Surface Mount Transient Voltage Suppressors
The 5KPS series of high current uni/bi-directional transient
suppressors are designed for A.C. line protection and high power
DC bus clamping applications. These devices offer
uni/bi-directional port protection from 15 volts to 43 volts.
provide a clamping voltage lower than the avalanche
Therefore, any voltage rise due to increased
is contained to a minimum, providing
level. They can also be
create very high
the best possible protection
connected in series and/or parallel to
capacity protection solutions.
JEDEC R-6/P-600 Molded Plastic.
Glass passivated chip junction in R-6/P600 package.
6600 W peak pulse power capability with a 10/1000 us
waveform, repetitive rate (duty cycle):0.01 %
Excellent clamping capability
Very fast response time: typically less than 1.0ps from 0V to
Meet with ISO 7637-2,ISO 16750,etc
Use in sensitive electronics protection against voltage transients
induced by inductive load switching and lighting, especially for
automotive load dump protection application
Peak power dissipation with a 10/1000us waveform
Power Dissipation on Infinite Heat Sink at T
Peak pulse current with a 10/1000us waveform
Operating junction and storage temperature range
Peak forward surge current, 8.3ms single half sine-wave
See Next Table
Revision February 2, 2015
@ UN Semiconductor Co., Ltd.
Specifications are subject to change without notice.
Please refer to www.unsemi.com.tw for current information.
|首页 - - 友情链接|
|Copyright© 2001 - 2014 ICPDF All Rights Reserved ICPDF.COM