PLC-035S045D [QUALTEK]

35Watts Single Output LED Driver; 35Watts单路输出LED驱动器
PLC-035S045D
型号: PLC-035S045D
厂家: QUALTEK ELECTRONICS CORPORATION    QUALTEK ELECTRONICS CORPORATION
描述:

35Watts Single Output LED Driver
35Watts单路输出LED驱动器

驱动器
文件: 总3页 (文件大小:1534K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
P
ualtek  
Q
P C  
35Watts Single Output LED Driver  
PLC-035 D Series  
Electronics Corporation  
Features:  
Constant Current Design  
Dimming Control  
Universal AC input/ Full Range  
Built-in Active PFC function, PF 0.98 Typical  
High Efficiency (Up to 88%)  
Output Protections: OVP/SCP/OTP  
Lightning Protection  
Class 2 Power Unit (See Note)  
Waterproof (IP67)  
CB  
5 Year Warranty  
PLC-035S035D PLC-035S045D PLC-035S070D PLC-035S105D PLC-035S140D PLC-035S175D PLC-035S210D PLC-035S245D PLC-035S290D  
Model  
Output Characteristics  
0.35A (1)  
33~100V  
±10% Vo  
±5% Vo  
±1% Vo  
±3% Vo  
0.45A (1)  
26~78V  
0.70A (2)  
17~50V  
1.05A (3)  
11~33V  
1.40A (3)  
8~24V  
1.75A (3)  
7~20V  
2.10A (3)  
6~18V  
2.45A (3)  
5~15V  
2.90A (3)  
4~12V  
Rated Current  
Voltage Range  
See Note  
Ripple and Noise (max) Note 1  
Voltage Accuracy  
Line Regulation  
Load Regulation  
20mS Max @ Rated Load  
Rise Time  
8.5mS Min (110VAC input, full load), 10mS Min (220VAC input, full load)  
Hold-up Time (Typ.)  
Input Characteristics  
Voltage Range  
90VAC~305VAC  
47Hz-63Hz  
Frequency Range  
>0.98  
>0.92  
88%  
>0.98  
>0.92  
87%  
>0.98  
>0.92  
86%  
>0.98  
>0.92  
86%  
>0.98  
>0.92  
85%  
>0.98  
>0.92  
84%  
>0.98  
>0.92  
84%  
>0.98  
>0.92  
83%  
>0.98  
>0.92  
82%  
Power Factor  
(Typical)  
110VAC  
220VAC  
Efficiency (Typical)  
AC Current (max)  
Inrush Current (max)  
Leakage Current  
1.0A @ 100-277VAC Input Full Load  
65A @ 230VAC, 25°C  
0.6mA max @ 277VAC  
Protection  
110°C (Temperature of internal components); shut down, auto recover after the temperature decreases  
Over Temperature (OTP)  
1.2~1.4Vo  
Over Voltage (OVP)  
Short Circuit (SCP)  
Note 2  
Long-term mode, auto recovery  
Environmental Characteristics  
Operating Temperature  
Operating Relative Humidity  
Storage Temperature  
Vibration  
-35°C~70°C  
10% RH to 100% RH  
-40°C~85°C, 5% to 100% RH non-condensing  
10 to 300Hz sweep at constant acceleration of 1.0G(Breadth: 3.5mm) for 1 Hour for each of the perpendicular axes X, Y, Z  
IP67  
Waterproof Rating  
Safety Standards  
Withstand Voltage  
Isolation Resistance  
EMC Emission  
UL8750, Compliance to UL1012 UL935, IEC61347  
L/N-GND: 4kV, L-N: 2kV  
I/P-O/P: >100M Ohms / 500VDC / 25°C / 70% RH  
Compliance to EN55022(CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3  
Compliance to EN61000-3-2, 3 EN61000-4-2, 3, 4, 5, 6, 8, 11, EN61547  
EMC Immunity  
Characteristics  
Life Time  
More than 50,000Hrs (25°C, 80% Load)  
MTBF (MIL-HDBK-217F)  
Dimension (LxWxH)  
Note  
More than 550,000Hrs (25°C, 80% Load)  
199x42.5x34mm  
1. Ripple & Noise: Measured by 20 MHz bandwidth oscilloscope and the output paralleled with a 0.1 uF ceramic capacitor and a 10 uF electrolytic capacitor.  
2. Latch Mode: The power supply shall return to normal operation only after the power is turned on again  
(1) Non-Class 2 output (USR & CNR)  
(2) Class 2 output (USR); Non-Class 2 output (CNR)  
(3) Class 2 output (USR & CNR)  
Page 1 of 3  
P
ualtek  
Q
P C  
35Watts Single Output LED Driver  
PLC-035 D Series  
Electronics Corporation  
DIMMING CONTROL  
The dimmer control may be operated from an input signal of 1 – 10 Vdc.  
Vout (-)  
Black  
AC/L  
LED LAMP  
Vout (+)  
White  
AC/N  
AC/G  
PLC-035SXXXD  
DIM+ (RED)  
Yellow/Green  
1-10V  
GND  
1-10Vdc  
V
DIM- (BLACK)  
Implementation: DC Input  
Io/Ir Vs Vdim  
100%  
80%  
60%  
40%  
20%  
0%  
0
1
2
3
4
5
6
7
8
9
10 11  
Vdim(V)  
Notes:  
1. Io is actual output current and Ir is rated current.  
2. If the dimming function is not used, please short 10 V output pin (Black) and 1-10 V input pin(Red).  
The output current is about 92% Ir when the 1-10V input pin is ꢀoating.  
3. For the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold  
(approx. 50% of the max. output voltage for any given model).  
4. The dimming voltage can be tuned down to less than 1V, and the output current will be decreased to about  
10% Ir; but the connected LEDs may ꢀicker. Keeping dimming voltage greater than 1V is strongly recommended.  
5. Do not connect the GND of dimming to the output; otherwise, the LED driver will not work normally.  
www.qualtekusa.com  
ISO-9001 Company  
Page 2 of 3  
P
ualtek  
Q
P C  
35Watts Single Output LED Driver  
PLC-035 D Series  
Electronics Corporation  
UNIT: mm  
MECHANICAL SPECIFICATIONS  
DIMMING  
RED (V+)  
BLACK (V-)  
AC INPUT (18AWG/3C SJOW)  
BLACK (AC L)  
WHITE (AC N)  
YELLOW/GREEN (GND)  
DC OUTPUT (18AWG/2C SJOW)  
WHITE (V+)  
BLACK (V-)  
Ambient Temperature vs.Load  
Derating Curve  
100  
80  
60  
40  
20  
0
100  
80  
60  
40  
20  
0
-35  
-20  
-5  
10  
25  
40  
55  
70  
90  
120  
150  
180  
210  
240  
270  
300  
330  
Ambient Temperature(°C)  
Input Voltage(V)  
www.qualtekusa.com  
ISO-9001 Company  
Page 3 of 3  

相关型号:

PLC-035S070

35Watts Single Output LED Driver
QUALTEK

PLC-035S070D

35Watts Single Output LED Driver
QUALTEK

PLC-035S105

35Watts Single Output LED Driver
QUALTEK

PLC-035S105D

35Watts Single Output LED Driver
QUALTEK

PLC-035S140

35Watts Single Output LED Driver
QUALTEK

PLC-035S140D

35Watts Single Output LED Driver
QUALTEK

PLC-035S175

35Watts Single Output LED Driver
QUALTEK

PLC-035S175D

35Watts Single Output LED Driver
QUALTEK

PLC-035S210

35Watts Single Output LED Driver
QUALTEK

PLC-035S210D

35Watts Single Output LED Driver
QUALTEK

PLC-035S245

35Watts Single Output LED Driver
QUALTEK

PLC-035S245D

35Watts Single Output LED Driver
QUALTEK