MDA630-36N2HAD [LITTELFUSE]
Rectifier Diode,;
| 型号： | MDA630-36N2HAD |
| 厂家： | 
LITTELFUSE |
| 描述： | Rectifier Diode, |
| 文件： | 总10页 (文件大小：1926K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Date: 4th March, 2016
Data Sheet Issue: 3
IXYS
Dual Diode Modules
MD#630-30N2 & MD#630-36N2
Absolute Maximum Ratings
VRRM
[V]
MDD
MDA
MDK
3000
3600
630-30N2
630-36N2
630-30N2
630-36N2
630-30N2
630-36N2
MAXIMUM
VOLTAGE RATINGS
UNITS
LIMITS
3000-3600
3100-3700
VRRM
VRSM
Repetitive peak reverse voltage 1)
V
V
Non-repetitive peak reverse voltage 1)
MAXIMUM
LIMITS
OTHER RATINGS
UNITS
IF(AV)M
IF(AV)M
Maximum average on-state current, TC = 85°C 2)
Maximum average on-state current. TC = 100°C 2)
630
530
A
A
IF(RMS)M Nominal RMS on-state current, TC = 55°C 2)
1275
A
IF(d.c.)
IFSM
IFSM2
I2t
D.C. on-state current, TC = 55°C
1090
A
3)
Peak non-repetitive surge tp = 10 ms, VRM = 60%VRRM
11.7
kA
kA
A2s
A2s
V
Peak non-repetitive surge tp = 10 ms, VRM £ 10V 3)
13.0
I2t capacity for fusing tp = 10 ms, VRM = 60%VRRM
684×103
845×103
3000
3)
I2t
I2t capacity for fusing tp = 10 ms, VRM £ 10 V 3)
Isolation Voltage 4)
VISOL
Isolation Voltage – Enhanced. See order code page 9 4)
Operating temperature range
5000
V
Tvj op
Tstg
-40 to +150
-40 to +150
°C
°C
Storage temperature range
Notes:
1) De-rating factor of 0.13% per °C is applicable for Tvj below 25°C.
2) Single phase; 50 Hz, 180° half-sinewave.
3) Half-sinewave, 150°C Tvj initial.
4) AC RMS voltage, 50 Hz, 1min test
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 1 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Characteristics
PARAMETER
MIN. TYP. MAX. TEST CONDITIONS 1)
UNITS
VFM
VFM
VT0
rT
Maximum peak forward voltage
Maximum peak forward voltage
Threshold voltage
-
-
1.20 IFM = 800 A
1.80 IFM = 2000 A
0.80
V
V
-
-
-
-
V
Slope resistance
-
-
0.50
mW
mA
µC
µC
A
IRRM
Qrr
Qra
Irm
Peak reverse current
-
-
50
Rated VRRM
Recovered Charge
-
2900
3200
Recovered Charge, 50% chord
Reverse recovery current
Reverse recovery time, 50% chord
-
2560
-
-
-
ITM = 500A, tp =1ms, di/dt =10A/µs,
VR =100 V
-
150
trr
-
34
µs
-
-
0.0650 Single Diode
K/W
K/W
K/W
K/W
Nm
Nm
kg
RthJC
Thermal resistance, junction to case
Thermal resistance, case to heatsink
-
-
0.0325 Whole Module
-
-
-
-
0.02 Single Diode
RthCH
0.01 Whole Module
F1
F2
Wt
Mounting force (to heatsink) 2)
Mounting force (to terminals) 2)
Weight
5.1
10.2
-
-
6.9
13.8
-
-
1.5
Notes:
1) Unless otherwise indicated Tvj=150°C.
2) Screws must be lubricated.
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 2 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
VRRM
V
3000
3600
VRSM
V
3100
3700
VR
Voltage Grade
DC V
2250
2700
3000
3600
2.0 Extension of Voltage Grades
This report is applicable to other voltage grades when supply has been agreed by Sales/Production.
3.0 De-rating Factor
A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tvj below 25°C.
4.0 Snubber Components
When selecting snubber components, care must be taken not to use excessively large values of snubber
capacitor or excessively small values of snubber resistor. Such excessive component values may lead to
device damage due to the large resultant values of snubber discharge current. If required, please consult
the factory for assistance.
5.0 Computer Modelling Parameters
5.1 Thyristor Dissipation Calculations
DT
2
-VT 0 + VT 0 + 4× ff 2 ×r ×WAV
WAV =
T
Rth
IAV =
and:
2× ff 2 ×r
T
DT = Tj max -TK
Where VT0 = 0.80 V, rT = 0.50 mW.
Rth = Supplementary thermal impedance, see table below and
ff = Form factor, see table below.
Supplementary Thermal Impedance
Conduction Angle
Square wave
Sine wave
30°
60°
90°
120°
180°
270°
d.c.
0.0798
0.0736
0.0742
0.0685
0.0712
0.0667
0.0694
0.0657
0.0674
0.0651
0.0659
0.0650
Form Factors
90°
Conduction Angle
Square wave
Sine wave
30°
3.464
3.98
60°
120°
1.732
1.879
180°
1.414
1.57
270°
d.c.
1
2.449
2.778
2
1.149
2.22
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 3 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
5.2 Calculating diode VF using ABCD Coefficients
The forward characteristic IF vs. VF, on page 6 is represented by a set of constants A, B, C, D, forming the
coefficients of the representative equation for VF in terms of IF given below:
VF = A+ B×ln IF +C×IF + D× IF
( )
The constants, derived by curve fitting software, are given below for both hot and cold characteristics. The
resulting values for VF agree with the true device characteristic over a current range, which is limited to that
plotted.
25°C Coefficients
150°C Coefficients
0.8507456
0.04762876
4.08857×10-4
-3.12768×10-3
0.4945386
0.05726181
4.98169×10-4
-2.79389×10-3
A
B
C
D
A
B
C
D
5.3 D.C. Thermal Impedance Calculation
-t
p=n
æ
r = r × 1- e
ö
t p
ç
p
÷
å
t
ç
÷
p=1
è
ø
Where p = 1 to n and:
n = number of terms in the series
t = Duration of heating pulse in seconds
rt = Thermal resistance at time t
rp = Amplitude of pth term
= Time Constant of rth term
tp
The coefficients for this device are shown in the table below:
D.C. Single Diode
Term
rp
1
2
3
4
0.03671713
3.123905
0.01198766
0.8540715
0.01439901
0.1955971
1.895749×10-3
1.412289×10-3
tp
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 4 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
6.0 Reverse recovery ratings
(i) Qra is based on 50% IRM chord as shown in Fig.
Fig.
(ii) Qrr is based on a 150 µs integration time i.e.
150µs
Qrr = irr.dt
ò
0
(iii)
t1
K Factor =
t2
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 5 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Curves
Figure 1 – Forward characteristics of Limit device
MD#630-30N2-36N2
Issue 3
Figure 2 – Maximum surge and I2t Ratings
MD#630-30N2-36N2
Issue 3
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 6 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Figure 3 - Total recovered charge, Qrr
Figure 4 - Recovered charge, Qra (50% chord)
MD#630-30N2-36N2
Issue 3
MD#630-30N2-36N2
Issue 3
Tj=150°C
Tj=150°C
Figure 5 - Peak reverse recovery current, Irm
Figure 6 - Maximum recovery time, trr (50% chord)
MD#630-30N2-36N2
Issue 3
MD#630-30N2-36N2
Issue 3
Tj=150°C
Tj=150°C
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 7 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Figure 8 – Forward current vs. Heatsink
temperature
Figure 7 – Forward current vs. Power dissipation
MD#630-30N2-36N2
Issue 3
MD#630-30N2-36N2
Issue 3
Figure 9 – Transient thermal impedance
MD#630-30N2-36N2
Issue 3
Tj (initial) = 150°C
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 8 of 9
March 2016
IXYS
Dual Diode Module Types MD#630-30N2 to MD#630-36N2
Outline Drawing & Ordering Information
3
1
2
MDD
3
1
2
MDA
3
1
2
MDK
150A123
ORDERING INFORMATION
(Please quote 11/14 digit code as below)
tt
M
D#
630
N
2
HAD
Voltage code
VRRM/100
30-36
Fixed
Version
Code
Optional for
Enhanced 5kV
Isolation Voltage
Standard
Diode
Fixed
Type Code
Configuration Code
DD, DA, DK
Fixed
Type Code
Typical order code: MDA630-36N2– MDA configuration, 3600V VRRM
Typical order code (Enhanced Isolation): MDA630-36N2HAD– MDA configuration, 3600V VRRM, 5kV isolation
IXYS Semiconductor GmbH
IXYS UK Westcode Ltd
Edisonstraße 15
Langley Park Way, Langley Park,
Chippenham, Wiltshire, SN15 1GE.
Tel: +44 (0)1249 444524
D-68623 Lampertheim
Tel: +49 6206 503-0
Fax: +49 6206 503-627
E-mail: marcom@ixys.de
Fax: +44 (0)1249 659448
E-mail: sales@ixysuk.com
IXYS Long Beach
IXYS Long Beach, Inc
2500 Mira Mar Ave, Long Beach
CA 90815
IXYS Corporation
www.ixysuk.com
www.ixys.com
1590 Buckeye Drive
Milpitas CA 95035-7418
Tel: +1 (408) 457 9000
Fax: +1 (408) 496 0670
E-mail: sales@ixys.net
Tel: +1 (562) 296 6584
Fax: +1 (562) 296 6585
E-mail: service@ixyslongbeach.com
The information contained herein is confidential and is protected by Copyright. The information may not be used or disclosed
except with the written permission of and in the manner permitted by the proprietors IXYS UK Westcode Ltd.
© IXYS UK Westcode Ltd.
In the interest of product improvement, IXYS UK Westcode Ltd reserves the right to change specifications at any time without
prior notice.
Devices with a suffix code (2-letter, 3-letter or letter/digit/letter combination) added to their generic code are not necessarily
subject to the conditions and limits contained in this report.
Rating Report. Types MD#630-30N2 to MD#630-36N2 Issue 3
Page 9 of 9
March 2016
Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently
evaluate the suitability of and test each product selected for their own applications. Littelfuse products are not designed for,
and may not be used in, all applications. Read complete Disclaimer Notice at www.littelfuse.com/disclaimer-electronics.
相关型号：
©2020 ICPDF网 联系我们和版权申明