Modular Passive Oscilloscope Probe w/RO
Accessories included with Probe:
Modular Passive Oscilloscope Probe with Readout
This probe is recommended for general purpose
probing applications and is adjustable for low
The probe's entire core is made of a high quality
Pure coaxial design and laser trimmed resistors
ensure highest signal fidelity along the signal path
offering high bandwidth and fast risetimes for
accurate impulse measurements.
Our passive probes are spring loaded, with needle
sharp tips to support precise and safe
Probe tips are interchangeable and can be replaced
Accessories (one of each) included with Probe are:
Ground Lead with Alligator Clip 22 cm (8.66”)
IC Caps: 0.8mm, 1.0mm, and 1.27mm pitch
Insulating Cap (green)
Solid Tip 0.8mm (0.0315”)
Spring Tip 0.8mm (0.0315”)
Copper (Cu) Pads
The Readout BNC connector enables automatic
recognition by scopes that feature a sense ring to
detect probe attenuation.
Maximum Input Voltage CAT II¹
Scope Bandwidth MHz
Probe Bandwidth MHz (-3 dB)
System Risetime (ns)
Probe Input Resistance (MΩ)
Probe Input Capacitance (pF)
Compensation Range (pF)
15 - 40
4 ft. (1.2 m)
Per IEC 61010-031. Maximum voltage allowed on the low or ground
connection including shell and housing must not exceed 30 V.
2 Any oscilloscope that uses the Tektronix® style range actuator.
150 MHz X10 Scope Probe RO
31-(0) 40 2675 150
Where to Buy:
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm),
.xxx = ± .005” (,127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks are
the property of their respective companies.
Copyright © 2008
D2015565 Rev. 002
Page 1 of 1
|首页 - - 友情链接|
|Copyright© 2001 - 2014 ICPDF All Rights Reserved ICPDF.COM