MPA321 [MPD]
Smallest 1U Height, 320W, Active PFC Single Output AC/DC Power Supplies; 最小的1U高度， 320W ，采用主动式PFC单路输出AC / DC电源
| 型号： | MPA321 |
| 厂家： | 
MICROPOWER DIRECT, LLC |
| 描述： | Smallest 1U Height, 320W, Active PFC Single Output AC/DC Power Supplies |
| 文件： | 总2页 (文件大小：393K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
MPA321Series
Smallest 1U Height,
Only
6 x 4 x 1.5
Inches!!
320W, Active PFC
Single Output
AC/DC Power Supplies
Key Features:
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
• Smallest 1U 320W Supply
• PFC to EN61000-3-2 “D”
• UL, cUL, TUV Approvals
• CE Certified
Input
Parameter
Input Voltage Range
Input Frequency
Input Current, Full Load
Conditions
Min.
90
47
Typ.
6
Max.
264
63
Units
VAC
Hz
Universal
• FCC Class B Emissions
• 2 - 60 V Output Voltages
• Universal 90-264 VAC Input
• 700W Peak Power
90 VAC
110 VAC
220 VAC
240 VAC
A
30
70
Inrush Current, Cold Start
A
Leakage Current
Power Factor Correction
Input Protection
3.5
mA
• Four Mechanical Options
Meets EN61000-3-2 Class D
T6A/250V Fuse
Output
Parameter
Conditions
Min.
Typ.
5.0
1.0
20
Max.
Units
%
%
Output Voltage Adjustment
Output Regulation (Note 1)
Hold Time
By Trim Pot
110 VAC, 80% Load
mSec
Ripple & Noise (20 MHz) (Note 2)
Overload Protection
Over Voltage Protection
Over Temperature Protection
Temperature Coefficient
Transient Recovery Time (Note 3)
Transient Response Deviation
Overshoot/Undershoot
Turn On Delay
See Model Selection Guide
Foldback (Autorecovery) 110
>130% of Rated Output Voltage. Recycle AC Input.
140
%
Operating Ambient (Autorecovery)
90
100
ºC
%/ºC
mS
%
%
S
0.04
2.5
5
50% Load Change
At Turn On/Off
120 VAC
5.0
1
Output Short Circuit
Continuous With Autorecovery
General
Parameter
Conditions
Min.
Typ.
Max.
Units
VAC
kHz
Input - Output 3,000
Input - FG (Frame Ground) 1,500
Primary - Core 1,500
Fixed
Isolation Voltage (Note 4)
Switching Frequency
Interface Signals
Power Supply On
23
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Green LED (LED1) on the PCB
PG on CN1. Goes TTL high 100 to 500 mS after regulation. Goes low at
least 1 mS before the loss of regulation. Will sink 100 mA.
FF on pin 3 of CN1. Open collector output rated for 15 VDC/5 mA sink
current maximum. Goes high if a fan failure is detected
Power Good Signal
Fan Fail
Environmental
Parameter
Operating Temperature Range
Output Derating
Storage Temperature Range
Cooling
Operating Humidity
Reliability Specifications
Parameter
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Conditions
Min.
0
Typ.
+25
Max.
+50
Units
ºC
Ambient
2.5%/ ºC from +50 ºC to + 70 ºC
-20
See Model Selection Guide
+85
90
ºC
%
RH, Non-condensing
Conditions
MIL HDBK 217F, 30ºC, Gnd Benign
Min.
100
Typ.
Max.
Units
kHours
MTBF
Safety Standards
EEMI Compliance
EMS Immunity Compliance
UL 60950; CSA C22.2 No. 60950; TUV EN60950; CB Report (IEC 60950)
Compliance to EN55022 (CISPR22) Class B; EN61000-3-2,3
EN6100-4-2,3,4,5,6,8,11; EN55024,; CE Marked (LVD)
Model Selection Guide
Input & Output Connector CN2:
Howder Terminal Block No. HB-95-7P or
Mating Molex Part No. 09-91-1600 (16 pin)
Output Voltage
Max. Output Current (Notes 6, 7, 8)
“U, E, F” Units “U” Units “C” Units
Convection Convection
Model
Number
Ripple &
Noise
Efficiency
Factory
Range
PreSet
5 VDC
9 VDC
28.5 CFM
45.00A
35.50A
26.66A
21.33A
17.77A
13.33A
11.42A
8.88A
Output Pin Assignment:
MPA321x-05z
MPA321x-09z
2.0 - 6.0 VDC
7.0 - 9.0 VDC
26.00A
20.00A
15.00A
12.00A
10.00A
7.50A
6.42A
5.00A
3.75A
3.33A
23.70A
18.75A
14.16A
11.33A
9.44A
7.08A
6.07A
4.72A
3.54A
3.14A
50 mV p-p
1% p-p
1% p-p
1% p-p
1% p-p
1% p-p
1% p-p
1% p-p
1% p-p
1% p-p
75%
80%
83%
83%
83%
83%
83%
83%
83%
83%
Howder
Molex
Pins 1 ~ 2: V+
Pins 3 ~ 4: V-
Pin 5: Grnd
Pin 6: Neutral
Pin 7: Line
Pins 1 ~ 5: V+
Pins 6 ~ 10: V-
Pin 12: Grnd
Pin 14: Neutral
Pin 16: Line
MPA321x-12z 12 VDC 10.0 - 13.8 VDC
MPA321x-15z 15 VDC 14.0 - 15.5 VDC
MPA321x-18z 18 VDC 16.0 - 20.0 VDC
MPA321x-24z 24 VDC 21.0 - 26.0 VDC
MPA321x-28z 28 VDC 27.0 - 34.0 VDC
MPA321x-36z 36 VDC 35.0 - 42.0 VDC
MPA321x-48z 48 VDC 43.0 - 50.0 VDC
MPA321x-54z 54 VDC 51.0 - 60.0 VDC
Logic Signal Connector CN1:
6.66A
5.92A
Mating JST XHP or equivalent (CHYAO
SHIUNN JS-21001-3) Mating Pins: JST
SXH-002T-P0.6 for AWG 30 to 26.
Notes:
certification. Models are factory set to the “Preset” voltage.This may be adjusted within
the range without affecting the agency certification. Contact the factory for details.
6. Output current is given for the factory preset voltage.With the exception of the “05”
output model, the maximum continuous output power level is 320W (with 28.5 CFM),
180W (U-Chassis convection cooled) or 170W (“C” units convection cooled. For more
information, contact the factory.
1. Output regulation includes line & load.
2. Ripple & noise is measured from 10 Hz to 20 MHz. Measurement
connection to the unit is made with a 0.1 µF ceramic capacitor & a 22
µF electrolytic capacitor connected in parallel.
Fan driver connector (FAN2):
12 VDC / 400 mA is available to drive an
external fan. Mating connector is a JST
XHP-2 or Molex P/N 48-151-0210 ( 2 pins
0.98 pitch). Mating Pins: JST SXH-001T-
P0.62T or Molex 48150 .
3. Transient recovery is measured to within a 1% error band for a load
step change of 50% to 100%.
7. Units will provide peak power of 700W for 500 µS. For units capable of longer durations,
contact the factory.
4. Isolation specifications are production HI-Pot tested for 3 seconds.
5. The full output range (see table above) is covered in the safety agency 8. A 1% minimum load is required to maintain regulation and ripple specifications.
Mechanical Dimensions: U-Chassis (U Suffix)
U-Chassis Cover (C Suffix)
Enclosure With End Fan (E Suffix)
Enclosure With Top Fan (F Suffix)
MicroPower Direct
•
www.micropowerdirect.com
292 Page Street Ste D Stoughton, MA 02072
•
TEL: (781) 344-8226
FAX: (781) 344-8481
•
E-Mail: sales@micropowerdirect.com
相关型号：
©2020 ICPDF网 联系我们和版权申明