WRA1215CS-3W [MORNSUN]

DUAL/SINGLE OUTPUT DC-DC CONVERTER; 双/单路输出DC -DC转换器
WRA1215CS-3W
型号: WRA1215CS-3W
厂家: MORNSUN SCIENCE& TECHNOLOGY LTD.    MORNSUN SCIENCE& TECHNOLOGY LTD.
描述:

DUAL/SINGLE OUTPUT DC-DC CONVERTER
双/单路输出DC -DC转换器

转换器 输出元件 DC-DC转换器
文件: 总2页 (文件大小:127K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
WRA_CS-3W & WRB_CS-3W Series  
3W, WIDE INPUT, ISOLATED & REGULATED  
DUAL/SINGLE OUTPUT DC-DC CONVERTER  
multi-country patent protection RoHS  
FEATURES  
PRODUCT PROGRAM  
Miniature SIP Package  
Wide (2:1) Input Range  
Regulated Outputs  
I/0 Isolation 1500VDC  
Short Circuit Protection(automatic  
recovery)  
Internal SMD construction  
Operating Temperature: -40°C to +85°C  
External On/Off control  
RoHS Compliance  
Input  
Output  
Part  
Number  
Efficiency  
(%, Typ)  
Voltage (VDC)  
Range  
Current (mA)  
Voltage  
(VDC)  
Nominal  
Max*  
Max  
Min  
±30  
±17  
±13  
±10  
60  
WRA1205CS-3W  
WRA1209CS-3W  
WRA1212CS-3W  
WRA1215CS-3W  
WRB1205CS-3W  
WRB1209CS-3W  
WRB1212CS-3W  
WRB1215CS-3W  
WRA2405CS-3W  
WRA2409CS-3W  
WRA2412CS-3W  
WRA2415CS-3W  
WRB2405CS-3W  
WRB2409CS-3W  
WRB2412CS-3W  
WRB2415CS-3W  
±5  
±9  
±12  
±15  
5
±300  
±167  
±125  
±100  
600  
74  
76  
78  
80  
74  
76  
78  
80  
76  
78  
80  
81  
76  
78  
80  
81  
12  
9.0-18  
22  
9
333  
33  
12  
15  
±5  
±9  
±12  
±15  
5
250  
25  
200  
20  
APPLICATIONS  
±300  
±167  
±125  
±100  
600  
±30  
±17  
±13  
±10  
60  
The WRA_CS-3W & WRB-CS-3W Series  
are specially designed for applications where  
a wide range input voltage power supplies are  
isolated from the input power supply in a  
distributed power supply system on a circuit  
board.  
24  
18-36  
40  
9
333  
33  
These products apply to:  
12  
15  
250  
25  
1) Where the voltage of the input power  
supply is wide range (voltage range2:1);  
2) Where isolation is necessary between input  
and output(Isolation Voltage1500VDC);  
3) Where the regulation of the output voltage  
and the output ripple noise are demanded.  
200  
20  
*Input voltage cant exceed this value, or will cause the permanent damage.  
Note: The load shouldn't be less than 10%, otherwise ripple will increase dramatically.  
Operation under 10% load will not damage the converter; However, they may not meet all specification listed.  
COMMON SPECIFICATION  
Item  
Test Conditions  
Min  
Typ  
15  
Max  
95  
Units  
%
Storage Humidity  
Operating Temperature  
Storage Temperature  
Temp. Rise at Full Load  
Lead Temperature  
Isolation voltage  
Isolation resistance  
Isolation capacitance  
No-load Power Consumption  
Cooling  
MODEL SELECTION  
WRA1205CS-3W  
-40  
-55  
85  
125  
Rated Power  
Package Style  
Output Voltage  
Input Voltage  
Product Series  
°C  
1.5mm from case for 10 seconds  
300  
Tested for 1 minute and 1mA max 1500  
VDC  
MΩ  
PF  
Test at 500VDC  
100KHz,1V  
1000  
80  
MORNSUN Science& Technology co.,Ltd.  
100  
mW  
Address: 2th floor 6th building, Huangzhou  
Industrial District, Guangzhou, China  
Tel: 86-20-38601850  
Free Air Convection  
Plastic (UL94-V0)  
Case Material  
Fax: 86-20-38601272  
Http://www.mornsun-power.com  
Short Circuit Protection  
MTBF  
Continuous, Automatic Recovery  
1000  
K hours  
g
Weight  
6
MORNSUN reserves the copyright  
Specifications subject to change without notice.  
WRA_CS-3W & WRB_CS-3W  
A/1-2008  
Page 1 of 2  
OUTPUT SPECIFICATIONS  
Recommended circuit  
Item  
Test Conditions  
Min  
0.3  
Typ  
Max  
3
Units  
W
If you want to further decrease the  
input/output ripple, an LCfiltering network may  
be connected to the input and output ends of the  
DC/DC converter, see (Figure 1).  
Output Power  
See below products program  
Positive voltage accuracy Refer to recommended circuit  
Negative voltage accuracy Refer to recommended circuit  
±1  
±3  
±3  
±5  
%
10% To 100% Load (WRB_CS-3W)  
Load Regulation  
±0.5 ±0.75  
Single Output  
Ic  
D1  
R
10% To 100% Load (WRA_CS-3W)*  
±0.5  
±0.2  
±1.0  
±0.5  
Vc  
3
Lin  
Line Regulation  
Input Voltage From Low To High  
Refer To Recommended Circuit  
20MHz Bandwidth  
6
8
2
Vin  
+Vo  
0V  
Temperature drift (Vout)  
Ripple & Noise**  
±0.03 %/°C  
100 mVp-p  
KHz  
Cin  
Cout  
50  
Cs  
1
GND  
7
Switching Frequency  
100% Load, Input Voltage  
300  
*Dual output models unbalanced load (25/100%): ±5%Max.  
**Test ripple and noise by parallel cablemethod. See detailed operation instructions at Testing of Power  
Converter section, application notes.  
Dual Output  
Ic  
D1  
R
Vc  
3
Lin  
Lout  
Note:  
2
6
Vin  
+Vo  
0V  
1. All specifications measured at TA=25°C, humidity<75%, nominal input voltage and rated output load  
unless otherwise specified.  
Cout  
Cout  
Cin  
7
8
Lout  
2. See below recommended circuits for more details.  
1
GND  
-Vo  
TYPICAL TEMPERATURE CURVE  
(Figure 1)  
However, the capacitance of the output filter  
capacitor must be proper. If the capacitance is  
too big, a startup problem might arise. For every  
channel of output, provided the safe and reliable  
operation is ensured, the greatest capacitance  
of its filter capacitor sees (Table 1).  
General: Cin:  
12V 100uF  
24V  
10uF-47uF  
Cout:  
Lin:  
100uF(Typ.)  
4.7μH -120μH  
Operating Temp.( C )  
OUTLINE DIMENSIONS FOOTPRINT DETAILS  
Lout:  
Cs:  
2.2μH-10μH  
10uF-47uF  
First Angle Projection  
External Capacitor Table(Table 1)  
Single Vout Cout (uF) Dual Vout Cout (uF)  
RECOMMENDED FOOTPRINT  
Top view,grid:2.54mm(0.1inch)  
diameter:1.00mm(0.039inch)  
(VDC)  
(Max)  
1000  
680  
(VDC)  
(Max)  
1 2 3 5 6 7 8  
5
9
±5  
680  
(Bottom View)  
±9  
470  
Dual Output & Single Output  
12  
15  
470  
±12  
±15  
330  
330  
220  
3
5
Input current  
(0.866)  
22.00  
While using unstable power source, please  
ensure the output voltage and ripple voltage do  
not exceed indexes of the converter. The  
preceding power source must be able to provide  
for converter sufficient starting current Ip (Figure  
2). General: Ip 1.4*Iin-max  
FOOTPRINT DETAILS  
Single  
Pin  
Dual  
GND  
Vin  
(Side View)  
1
2
3
5
6
7
8
GND  
Vin  
CTRL  
NC  
CTRL  
NC  
Note:  
Unit:mm(inch)  
+Vo  
0V  
+Vo  
0V  
Pin section:0.50*0.30mm(0.020*0.012inch)  
Pin section tolerances: 0.10mm( 0.004inch)  
General tolerances: 0.25mm( 0.010inch)  
Ip  
CS  
-Vo  
NC:No Connection  
APPLICATION NOTE  
Input Voltage  
Range  
CTRL Terminal  
When open or high impedance, the converter work well; When this pin is high; the converter  
shutdown; It should be note that the input current (Ic) should between 5-10mA, exceeding the  
maximum 20mA will cause permanence damage to the converterThe value of R Can be derived  
as follows:  
Input Voltage (V)  
No parallel connection or plug and play.  
Vc-VD-1.0  
R=  
Ic  
MORNSUN reserves the copyright  
Specifications subject to change without notice.  
WRA_CS-3W & WRB_CS-3W  
A/1-2008  
Page 2 of 2  

相关型号:

WRA1215D-10W

DUAL/SINGLE OUTPUT DC-DC CONVERTER
MORNSUN

WRA1215LT-2W

SINGLE/DUAL OUTPUT DC/DC CONVERTER
MORNSUN

WRA1215LT-3W

SINGLE/DUAL OUTPUT DC/DC CONVERTER
MORNSUN

WRA1215N-2W

DUAL/SINGLE OUTPUT DIP DC-DC CONVERTER
MORNSUN

WRA1215P-3W

WIDE INPUT ISOLATED & REGULATED 3W OUTPUT
ETC

WRA1215P-3WR2

WRBP-3WR2
RSG

WRA1215P-3WR2

DC/DC Converter
MORNSUN

WRA1215S-3WR2

Ultra-Miniature SIP Package
RSG

WRA1215S-3WR2

DUAL/SINGLE OUTPUT DC-DC CONVERTER
MORNSUN

WRA1215SP-2W

DIP PACKAGE DC-DC CONVERTER
MORNSUN

WRA1215SP-3W

DUAL/SINGLE OUTPUT DIP DC-DC CONVERTER
MORNSUN

WRA1215YD-12W

12W, WIDE INPUT, ISOLATED & REGULATED DUAL OUTPUT DC-DC CONVERTER
MICRODC