PI5C3401QX [PERICOM]

Bus Exchanger, CBT/FST/QS/5C/B Series, 1-Func, 6-Bit, True Output, CMOS, PDSO24, 0.150 INCH, PLASTIC, QSOP-24;
PI5C3401QX
型号: PI5C3401QX
厂家: PERICOM SEMICONDUCTOR CORPORATION    PERICOM SEMICONDUCTOR CORPORATION
描述:

Bus Exchanger, CBT/FST/QS/5C/B Series, 1-Func, 6-Bit, True Output, CMOS, PDSO24, 0.150 INCH, PLASTIC, QSOP-24

光电二极管 逻辑集成电路
文件: 总5页 (文件大小:314K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
PI5C3401  
6-Bit, 3-Port Bus Exchange Switch  
Features:  
Description:  
• Near-Zero propagation delay  
PericomSemiconductor’sPI5C3401isa6-bit,3-portbusexchange  
switchdesignedwithalowOn-Resistance(5-ohm)allowinginputs  
to be connected directly to outputs. The bus switch creates no  
additional propagation delay or additional ground bounce noise.  
The switches are turned OFF by S0 = H and S1 = H. The A bus  
can be connected to B bus by S0 =L and S1 = L. The B bus can  
be connected to C bus by S0 = H and S1=L. The C bus can be  
connected to A bus by S0 = L and S1 = H.  
• 5-ohm switches connect inputs to outputs  
Direct bus connection when switches are ON  
Ultra Low Quiescent Power (0.2μA typical)  
– Ideally suited for notebook applications  
• Packaging (Pb-free & Green available):  
– 24-pin 150-mil wide plastic QSOP (Q)  
– 24-pin 300-mil wide plastic SOIC (S)  
Block Diagram  
Pin Conguration  
B0  
A0  
C0  
B5  
A5  
C5  
S0  
DECODER  
S1  
Pin Description  
Pin Name  
S0, S1  
A0–5  
B0–5  
Description  
Bus Direction  
Bus A  
(1)  
Truth Table  
Function  
S0  
H
L
S1 A0–5 B0–5  
C0–5  
Hi-Z  
Hi-Z  
B0–5  
A0–5  
Bus B  
Disconnect  
H
L
L
H
Hi-Z Hi-Z  
B0–5 A0–5  
Hi-Z C0–5  
C0–5 Hi-Z  
C0–5  
Bus C  
Connect A-B  
Connect B-C  
Connect C-A  
NC  
No Connect  
Ground  
Power  
H
L
GND  
VCC  
Note:  
1. H = High Voltage Level, L = Low Voltage Level,  
Hi-Z = High Impedance  
PS7020E  
05/02/07  
07-0127  
1
PI5C3401  
6-Bit, 3-Port Bus Exchange Switch  
Maximum Ratings  
(Above which the useful life may be impaired. For user guidelines, not tested.)  
Storage Temperature ..........................................................–65°C to +150°C  
Ambient Temperature with Power Applied .........................–40°C to +85°C  
Supply Voltage to Ground Potential .....................................–0.5V to +7.0V  
DC Input Voltage ..................................................................–0.5V to +7.0V  
DC Output Current............................................................................120 mA  
Power Dissipation.................................................................................0.5W  
Note:  
Stresses greater than those listed under MAXIMUM RAT-  
INGS may cause permanent damage to the device. This is a  
stress rating only and functional operation of the device at  
these or any other conditions above those indicated in the  
operational sections of this specication is not implied. Ex-  
posure to absolute maximum rating conditions for extended  
periods may affect reliability.  
DC Electrical Characteristics (Over the Operating Range, T = –40°C to +85°C, V = 5V ±5%)  
A
CC  
(1)  
(2)  
Parameters  
Description  
Test Conditions  
Min.  
2.0  
Typ  
Max.  
Units  
V
IH  
Input HIGH Voltage  
Guaranteed Logic HIGH Level  
Guaranteed Logic LOW Level  
V
V
IL  
Input LOW Voltage  
–0.5  
0.8  
±1  
I
Input HIGH Current  
V
V
= Max., V = V  
IN CC  
IH  
CC  
I
Input LOW Current  
= Max., V = GND  
±1  
μA  
IL  
CC  
IN  
CC  
I
OZ  
High Impedance Output Current  
Clamp Diode Voltage  
0 A, B V  
= Min., I = –18 mA  
±1  
V
V
CC  
–0.7  
–1.2  
V
IK  
IN  
(3)  
I
Short Circuit Current  
A (B) = 0V, B (A) = V  
100  
mA  
mV  
OS  
CC  
V
Input Hysteresis at Control Pins  
150  
5
H
V
V
= Min., V = 0.0V, I = 48mA  
7
CC  
IN  
ON  
(4)  
R
Switch On-Resistance  
Ω
ON  
= Min., V = 2.4V, I = 15mA  
10  
15  
CC  
IN  
ON  
Notes:  
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.  
2. Typical values are at Vcc = 5.0V, TA = 25°C ambient and maximum loading.  
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.  
4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the lower of the  
voltages on the two (A,B) pins.  
Capacitance (TA = 25°C, f = 1 MHz)  
(1)  
Parameters  
Description  
Input Capacitance  
Test Conditions  
Typ.  
Max.  
Units  
C
6
6
8
IN  
C
A/B Capacitance, Switch Off  
A/B Capacitance, Switch On  
V
= 0V  
IN  
pF  
OFF  
C
ON  
Notes:  
1. This parameter is determined by device characterization but is not production tested.  
PS7020E  
05/02/07  
07-0127  
2
PI5C3401  
6-Bit, 3-Port Bus Exchange Switch  
Power Supply Characteristics  
(1)  
(2)  
Parameters  
Description  
Test Conditions  
Min.  
Typ  
Max.  
Units  
Quiescent Power  
Supply Current  
V
or V  
= GND  
IN  
I
V
= Max.  
= Max.  
0.1  
3.0  
μA  
CC  
CC  
CC  
Supply Current per  
Input @ TTL HIGH  
(3)  
ΔI  
V
V
V = 3.4V  
IN  
2.5  
mA  
CC  
CC  
CC  
= Max.,  
A and B Pins Open  
BE = GND  
Control Input Toggling  
50% Duty Cycle  
Supply Current per  
Input per MHz  
mA/  
MHz  
I
0.25  
CCD  
(4)  
Notes:  
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device.  
2. Typical values are at VCC = 5.0V, +25°C ambient.  
3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to ICC  
.
4. This current applies to the control inputs only and represent the current required to switch internal capacitance at the specied frequency. The  
A and B inputs generate no signicant AC or DC currents as they transition. This parameter is not tested, but is guaranteed by design.  
Switching Characteristics over Operating Range  
Com.  
Parameters  
Description  
Conditions  
Unit  
Min.  
Max.  
(1,2)  
Propagation Delay  
t
t
PLH  
Ax to Bx, Bx to Cx  
or Cx to Ax  
0.25  
PHL  
C = 50pF  
R = 500-ohm  
L
ns  
L
Bus Direction Time  
SX to Ax or Bx or Cx  
t
1.5  
6.5  
S
Notes:  
1. This parameter is guaranteed but not tested on Propagation Delays.  
2. The bus switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The  
time constant for the switch alone is of the order of 0.25ns for 50 pF load. Since this time constant is much smaller than the rise/fall times of  
typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is  
determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.  
PS7020E  
05/02/07  
07-0127  
3
PI5C3401  
6-Bit, 3-Port Bus Exchange Switch  
Packaging Mechanical: 24-pin QSOP (Q)  
24  
.008  
0.20  
MIN.  
.008  
.013  
0.20  
0.33  
.150  
.157  
3.81  
3.99  
Guage Plane  
0˚-6˚  
.010  
.016  
.035  
0.41  
0.89  
0.254  
Detail A  
1
.041  
1.04  
REF  
.337 8.56  
.344 8.74  
.015 x 45˚  
0.38  
.033  
0.84  
.053 1.35  
.069 1.75  
Detail A  
0.178  
0.254  
.007  
.010  
SEATING  
PLANE  
.016 0.406  
.050 1.27  
0.101  
0.254  
.004  
.010  
.025  
typical  
.228  
.244  
0.203  
0.305  
.008  
.012  
0.635  
5.79  
6.20  
X.XX  
X.XX  
DENOTES DIMENSIONS  
IN MILLIMETERS  
Packaging Mechanical: 24-pin SOIC (S)  
24  
7.40  
7.60  
.2914  
.2992  
0.254  
0.737  
.010  
.029  
x 45˚  
1
0.23  
0.32  
.0091  
.0125  
0-8˚  
.5985  
.6141  
15.20  
15.60  
0.41  
1.27  
.016  
.050  
0.533  
0.787  
.021  
.031  
2.35  
2.65  
.0926  
.1043  
.394  
.419  
10.00  
10.65  
SEATING  
PLANE  
0.10  
0.30  
.0040  
.0118  
.050  
BSC  
.013  
.020  
0.33  
0.51  
1.27  
X.XX  
X.XX  
DENOTES DIMENSIONS  
IN MILLIMETERS  
PS7020E  
05/02/07  
07-0127  
4
PI5C3401  
6-Bit, 3-Port Bus Exchange Switch  
Ordering Information  
Ordering Code  
PI5C3401S  
Package Code  
Package Description  
S
S
24-pin SOIC  
PI5C3401SE  
Pb-free & Green, 24-pin SOIC  
24-pin QSOP  
PI5C3401Q  
Q
Notes:  
Thermal characteristics can be found on the company web site at www.pericom.com/packaging/  
E = Pb-free & Green  
• Adding an X sufx = Tape/Reel  
Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com  
PS7020E  
05/02/07  
07-0127  
5

相关型号:

PI5C3401S

6-Bit, 3-Port Bus Exchange Switch
PERICOM

PI5C3401SE

6-Bit, 3-Port Bus Exchange Switch
PERICOM

PI5C3401SEX

暂无描述
PERICOM

PI5C3401SX

Bus Exchanger, CBT/FST/QS/5C/B Series, 1-Func, 6-Bit, True Output, CMOS, PDSO24, 0.300 INCH, PLASTIC, SOIC-24
PERICOM

PI5C34171C

17-Bit to 34-Bit, Demux PCI Hot-Plug Bus Switch with 2V Undershoot Protection
PERICOM

PI5C34171CA

Bus Exchanger
PERICOM

PI5C34171CAE

Bus Driver, CBT/FST/QS/5C/B Series, 1-Func, 17-Bit, True Output, CMOS, PDSO56, 0.240 INCH, GREEN, PLASTIC, TSSOP-56
PERICOM

PI5C34171CAEX

Bus Driver, CBT/FST/QS/5C/B Series, 1-Func, 17-Bit, True Output, CMOS, PDSO56, 0.240 INCH, GREEN, PLASTIC, TSSOP-56
PERICOM

PI5C34171CAX

暂无描述
PERICOM

PI5C3417ICA

17-Bit to 34-Bit, Demux PCI Hot-Plug Bus Switch with 2V Undershoot Protection
PERICOM

PI5C34EX245BEX

Bus Driver, CBT/FST/QS/5C/B Series, 4-Func, 8-Bit, True Output, CMOS, PDSO80, 0.150 INCH, PLASTIC, BQSOP-80
PERICOM

PI5C34EX2461NBEX

Bus Driver, CBT/FST/QS/5C/B Series, 4-Func, 10-Bit, True Output, CMOS, PBGA96, 5.50 X 13.50 MM, LFBGA-96
PERICOM