BAH48-25V40 [PAIRUI]

DC-DC Converter;
BAH48-25V40
型号: BAH48-25V40
厂家: PAIRUI GROUP INC.    PAIRUI GROUP INC.
描述:

DC-DC Converter

文件: 总4页 (文件大小:597K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
DC-DC Converter  
Bricks, Open/Enclosed  
BAH SERIES, 1/2 BRICK, UP TO 300W  
FEATURES:  
5 years warranty  
1500Vdc isolation voltage  
Output current up to 60A  
Efficiency up to 93%  
Operating temperature range -40°C to +85°C  
Under voltage, over current, short circuit,  
over voltage protection  
Remote on/off  
Adjustable output voltage  
Input voltage  
Output voltage  
(Vdc)  
Output current  
Efficiency  
Typ.  
Model  
(Vdc)  
(A)  
2.5  
2.5  
2.5  
2.5  
3.3  
3.3  
3.3  
3.3  
3.3  
3.3  
5.0  
5.0  
5.0  
5.0  
12.0  
30.0  
40.0  
50.0  
60.0  
15.0  
25.0  
30.0  
40.0  
50.0  
60.0  
15.0  
20.0  
30.0  
40.0  
25.0  
88%  
90%  
89%  
87%  
91%  
92%  
93%  
89%  
89%  
89%  
94%  
92%  
93%  
92%  
93%  
BAH48-25V30  
BAH48-25V40  
BAH48-25V50  
BAH48-25V60  
BAH48-33V15  
BAH48-33V25  
BAH48-33V30  
BAH48-33V40  
BAH48-33V50  
BAH48-33V60  
BAH48-50V15  
BAH48-50V20  
BAH48-50V30  
BAH48-50V40  
BAH48-120V25  
Notes:  
48(36~72)  
1. Other input and output models may available on request;  
2. You may request for the models with heatsink, plus “R” in the suffix, e.g. BAH48-25V30R.  
ELECTRICAL  
Input voltage range  
Remote control  
48Vdc  
36-72Vdc  
OFF: High level or left close  
ON: Low level or grounded  
ON: High level or left open  
OFF: Low level or grounded  
50-300W  
Negative logic  
Positive logic  
Output power  
Input voltage range  
www.pairuigroup.com  
Page: 1 / 4  
Date: 01/23/2014  
DC-DC Converter  
Bricks, Open/Enclosed  
BAH SERIES, 1/2 BRICK, UP TO 300W  
ELECTRICAL  
Output voltage  
Single output  
2.5/3.3/5/12Vdc  
±1%  
Output voltage accuracy  
Output voltage adjustable  
Line regulation  
Input voltage range  
Positive  
-20% - +10%  
±0.2%  
Full load  
Load regulation  
10%-100% full load  
±0.5%  
Dynamic response  
25%-50%-75% load capability  
∆Vo/∆t: ±4.0%/500μs  
(transient/recovery time)  
Ripple and noise  
Parallel test, 20MHz wide range  
Typical value  
180mVp-p max.  
250KHz typ.  
1500Vdc  
Operating frequency  
Input to output  
Input to case  
Isolation voltage  
1050Vdc  
Output to case  
---  
500Vdc  
Isolation resistance  
Safety  
10MΩ  
IEC-60950-1, UL-60950-1  
EN-60950-1, GB4943  
300ppm  
---  
Temperature coefficient  
Operating temperature range  
Storage temperature range  
Over temperature protection  
Under voltage protection  
Over current protection  
Short circuit protection  
Over voltage protection  
Relative humidity  
---  
Auxiliary heat sink  
-40°C to +85°C  
-40°C to +125°C  
110°C typ.  
Yes  
---  
Typical  
---  
---  
Yes  
---  
Yes  
---  
Yes  
---  
95% max.  
Hole package  
2x106Hrs  
Packing  
---  
MTBF  
Bellcore TR-332, 25°C  
Notes: Unless otherwise specified, all the parameters of the test conditions are as follows: ambient temperature  
25 , the nominal input voltage, pure resistive nominal load.  
www.pairuigroup.com  
Page: 2 / 4  
Date: 01/23/2014  
DC-DC Converter  
Bricks, Open/Enclosed  
BAH SERIES, 1/2 BRICK, UP TO 300W  
MECHANICAL  
WITHOUT HEATSINK  
WITH HEATSINK  
PCB LAYOUT  
CONNECTION  
PIN #  
SINGLE  
-Vin  
FG  
1
2
3
REM  
+Vin  
GND  
-S  
4
5
6
7
8
TRIM  
+S  
9
+Vo  
Note:  
* Unit is mm(inch).  
DERATING CURVE  
EFFICIENCY CURVE  
www.pairuigroup.com  
Page: 3 / 4  
Date: 01/23/2014  
DC-DC Converter  
Bricks, Open/Enclosed  
BAH SERIES, 1/2 BRICK, UP TO 300W  
NOTES  
RECOMMENDED TEST AND APPLICATION CIRCUIT  
NOTES  
1. TVS&FUSE be helpful with over voltage protection and inrush limiting. Recommended FUSE better be 1.5~2times of  
the rated current .  
2. The input filter capacitor C6 could select the aluminum electrolytic capacitors or tantalum capacitors, and the  
withstand voltage should be greater than the highest input voltage. Recommended capacitor should be between  
22μF~100μF.  
3. C1,C2 for the input filter capacitor,0.1~1μF high-frequency ceramics capacitor or chip capacitor are recommended.  
The withstand voltage of output filter C5, C7 should be greater than the highest output voltage. Recommended  
capacitor of C7 better within 100μF and C5 connected with the chip to reduce the input voltage peak, recommended  
0.1~1μF high-frequency ceramics capacitor or chip capacitor.  
www.pairuigroup.com  
Page: 4 / 4  
Date: 01/23/2014  

相关型号:

BAH48-25V50

DC-DC Converter
PAIRUI

BAH48-25V60

DC-DC Converter
PAIRUI

BAH48-33V15

DC-DC Converter
PAIRUI

BAH48-33V25

DC-DC Converter
PAIRUI

BAH48-33V30

DC-DC Converter
PAIRUI

BAH48-33V40

DC-DC Converter
PAIRUI

BAH48-33V50

DC-DC Converter
PAIRUI

BAH48-33V60

DC-DC Converter
PAIRUI

BAH48-50V15

DC-DC Converter
PAIRUI

BAH48-50V20

DC-DC Converter
PAIRUI

BAH48-50V30

DC-DC Converter
PAIRUI

BAH48-50V40

DC-DC Converter
PAIRUI