电子元器件数据表 IC PDF查询
English 中文版
  品牌   我要上传
型号:  
描述:
WV3EG264M72ESFR262D4-MG  2D02W8J012JC5E  KR12D5-500  JR12D5-1000  HSD16M32D4-12  7612D2-2  2D02W8J012JT3E  JC12D5-200  HSD16M32D4-13  DM12D5-1500  
ML4831CP Electronic Ballast Controller
型号:   ML4831CP
PDF文件: 下载PDF文件   鼠标右键选目标另存为
网页直接浏览   不需安装PDF阅读软件
在线打开PDF文件   需安装PDF阅读软件
描述:   Electronic Ballast Controller
文件大小 :   195 K    14 页
Logo:   
品牌   MICRO-LINEAR [ MICRO LINEAR CORPORATION ]
购买 :   
  浏览型号ML4831CP的Datasheet PDF文件第2页 浏览型号ML4831CP的Datasheet PDF文件第3页 浏览型号ML4831CP的Datasheet PDF文件第4页 浏览型号ML4831CP的Datasheet PDF文件第5页 浏览型号ML4831CP的Datasheet PDF文件第6页 浏览型号ML4831CP的Datasheet PDF文件第7页 浏览型号ML4831CP的Datasheet PDF文件第8页 浏览型号ML4831CP的Datasheet PDF文件第9页  
100%
JULY 2000
ML4831*
Electronic Ballast Controller
GENERAL DESCRIPTION
The ML4831 is a complete solution for a dimmable, high
power factor, high efficiency electronic ballast. Contained
in the ML4831 are controllers for “boost” type power
factor correction as well as for a dimming ballast.
The Power factor circuit uses the average current sensing
method with a gain modulator and over-voltage
protection. This system produces power factors of better
than 0.99 with low input current THD at > 95%
efficiency. Special care has been taken in the design of the
ML4831 to increase system noise immunity by using a
high amplitude oscillator, and a current fed multiplier. An
over-voltage protection comparator inhibits the PFC
section in the event of a lamp out or lamp failure
condition.
The ballast section provides for programmable starting
scenarios with programmable preheat and lamp out-of-
socket interrupt times. The IC controls lamp output
through either frequency modulation using lamp current
feedback.
The ML4831 is designed using Micro Linear‘s Semi-
Standard tile array technology. Customized versions of this
IC, optimized to specific ballast architectures can be made
available. Contact Micro Linear or an authorized
representative for more information.
FEATURES
s
Complete Power Factor Correction and Dimming
Ballast Control on one IC
Low Distortion, High Efficiency Continuous Boost,
Average Current sensing PFC section
Programmable Start Scenario for Rapid or Instant Start
Lamps
Lamp Current feedback for Dimming Control
Variable Frequency dimming and starting
Programmable Restart for lamp out condition to
reduce ballast heating
Over-Temperature Shutdown replaces external heat
sensor for safety
PFC Over-Voltage comparator eliminates output
“runaway” due to load removal
Large oscillator amplitude and gain modulator
improves noise immunity
s
s
s
s
s
s
s
s
* This product is End Of Life as of July 1, 2000
BLOCK DIAGRAM
7
8
R(SET)
R(T)/C(T)
OSCILLATOR
INTERRUPT
LAMP F.B.
LFB OUT
9
5
6
OUTPUT
DRIVERS
R(X)/C(X)
PRE-HEAT
AND INTERRUPT
TIMERS
OUT A
CONTROL
&
GATING LOGIC
OUT B
14
10
13
PFC OUT
2
4
3
1
18
IA OUT
IA+
I(SINE)
EA OUT
EA–/OVP
POWER
FACTOR
CONTROLLER
UNDER-VOLTAGE
AND THERMAL
SHUTDOWN
PGND
VCC
V
REF
GND
15
12
16
17
11
1
首页 - - 友情链接
Copyright© 2001 - 2014 ICPDF All Rights Reserved ICPDF.COM

粤公网安备 44030402000629号


粤ICP备13051289号-7