Operation in Configuration Selection Mode
Select which H7CX configuration is used (i.e., 1-stage counter, 2-stage counter, total and preset counter, batch counter, dual counter, or tachom-
eter) in configuration selection mode. The H7CX is also equipped with a DIP switch monitor function, a convenient function that enables the settings
of the DIP switch pins to be confirmed using the front display.
To change the mode to configuration selection mode, press
Key for 1 s min. with the
key held down. The
mode will not change if the
key is pressed first.
(See note 2.)
(See note 1.)
1 s min.
Select the configuration using the
key only for 6-
The H7CX is factory-set to the 1-stage counter configuration (2-stage
counter configuration with H7CX-AW@/-A4W@ models).
Configuration Selection Mode
(1-stage counter) (2-stage counter) (Total and
The configuration that can be selected depend on the model.
The status of the DIP switch pins (1 to 8) can be confirmed using the
This display is possible only if DIP switch pin 1 (DIP switch set-
tings) is set to ON (i.e., enabled).
Indicates that DIP switch pin 8 is ON.
Indicates that DIP switch pin 7 is OFF.
Indicates that DIP switch pin 6 is ON.
Indicates that DIP switch pin 5 is OFF.
Indicates that DIP switch pin 4 is ON.
Indicates that DIP switch pin 3 is OFF.
Indicates that DIP switch pin 2 is ON.
Indicates that DIP switch pin 1 is ON.
When the mode is changed to configuration selection mode, the present value is reset, outputs turns OFF, and counting (measuring)
Setting changes made in configuration selection mode are enabled when the mode is changed to run mode. If the configuration is
changed, the set value (or set value 1 and set value 2), OUT1 set value or OUT2 set value are initialized.
Multifunction Preset Counter
|Home - IC Supply - Link|
|Copyright© 2001 - 2014 ICPDF All Rights Reserved ICPDF.COM