7
MZ SERIES
Fujitsu Components International Headquarter Offices
Japan
Europe
Fujitsu Component Limited
Gotanda-Chuo Building
3-5, Higashigotanda 2-chome, Shinagawa-ku
Tokyo 141, Japan
Fujitsu Components Europe B.V.
Diamantlaan 25
2132 WV Hoofddorp
Netherlands
Tel: (81-3) 5449-7010
Tel: (31-23) 5560910
Fax: (81-3) 5449-2626
Email: promothq@ft.ed.fujitsu.com
Web: www.fcl.fujitsu.com
Fax: (31-23) 5560950
Email: info@fceu.fujitsu.com
Web: emea.fujitsu.com/components/
North and South America
Fujitsu Components America, Inc.
250 E. Caribbean Drive
Asia Pacific
Fujitsu Components Asia Ltd.
102E Pasir Panjang Road
Sunnyvale, CA 94089 U.S.A.
Tel: (1-408) 745-4900
#01-01 Citilink Warehouse Complex
Singapore 118529
Fax: (1-408) 745-4970
Tel: (65) 6375-8560
Email: components@us.fujitsu.com
Web: http://us.fujitsu.com/components
Fax: (65) 6273-3021
Email: fcal@fcal.fujitsu.com
Web: http://www.fujitsu.com/sg/services/micro/components/
©2014 Fujitsu Components Europe B.V. All rights reserved. All trademarks or registered trademarks are the property of their respective owners.
The contents, data and information in this datasheet are provided by Fujitsu Component Ltd. as a service only to its user and only for general
information purposes.
The use of the contents, data and information provided in this datasheet is at the users’ own risk.
Fujitsu has assembled this datasheet with care and will endeavor to keep the contents, data and information correct, accurate, comprehensive,
complete and up to date.
Fujitsu Components Europe B.V. and affiliated companies do however not accept any responsibility or liability on their behalf, nor on behalf of its
employees, for any loss or damage, direct, indirect or consequential, with respect to this datasheet, its contents, data, and information and related
graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof.
Nor do Fujitsu Components Europe B.V. and affiliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability
for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or fitness for particular use,
with respect to these datasheets, its contents, data, information and related graphics and the correctness, reliability, accuracy, comprehensiveness,
usefulness, availability and completeness thereof. Rev. May 21, 2014
8
相关型号:
MZ-6WHG-U
Power/Signal Relay, 1 Form C, SPDT, Momentary, 0.075A (Coil), 6VDC (Coil), 450mW (Coil), 1A (Contact), 24VDC (Contact), DC Input, Random, AC/DC Output, Through Hole-Straight Mount, ROHS COMPLIANT
FUJITSU
MZ-6WHS
Power/Signal Relay, 1 Form C, SPDT, Latched, 1A (Contact), 60VDC (Contact), DC Input, Random, AC/DC Output
FUJITSU
MZ-6WHS-K
Power/Signal Relay, 1 Form C, SPDT, Latched, 1A (Contact), 60VDC (Contact), DC Input, Random, AC/DC Output
FUJITSU
MZ-6WHS-K-U
Power/Signal Relay, 1 Form C, SPDT, Latched, 1A (Contact), 60VDC (Contact), DC Input, Random, AC/DC Output,
FUJITSU
MZ-6WHS-U
Power/Signal Relay, 1 Form C, SPDT, Latched, 1A (Contact), 60VDC (Contact), DC Input, Random, AC/DC Output,
FUJITSU
©2020 ICPDF网 联系我们和版权申明