RS2332 [PTC]

High-Voltage Start-Up Primary Side LED Controller with Active PFC;
RS2332
型号: RS2332
厂家: PRINCETON TECHNOLOGY CORP    PRINCETON TECHNOLOGY CORP
描述:

High-Voltage Start-Up Primary Side LED Controller with Active PFC

功率因数校正
文件: 总4页 (文件大小:264K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
RS2332  
High-Voltage Start-Up Primary Side LED  
Controller with Active PFC  
DESCRIPTION  
FEATURES  
The RS2332 integrates 600V ultra high voltage startup  
circuit reduces the total power consumption to provide  
a high efficiency solution for lighting applications and it  
is a single-power stage, isolated, primary-side-control  
offline LED lighting controller that achieves high power  
factor in a single SOP-8 package. The proprietary  
real-current control method can control the LED  
current accurately from the primary side information. It  
can significantly simplify the LED lighting system  
design by eliminating the secondary side feedback  
components and the opto-coupler.  
Very less components  
Build-in 600V start-up circuit  
Real current control without secondary feedback  
Accurate constant current output  
Active power factor correction (>0.9)  
Quasi resonance mode for high efficiency  
Under voltage lockout (UVLO)  
Programmable input AC voltage compensation  
Leading edge blanking on CS/ZCD pin  
Available in an SOP-8 package  
Protection features  
- Building in hysteresis OTP  
- VCC over voltage protection  
- Clamped Gate output voltage to maximal 18V  
- Cycle by cycle current limiting on CS  
- Secondary peak current protection on CS pin  
- Output short to GND protection  
- Output programmable over voltage protection  
The RS2332 integrates active power factor correction  
and works in quasi resonance mode in order to reduce  
the MOSFET switching losses. The multi-protection  
features of RS2332 greatly enhance the system  
reliability and safety. The RS2332 features over  
voltage  
protection,  
short  
circuit  
protection,  
cycle-by-cycle current limit, VCC UVLO and  
auto-restart over-temperature protection. The driver  
output voltage is clamped at maximal 18V to protect  
the external power MOSFET.  
APPLICATIONS  
Low Power AC/DC offline SMPS for:  
- Solid state lighting  
- Industrial and commercial lighting  
BLOCK DIAGRAM  
Tel: 886-66296288Fax: 886-29174598http://www.princeton.com.tw2F, No. 233-1, Baociao Rd., Sindian Dist., New Taipei City 23145, Taiwan  
RS2332  
APPLICATION CIRCUIT  
ORDER INFORMATION  
Device  
Device Code  
Y is package & Pin Assignments designator:  
S: SOP-8  
RS2332 Y Z  
Z is Lead Free designator:  
P: Commercial Standard, Lead (Pb) Free and Phosphorous (P) Free Package  
G: Green (Halogen Free with Commercial Standard)  
V1.2  
2
December 2014  
RS2332  
PIN CONFIGURATION  
PIN DESCRIPTION  
Pin Name  
Description  
Pin No.  
Loop Compensation pin. Connect a compensation network to stabilize the LED driver and  
achieve an accurate LED driver current.  
Reference GND of IC  
COMP  
GND  
1
2
Current sense pin. The MOSFET current is sensed via a resistor. If the voltage in this pin  
is higher than the current limit threshold 1.0V after some blanking time in the turn-on  
interval, the gate signal will be turned off.  
CS  
3
Gate drive output pin. The totem pole output stage is able to drive high power MOSFET  
with a peak current of 0.5A source capability and 0.8A sink capability. The high level  
voltage of this pin is clamped to 19V to avoid excessive gate drive voltage.  
Power supply.  
GATE  
VCC  
4
5
Zero current detection pin. A negative going edge triggers the turn on signal of the  
external MOSFET. Connect this pin through a resistor divider from the auxiliary winding to  
GND. Over-voltage conditions is detected through ZCD. If ZCD voltage is higher than the  
over-voltage-protection (OVP) threshold after a blanking time 1μs, the over-voltage  
condition is detected.  
ZCD  
6
NC  
HV  
No connect  
High voltage startup switch instead of resistor  
7
8
V1.2  
3
December 2014  
RS2332  
IMPORTANT NOTICE  
Princeton Technology Corporation (PTC) reserves the right to make corrections, modifications, enhancements,  
improvements, and other changes to its products and to discontinue any product without notice at any time.  
PTC cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a PTC product. No  
circuit patent licenses are implied.  
Princeton Technology Corp.  
2F, 233-1, Baociao Road,  
Sindian Dist., New Taipei City 23145, Taiwan  
Tel: 886-2-66296288  
Fax: 886-2-29174598  
http://www.princeton.com.tw  
V1.2  
12  
December 2014  

相关型号:

RS2332SG

High-Voltage Start-Up Primary Side LED Controller with Active PFC
PTC

RS2332SP

High-Voltage Start-Up Primary Side LED Controller with Active PFC
PTC

RS2336

700V High Voltage Quasi-Resonant Fly-back PWM Controller
PTC

RS2336DP

700V High Voltage Quasi-Resonant Fly-back PWM Controller
PTC

RS2336SP

700V High Voltage Quasi-Resonant Fly-back PWM Controller
PTC

RS24

KUPPLUNG ROTE REIHE 24POL
ETC

RS240G30

Board Connector, 40 Contact(s), 2 Row(s), Female, Straight, 0.1 inch Pitch, Solder Terminal, Plug
ADAM-TECH

RS244G30

HEADER CONNECTOR,PCB MNT,PLUG,44 CONTACTS,SKT,0.1 PITCH,PC TAIL TERMINAL,
ADAM-TECH

RS24N*

Monitor_ICs:BA7657F AD9883AKST-110 MSP3451G AD9884AKS-140 BA7078AF VPC3230D-C5 Z86129 FST3257 4S643232 FST16233MTD FLI2200 DS1834 80251G2 JAG200MXHD AD5301B DS90C387VJD IRU1030-33CM
ETC

RS24T

HEADER CONNECTOR,PCB MNT,PLUG,4 CONTACTS,SKT,0.1 PITCH,PC TAIL TERMINAL,
ADAM-TECH

RS25-12

25W Single Output Switching Power Supply
ASTRODYNE

RS25-15

25W Single Output Switching Power Supply
ASTRODYNE