SHSP-1-R/N [MSYSTEM]
8-PORT ETHERNET SWITCH;
| 型号： | SHSP-1-R/N |
| 厂家： | 
M-SYSTEM |
| 描述： | 8-PORT ETHERNET SWITCH 以太网：16GBASE-T |
| 文件： | 总5页 (文件大小：119K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
MODEL: SHSP
Other Options
8-PORT ETHERNET SWITCH
(with surge protector)
blank: none
/Q: Option other than the above (specify the specification)
Functions & Features
• Surge protector function for each port
• Protects Ethernet devices from surges entering through
LAN cables
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
• Surge protector life monitor function with LED and contact
output alarm
/C02: Polyurethane coating
• Data transfer rate can be fixed
/C03: Rubber coating
EX-FACTORY SETTING
Typical Applications
/SET: Preset according to the Ordering Information Sheet
(No. ESU-9308)
• Risk managed system
40 (1.57)
RELATED PRODUCTS
• PC configurator software (model: SHSPCFG)
Downloadable at M-System’s web site.
138
A dedicated cable is required to connect the module to the
PC. Please refer to the internet software download site or
the users manual for the PC configurator for applicable
cable types.
(5.43)
124
(4.88)
mm (inch)
GENERAL SPECIFICATIONS
Surge protection: All ports
Connection
MODEL: SHSP–1–[1][2]
Ethernet: RJ-45 connector
Power input, grounding, alarm contact output:
M3 separable screw terminal (torque 0.8 N·m)
PC configurator: Miniature jack
ORDERING INFORMATION
• Code number: SHSP-1-[1][2]
Specify a code from below for each of [1] and [2].
(e.g. SHSP-1-R/CE/Q)
Screw terminal: Nickel-plated steel
Housing material: Steel, melamine baking finish (black)
Monitor LED
• Specify the specification for option code /Q
(e.g. /C01/SET)
Status: Green/Red bicolor LED;
Green light turns on in normal conditions;
Red turns on in an abnormality.
SURGE PROTECTOR
(Amber light turns on for approx. 1 second while the
internal processor is initialized at the startup.)
Surge Protector: Green/Amber/Red tricolor LED indicating
the surge protector life.
1: With
[1] POWER INPUT
AC Power
OFF while no surge has been detected;
Green when the first surge has been detected;
Amber when the protector is close to the end of life;
Red at the end of life.
M2: 100 – 240V AC (Operational voltage range 85 – 264 V,
47 – 66 Hz)
(Select ‘/N’ for ‘Standards & Approvals’ code.)
DC Power
(Amber light turns on for approx. 1 second while the
internal processor is initialized at the startup.)
LINK LED: Green LED indicating port link status.
ON with a link established; Flashes during communication.
100M LED: Amber LED indicating data transfer rate;
ON at 100 Mbps;
R: 24 V DC
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
(Select ‘/CE’ for ‘Standards & Approvals’ code.)
[2] OPTIONS (multiple selections)
Standards & Approvals (must be specified)
/N: Without CE
OFF at 10 Mbps.
PC configuration: PC Confiugrator Software is used to
program;
/CE: CE marking
SHSP SPECIFICATIONS
ES-9308 Rev.8 Page 1/5
http://www.m-system.co.jp/
MODEL: SHSP
• LAN port operating mode (Default setting: Auto
negtiation)
shortcircuit bar
Voltage protection level
Port to FG or G: 160 V min.
• User password
■ ALARM CONTACT OUTPUT
Turns on when the surge protector life ends,
when the power supply is lost,
or when an internal error is detected.
Rated load:
Between each port: 160 V min.
FG to G: 160 V min. (with the shortcircuit bar removed)
Insulation resistance: ≥ 100 MΩ with 100 V DC
(port or FG or G to alarm contact to power)
Dielectric strength: 2000 V AC @ 1 minute
(port or FG or G or power to alarm contact)
1500 V AC @ 1 minute
250 V AC @ 1.5 A (cos ø = 1)(applicable only to AC powered
model.)
30 V DC @ 1.5 A (resistive load)
Minimum load: 5 V DC @ 10 mA
(port or FG or G to power)
Mechanical life: 1 × 10 cycles (rate 180/min.)
7
STANDARDS & APPROVALS
The following standards are applied only to DC powered
LAN PORT
model.
Standards: IEEE 802.3, IEEE 802.3u, IEEE 802.3x
Number of ports: 8; All ports support AUTO-MDIX
(Automatically sensing cable type, straight-through or cross-
over)
EU conformity:
EMC Directive
EN 55032 Class A (EMI)
EN 55024 (EMS)
RoHS Directive
EN 50581
Data transfer rate: 10 Mbps (10BASE-T), 100 Mbps
(100BASE-TX); Supports Auto-Negotiation
Cable: 10BASE-T (STP cable, category 5)
100BASE-TX (STP cable, category 5e)
Maximum segment length: 100 meters
Switching: Store & Forward
Flow control
Full duplex: PAUSE Frames
Half duplex: Back pressure
Buffer: 64 KB
MAC address table: 1024
INSTALLATION
•AC: Approx. 8 VA @ 100 V
Approx. 10 VA @ 200 V
Approx. 11 VA @ 264 V
•DC: Approx. 5.5 W
Operating temperature: -5 to +60°C (23 to 140°F)
Operating humidity: 30 to 95 %RH (non-condensing)
Mounting: DIN rail
Weight
•AC powered: 650 g (1.4 lb)
•DC powered: 600 g (1.3 lb)
PERFORMANCE
Compliant standard: EN 61000-4-5 level X
Between ports: 1kV (combination waveform)
RJ-45 connector contact is out of the scope of this
protection. Using twisted-pair (STP) LAN cable is
effective to reduce risk of fusing contact.
Port to G: 10kV (combination waveform)
FG (shield) to G: 15kV (combination waveform) with the
SHSP SPECIFICATIONS
ES-9308 Rev.8 Page 2/5
http://www.m-system.co.jp/
MODEL: SHSP
EXTERNAL VIEW
FRONT VIEW
LINK LED (x 8)
100M LED (x 8)
Ethernet Switch
MODEL:SHSP
PORT 100/10M
LAN Port (x 8)
RJ45 Connector
Status
Surge Protector
Device status LED
4
5
6
7
1
2
3
Surge Protector Life Monitor LED
TOP VIEW
COMM
Configurator Jack
COMM
(front)
SHSP SPECIFICATIONS
ES-9308 Rev.8 Page 3/5
http://www.m-system.co.jp/
MODEL: SHSP
CONNECTION DIAGRAM
■ AC POWERED
JACK
COMM
LAN Port
U
PC CONFIGURATOR
RJ-45 CONNECTOR
2
3
4
5
6
7
POWER SUPPLY
V
ALARM CONTACT OUTPUT
FG
Shortcircuit bar (attached)
G
Grounding
■ DC POWERED
JACK
COMM
PC CONFIGURATOR
RJ-45 CONNECTOR
LAN Port
+
+
–
1
2
3
4
5
6
7
POWER SUPPLY
(dual redundant)
ALARM CONTACT OUTPUT
FG
Shortcircuit bar (attached)
G
Grounding
■ Relay Protection
• AC Powered
• DC Powered
Inductive
Load (Coil)
Inductive
Load (Coil)
Varistor or
CR Circuit
Diode, Varistor or
CR Circuit
LOAD
LOAD
U
EXTERNAL DIMENSIONS unit: mm (inch)
DIN RAIL
35mm wide
7–M3
SCREW
6.3 (.25)
4
1
5
2
6
3
7
40 (1.57)
124 (4.88)
[2 (.08)]
SHSP SPECIFICATIONS
ES-9308 Rev.8 Page 4/5
http://www.m-system.co.jp/
MODEL: SHSP
Specifications are subject to change without notice.
SHSP SPECIFICATIONS
ES-9308 Rev.8 Page 5/5
http://www.m-system.co.jp/
相关型号：
©2020 ICPDF网 联系我们和版权申明