C5185-03 [HAMAMATSU]
Narrow Band Low Power Amplifier,;型号: | C5185-03 |
厂家: | HAMAMATSU CORPORATION |
描述: | Narrow Band Low Power Amplifier, |
文件: | 总4页 (文件大小:327K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Amplifier for infrared detector
C4159/C5185 series
C3757-02
Low noise amplifiers for infrared detector
(InSb, InAs, InAsSb, InGaAs, MCT, PbS, PbSe)
Accessories
Instruction manual
Power cable (one end with 4-pin connector for connection to amplifier and the other end unterminated, 2 m) A4372-02
Required power supply specifications
· C4159 series: ±15 V ± 0.5
· C5185 series: ±15 V ± 0.5
· Current-carrying capacity: 1.5 times or more of amplifier's maximum current consumption
· Ripple noise: 5 mVp-p or less
· Analog power supply only
Recommended DC power supply: E3620A, E3630A (Agilent Technologies)
Absolute maximum ratings (Ta=25 °C)
Parameter
Supply voltage
Operating temperature
Storage temperature
Value
Unit
V
°C
°C
18.0 max.
0 to +40
-20 to +70
Note: Absolute maximum ratings are the values that must not be exceeded at any time. If even one of the absolute maximum ratings
is exceeded even for a moment, the product quality may be impaired. Always be sure to use the product within the absolute
maximum ratings.
Amplifiers for photovoltaic detectors (Typ.)
Parameter
C4159-01
C4159-04
C4159-05
C4159-06
Unit
-
Dewar type InSb
(P5968-060, P5968-100)
Dewar type InAsSb
(P11120-901)
Dewar type InSb
(P5968-200)
Dewar type InAs
(P7163)
InAs
(P10090 series)
Applicable detector *1 *2 *3
108, 107, 106
2 × 107, 2 × 106, 2 × 105
108, 107, 106
106, 105, 104
Conversion impedance
V/A
(3 ranges switchable) (3 ranges switchable) (3 ranges switchable) (3 ranges switchable)
Frequency response
(amp only, -3 dB)
Output impedance
Maximum output voltage
(1 kΩ load)
Output offset voltage
Equivalent input noise current 0.15 (108, 107 range)
(f=1 kHz)
DC to 100 kHz *4
DC to 45 kHz
DC to 15 kHz
DC to 100 kHz
-
Ω
50
+10
±5
50
+10
±5
50
50
+10
±5
6
+10
±10
V
mV
0.15 (108, 107 range)
0.55
pA/Hz1/2
0.65 (106 range)
0.65 (106 range)
Reverse voltage
External power supply *5
Current consumption
Limited to 0 V operation
±15
+30, -10 max.
-
V
mA
+30, -22 max.
1:
*
2:
*
3:
*
These amplifiers cannot operate multiple detectors.
Consult us before purchasing if you want to use with a detector other than listed here.
Consult us before purchasing if you want to use with a multi-element detector.
*4: When connected to a detector, frequency response becomes 60 kHz or less depending on the detector active area. ( 0.6 mm: 60
φ
kHz or less, φ1 mm: 25 kHz or less) Ringing occurs in the output if the rise time tr (0 to 90%) of incident light is approximately 100
μs or less. The ringing becomes larger as the rise time becomes shorter. No ringing occurs when detecting sine-wave light. (For
information on the ringing specifications, see page 2.)
*5: Recommended DC power supply (analog power supply): ±15 V
Current capacity: More than 1.5 times the maximum current consumption
Ripple noise: 5 mVp-p or less
Note: Output noise voltage = Equivalent input noise current × Conversion impedance
For information about accessories except for the amplifiers, refer to our datasheet “Infrared detector accessories”.
1
www.hamamatsu.com
Amplifier for infrared detector
C4159/C5185 series, C3757-02
Ringing specifications
90 %
10 %
tr
Incident light
Output waveform when tr = 40 µs and active area is 0.6 mm
Ringing Vri ≤ 1.5 V
Oscillating cycle ≤ 3 cycles
KIRDC0090EA
Amplifier for InGaAs PIN photodiodes (Typ.)
Parameter
C4159-03
InGaAs
Unit
-
Applicable detector *6 *7
107, 106, 105
Conversion impedance
V/A
(3 ranges switchable)
Frequency response
(amp only, -3 dB)
Output impedance
Maximum output voltage
(1 kΩ load)
DC to 15 kHz
-
Ω
50
+10
±5
V
Output offset voltage
mV
Equivalent input noise current
(f=1 kHz)
2.5
pA/Hz1/2
Reverse voltage
External power supply *8
Current consumption
Can be applied from external unit
-
V
mA
±15
±15 max.
Amplifier for photoconductive detectors (Typ.) *9
Parameter
Applicable detector *6 *7 *10
Input impedance
C5185-02
Dewar type MCT,
InSb (P6606 series)
5
C5185-03
C3757-02
PbS, PbSe
Unit
-
MCT
(P3981/P2750 series) *11
5
10000
kΩ
Voltage gain
66 (× 2000)
66 (× 2000)
40 (× 100)
dB
Frequency response
(amp only, -3 dB)
5 Hz to 250 kHz
5 Hz to 250 kHz
0.2 Hz to 10 kHz
-
5 mA, 10 mA, 15 mA
(3 ranges switchable)
50
0.1 mA, 0.5 mA, 1 mA
(3 ranges switchable)
50
Detector bias current
Internal bias
-
Output impedance
Maximum output voltage
(1 kΩ load)
Equivalent input noise voltage
50
Ω
V
±10
2.6
±10
1.8
±10
40
nV/Hz1/2
(f=1 kHz)
External power supply *8
±15
±15
±15
V
Current consumption
+100, -30 max.
+100, -30 max.
+15, -15 max.
mA
Note: Output noise voltage = Equivalent input noise voltage × Voltage gain
*6: These amplifiers cannot operate multiple detectors.
*7: Consult us before purchasing if you want to use with a detector other than listed here.
*8: Recommended DC power supply (analog power supply): ±15 V
Current capacity: More than 1.5 times the maximum current consumption
Ripple noise: 5 mVp-p or less
*9: Before purchasing, make sure the bias current to the detector matches the detector bias current specified in the above table.
*10: Consult us before purchasing if you want to use with a multi-element detector.
*11: Preamp for P3257-25/-30/-31 available upon request
2
Amplifier for infrared detector
C4159/C5185 series, C3757-02
Dimensional outline (unit: mm, tolerance unless otherwise noted: ±1)
C4159-01/-03/-04/-05/-06
C5185-02/-03
4-pin connector
4-pin connector
PREAMPLIFIER
PREAMPLIFIER
POWER
POWER
HIGH
MID
HIGH
MID
LOW
IN
LOW
IN
OUT
OUT
BNC
Bias adjusting screw
BNC connector
Gain adjusting screw
BNC connector
Offset voltage
adjusting screw
85
85
KIRDA0048EB
Solder leads to these terminals.
PIN connections
GND
Cathode
Anode
Note: Socket for lead attachment is not provided.
KIRDA0046EC
C3757-02
4-pin connector
PREAMPLIFIER
POWER
IN
OUT
BNC connector
85
Solder leads to these terminals.
PIN connections
GND
Detector
Detector
Note: Socket for lead attachment is not provided.
KIRDA0049EC
3
Amplifier for infrared detector
C4159/C5185 series, C3757-02
A4372-02
2000 100
10
3
70 10
27
Shielded wire (4 conductors)
Solder processing
Connector: HR10-7P-4P
(made by Hirose Electric)
Pin connection
Lead color
Pin no.
Blue
-Vs
GND
GND
+Vs
Black/white/blue
stranded wire
White
As viewed from connector side
KIRDA0196EB
The C4159-03, C5185-02/-03 and C3757-02 conform to the European
EMC directives (Applied standard: EN 61326-1 Class B).
Information described in this material is current as of December, 2011.
Product specifications are subject to change without prior notice due to improvements or other reasons. Before assembly into final products, please contact
us for the delivery specification sheet to check the latest information.
Type numbers of products listed in the delivery specification sheets or supplied as samples may have a suffix "(X)" which means preliminary specifications or
a suffix "(Z)" which means developmental specifications.
The product warranty is valid for one year after delivery and is limited to product repair or replacement for defects discovered and reported to us within that
one year period. However, even if within the warranty period we accept absolutely no liability for any loss caused by natural disasters or improper product
use.
Copying or reprinting the contents described in this material in whole or in part is prohibited without our prior permission.
www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Solid State Division
1126-1 Ichino-cho, Higashi-ku, Hamamatsu City, 435-8558 Japan, Telephone: (81) 53-434-3311, Fax: (81) 53-434-5184
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, P.O.Box 6910, Bridgewater, N.J. 08807-0910, U.S.A., Telephone: (1) 908-231-0960, Fax: (1) 908-231-1218
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49) 8152-375-0, Fax: (49) 8152-265-8
France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: 33-(1) 69 53 71 00, Fax: 33-(1) 69 53 71 10
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road, Welwyn Garden City, Hertfordshire AL7 1BW, United Kingdom, Telephone: (44) 1707-294888, Fax: (44) 1707-325777
North Europe: Hamamatsu Photonics Norden AB: Smidesvägen 12, SE-171 41 Solna, Sweden, Telephone: (46) 8-509-031-00, Fax: (46) 8-509-031-01
Italy: Hamamatsu Photonics Italia S.R.L.: Strada della Moia, 1 int. 6, 20020 Arese, (Milano), Italy, Telephone: (39) 02-935-81-733, Fax: (39) 02-935-81-741
China: Hamamatsu Photonics (China) Co., Ltd.: 1201 Tower B, Jiaming Center, No.27 Dongsanhuan Beilu, Chaoyang District, Beijing 100020, China, Telephone: (86) 10-6586-6006, Fax: (86) 10-6586-2866
4
Cat. No. KIRD1011E13 Dec. 2011 DN
相关型号:
©2020 ICPDF网 联系我们和版权申明