PL602-04HOC-R [MICREL]
Low Phase Noise CMOS XO (96MHz to 200MHz);型号: | PL602-04HOC-R |
厂家: | MICREL SEMICONDUCTOR |
描述: | Low Phase Noise CMOS XO (96MHz to 200MHz) 石英晶振 |
文件: | 总4页 (文件大小:260K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
PL602-04
Low Phase Noise CMOS XO (96MHz to 200MHz)
FEATURES
PIN CONFIGURATION
Low phase noise XO output for the 96MHz to
200MHz range (-125 dBc at 10kHz offset).
CLK
VDD
OE^
XIN
GND
GND
N/C
1
2
3
4
8
7
6
5
12 to 25MHz crystal input.
Integrated crystal load capacitor: no external
load capacitor required.
Selectable High Drive (30mA) or Standard Drive
(10mA) output.
XOUT
3.3V operation.
Available in 8-Pin TSSOP or SOIC.
Note: ^ denotesinternal pull up
OUTPUT RANGE
DESCRIPTION
FREQUENCY
RANGE
OUTPUT
BUFFER
MULTIPLIER
The PL602-04 is a low cost, high performance and
low phase noise XO, providing less than -125dBc at
10kHz offset in the 96MHz to 200MHz operating
range. The very low jitter makes this chip ideal for
applications requiring clean reference frequency
sources. Input crystal can range from 12 to 25MHz
(fundamental resonant mode).
X8
96 - 200MHz
CMOS
BLOCK DIAGRAM
VCO
Divider
Reference
Divider
Phase
Comparator
Charge
Pump
Loop
Filter
VCO
OE
CLK
XIN
XTAL
OSC
XOUT
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 1
PL602-04
Low Phase Noise CMOS XO (96MHz to 200MHz)
PIN DESCRIPTIONS
Name
Number
Type
Description
CLK
VDD
1
2
O
P
Output clock.
power supply.
Output enable input. Disables (tri-state) output when low. Internal pull-up
enables output by default if pin is not connected to low.
OE
3
I
XIN
XOUT
N/C
4
5
I
I
Crystal input. See Crystal Specification on page 3.
Crystal output. See Crystal Specification on page 3.
Not connected.
6
-
GND
7, 8
P
Ground.
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS
SYMBOL
MIN.
MAX.
UNITS
Supply Voltage
VDD
VI
4.6
VDD+0.5
VDD+0.5
150
V
Input Voltage, dc
-0.5
-0.5
-65
-40
V
Output Voltage, dc
VO
TS
V
Storage Temperature
C
C
C
kV
Ambient Operating Temperature*
Lead Temperature (soldering, 10s)
ESD Protection, Human Body Model
TA
85
260
2
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for e xtended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the dev ice at these or any other con-
ditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDU STRIAL), but tested for COMMERCIAL grade only.
2. DC Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN.
TYP.
MAX.
UNITS
Supply Current, Dynamic, with
Loaded Outputs
FXIN = 12 - 25MHz
Output load of 10pF
IDD
35
mA
Operating Voltage
VDD
IOH
IOL
2.97
30
3.63
V
VOH= VDD-0.4V, VDD=3.3V
VOL = 0.4V, VDD = 3.3V
VOH= VDD-0.4V, VDD=3.3V
VOL = 0.4V, VDD = 3.3V
mA
mA
mA
mA
Output drive current
(High Drive)
30
IOH
IOL
10
Output drive current
(Standard Drive)
10
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944-0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 2
PL602-04
Low Phase Noise CMOS XO (96MHz to 200MHz)
3. AC Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN.
TYP.
MAX.
UNITS
Input Crystal Frequency
12
25
MHz
Output Clock Rise/Fall Time
(Standard Drive)
Output Clock Rise/Fall Time
(High Drive)
0.3V ~ 3.0V with 15 pF load
2.4
ns
%
0.3V ~ 3.0V with 15 pF load
Measured @ 50% VDD
1.2
50
Output Clock Duty Cycle
45
55
4. Jitter and Phase Noise Specification
PARAMETERS CONDITIONS
MIN.
TYP.
MAX.
UNITS
RMS Period Jitter
(1 sigma – 1000 samples)
at 80MHz, with capacitive decoupling
between VDD and GND.
20
ps
Phase Noise relative to carrier
155.52MHz @100Hz offset
155.52MHz @1kHz offset
155.52MHz @10kHz offset
155.52MHz @100kHz offset
155.52MHz @1MHz offset
155.52MHz @10MHz offset
-100
-115
-125
-116
-114
-132
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
5. Crystal Specifications
PARAMETERS
SYMBOL
MIN.
TYP.
MAX.
UNITS
Crystal Resonator Frequency
Crystal Loading Capacitance Rating
Driving power
12
25
MHz
pF
FXIN
20
1
CL
(xtal)
mW
ESR
RS
30
PACKAGE INFORMATION
8 PIN ( dimensions in mm )
TSSOP
Narrow SOIC
Max
Max
.
Min.
-
Symbol
Min.
.
E
H
1.20
0.15
0.30
0.20
3.10
4.50
6.60
0.75
A
A1
B
C
D
E
1.34
0.10
0.33
0.19
4.80
3.80
5.80
0.38
1.74
0.05
0.19
0.09
2.90
4.30
6.20
0.45
0.25
0.51
0.25
4.95
4.00
6.20
1.27
D
H
L
A
A1
C
e
0.65 BSC
1.27 BSC
L
B
e
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944-0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 3
PL602-04
Low Phase Noise CMOS XO (96MHz to 200MHz)
ORDERING INFORMATION
For part ordering, please contact our Sales Department:
2180 Fortune Drive, San Jose, CA 95131, USA
Tel: (408) 944-0800 Fax: (408) 474-1000
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PL602-04 (H) X C
PART NUMBER
TEMPERATURE
C=COMMERCIAL
I=INDUSTRAL
Optional High Drive
PACKAGE TYPE
S=SOIC, O=TSSOP
Part/Order Number
(Commercial)
Marking*
Package Option
P602-04
OC
LLLLL
PL602-04OC
8-Pin SOP Tube
PL602-04OC-R
PL602-04HOC
PL602-04HOC-R
PL602-04SC
8-Pin SOP (Tape and Reel)
8-Pin SOP Tube
P602-04
HOC
LLLLL
8-Pin SOP (Tape and Reel)
8-Pin SOP Tube
P602-04
SC
PL602-04SC-R
PL602-04HSC
LLLLL
8-Pin SOP (Tape and Reel)
8-Pin SOP Tube
P602-04
HSC
PL602-04HSC-R
LLLLL
8-Pin SOP (Tape and Reel)
*Note: LLLLL designates lot number
Micrel Inc., reserves the right to make changes in its products or specifications, or both at any time without notice. The in formation furnished by Micrel
is believed to be accurate and reliable. However, Micrel makes no guarantee or warranty concerning the accuracy of said info rmation and shall not be
responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: Micrel’s products are not authorized for use as critical components in life support devices or systems without the express
written approval of the President of Micrel Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 4
相关型号:
©2020 ICPDF网 联系我们和版权申明