72247 [GAMEWELL-FCI]
Analog Addressable Duct Smoke Detectors; 模拟寻址管烟雾探测器
| 型号： | 72247 |
| 厂家： | 
GAMEWELL-FCI BY HONEYWELL |
| 描述： | Analog Addressable Duct Smoke Detectors |
| 文件： | 总2页 (文件大小：254K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
XP95-PD/-PDR,
XP95-ID/-IDR
Description
Analog Addressable Duct
Smoke Detectors
The Gamewell-FCI analog addressable duct smoke detec-
tors provide early detection of smoke and products with
combustion present in air moving through an HVAC duct.
Fans, blowers and complete systems may be shut down or
activated in fire alarm mode by the Fire Alarm Control
Panel (FACP) in the event of smoke detection.
The Gamewell-FCI analog addressable duct smoke detec-
tors may utilize either interchangeable photoelectric or ion-
ization sensor heads. The external alarm indication is a
light-emitting diode (LED), easily visible through the hous-
ing. A manual reset switch is provided on the front of the
sensor.
XP95 Series
Duct smoke detectors are also available with auxiliary relay
contacts. The relay requires two additional wires for power
and will activate when the sensor reaches alarm levels. All
wiring must comply with local codes and regulations.
Features
•
•
Compatible with the Gamewell-FCI 600 Series analog
addressable control panels
Interchangeable “Plug-in” photoelectric or ionization
heads
XP95 Duct Smoke Detectors digitally transmit their address
and the chamber’s analog value to the FACP for analysis.
•
•
•
•
•
•
•
•
•
•
•
Address is stored in the sensor base
Address is set by XPert addressing card
Remote alarm LED option
Two-wire supply- polarity insensitive
Very low standby current
LED alarm indication on sensor head
Rugged steel backbox with clear plastic cover
Large terminal connection screws
No additional screens or filters to clean or replace
Relay version available with optional remote test unit
Three standard tube lengths available: 2.5, 5, or 10 ft.
(0.762, 1.524, or 3.048 m)
Air sampling is accomplished by two tubes which protrude
into the duct. An exhaust tube of one standard length 7.5"
(19.05 cm) is provided with the sensor housing. Intake sam-
pling tubes, which must be ordered separately, are supplied
in three standard lengths: 2.5, 5, or 10 feet
(0.762, 1.524, or 3.048 m).
Installation
Duct mounting is accomplished by the use of a template
and four sheet metal screws, provided. The duct detectors
are compatible with the analog loops on Gamewell-FCI’s
600 Series Analog Addressable Control Panels.
Programming
The only programming required for the XP95 Duct Smoke
Sensors is address setting. This is accomplished through
the use of the XPert addressing card which is inserted into
the sensor base.
An ISO 9000-2000 Company
SIGNALING
FM
MEA
Approved
73-92-E
APPROVED
3242-1004:103 (photo)
3242-1004:102 (ion)
268A
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2007 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
CS-2049 Rev. a1 page 1 of 2
Programming (Continued)
Specifications (Continued)
When the sensor head is inserted into the base, the
address is automatically relayed to the sensor. Changing
the sensor does not require additional programming since
the address remains on the XPert card located in the base.
All other sensor-specific programming is accomplished at
the FACP.
Relay Versions Only:
Relay Contacts:
Two dry Form-C contacts
Relay Contact Ratings:10 A @ 24 VDC resistive
maximum
Operating Voltage:
Current:
24 VDC
Standby current:
0.010 A @ 24 VDC
Alarm current:
0.055 A @ 24 VDC
Engineer’s Specifications
The contractor shall furnish and install, where indicated on
the plans, analog addressable air duct smoke detectors.
The sensors shall be listed by Underwriter’s Laboratories
per UL 268A and UL-Listed as compatible with the Fire
Alarm Control Panel (FACP). The sensors shall operate at
air velocities from 300 to 4,000 feet (91.44 to 1219.20 m) per
minute. The smoke sensor shall contain an integral LED
that shall latch in when the unit goes into alarm, mounted at
a 30° slant to provide a wide viewing angle.
Ordering Information
Model
Description
XP95-ID
Two-wire air duct, ionization smoke detector
24 VDC (RW-AAN)
XP95-PD Two-wire air duct, photoelectric smoke
detector 24 VDC (RW-AAP)
30203-01 Remote LED alarm indicator (two VDCs);
used with XP95-PD and XP95-ID
XP95-IDR Four-wire air duct, ionization smoke detector
24 VDC with relay (RW-ARN)
A manual reset/test switch shall be located on the front of
the device. The housing shall contain a sensor base which
will accept photoelectric or ionization heads. All wiring must
comply with local codes and regulations. The duct sensor
housing shall have a metal chassis with a clear plastic
cover and complete mechanical installation may be per-
formed without removal of the cover. The duct smoke
detector shall be the Gamewell-FCI model, XP95-ID(R) or
XP95-PD(R) analog addressable duct smoke detector.
XP95-PDR Four-wire air duct, photoelectric smoke
detector 24 VDC with relay (RW-ARP)
Remote LED alarm indicator (24 VDCs);
used with relay versions
30203
30007-02 Remote test station with alarm LED;
used with relay versions
70896-02 Sampling tube, 2.5 feet (0.762 m)
70896-05 Sampling tube, 5 feet (1.524 m)
70896-10 Sampling tube, 10 feet (3.048 m)
Specifications
XP95-I
XP95-P
72247
Ionization sensor head (replacement)
Photoelectric sensor head (replacement)
Duct detector enclosure (WP-1)
(See Data Sheet CS-2308).
Ambient Temperature: 32° F to 120°F (0°C to 49°C)
Humidity:
Material:
10% to 85% R.H
18 gauge steel backbox,
clear plastic cover
Dimensions:
10.0" H x 8.25" W x 2.25" D
(25.4 H x 21.0 W x 5.7 D cm)
Maximum Net Weight: 4.0 lbs. (1.814 kg)
Mounting: Template and necessary
hardware supplied
Radioactive Element: For Ionization versions only:
Americium 241 (0.9 microcuries)
Sensitivity:
Factory set (ion); or adjustable
via the IF600 control panel
(photoelectric)
Air Velocity:
300 to 4,000 feet per minute.
Pressure Differential: 0.01 to 1.2 inches (1.524 to 20.320
meters per second) of water
Standby Current:
Photoelectric: 340 µA
Ionization: 280 µA
Photoelectric: 4 mA
Ionization: 2 mA
Alarm LED Current:
Remote Alarm Output
Range:
20 mA maximum; diode gated
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
CS-2049 Rev. a1 page 2 of 2
www.gamewell-fci.com
相关型号：
72249-004H
Board Stacking Connector, 4 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
72249-008H
Board Stacking Connector, 8 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
72249-010H
Board Stacking Connector, 10 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
72249-018H
Board Stacking Connector, 18 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
72249-020H
Board Stacking Connector, 20 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
72249-028H
Board Stacking Connector, 28 Contact(s), 2 Row(s), Male, Straight, Solder Terminal
AMPHENOL
©2020 ICPDF网 联系我们和版权申明