MCR100JZHF12R3 [ROHM]
RES,SMT,RUTHENIUM OXIDE,12.3 OHMS,200WV,1% +/-TOL,-100,100PPM TC,2512 CASE;型号: | MCR100JZHF12R3 |
厂家: | ROHM |
描述: | RES,SMT,RUTHENIUM OXIDE,12.3 OHMS,200WV,1% +/-TOL,-100,100PPM TC,2512 CASE |
文件: | 总4页 (文件大小:72K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
MCR100
Resistors
Thick Film Chip Resistors
MCR100 (2512 size : 1W)
zFeatures
1) Made of same material as the general purpose chip resistors (MCR10 / 18).
2) Highly reliable chip resistor
Ruthenium oxide dielectric offers superior resistance to the elements.
3) Electrodes not corroded by soldering
Suitable for re-flow soldering.
4) ROHM resistors have approved ISO9001- / ISO/TS 16949- certification.
Design and specifications are subject to change without notice. Carefully check the specification sheet supplied with
the product before using or ordering it.
zRatings
Item
Rated power
Conditions
Specifications
1W at 70°C
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70°C.
100
80
60
40
20
0
−55
0
70
100 125
AMBIENT TEMPERATURE (°C)
Fig.1
Rated voltage
The voltage rating is calculated by the following equation. If the value
obtained exceeds the limiting element voltage, the voltage rating is
equal to the maximum operating voltage.
E: Rated voltage (V)
P: Rated power (W)
R: Nominal resistance (Ω)
E = P × R
200V
Limiting element voltage
Nominal resistance
See Table 1.
Operating temperature
−55°C to +125°C
Table 1
Jumper type
Resistance range
(Ω)
Resistance temperature coefficient
Resistance
Max. 50mΩ
4A
Resistance tolerance
(ppm / °C)
Rated current
F ( 1%)
J ( 5%)
10
≤
R
≤
82k
(E24,96)
(E24)
100
Operating temperature
−55°C to+125°C
1.0
≤R
<
2.0
500 350
500
2.2
≤R<9.1
(E24)
10
≤
R
<
22
100k
(E24)
350
24≤
R
≤
(E24)
200
•Before using components in circuits where they will be exposed to transients such as pulse loads (short-duration, high-level loads), be certain to evaluate the
component in the mounted state. In addition, the reliability and performance of this component cannot be guaranteed if it is used with a steady state voltage that
is greater than its rated voltage.
Rev.C
1/3
MCR100
Resistors
zCharacteristics
Item
Guaranteed value
Resistor type Jumper type
J : 5% Max. 50mΩ
Test conditions (JIS C 5201-1)
JIS C 5201-1 4.5
Resistance
F : 1%
Variation of resistance
with temperature
JIS C 5201-1 4.8
Measurement : −55 / +25 / +125°C
See Table.1
JIS C 5201-1 4.13
Rated voltage (current) ×2.5, 2s.
Maximum Overload Voltage : 400V
Overload
(2.0%+0.1Ω)
Max. 50mΩ
A new uniform coating of minimum of
95% of the surface being immersed
and no soldering damage.
JIS C 5201-1 4.17
Rosin·Ethanol (25%WT)
Soldering condition : 235 5°C
Duration of immersion : 2.0 0.5s.
Solderability
(1.0%+0.05Ω)
No remarkable abnormality on the appearance.
Max. 50mΩ
JIS C 5201-1 4.18
Soldering condition : 260 5°C
Duration of immersion : 10 1s.
Resistance to
soldering heat
(1.0%+0.05Ω)
(3.0%+0.1Ω)
Max. 50mΩ
JIS C 5201-1 4.19
Test temp. : −55°C to +125°C 5cyc
Rapid change of
temperature
Max. 100mΩ
JIS C 5201-1 4.24
40°C, 93%RH
Test time : 1,000h to 1,048h
Damp heat, steady state
(3.0%+0.1Ω)
Max. 100mΩ
JIS C 5201-1 4.25.1
Rated voltage (current), 70°C
1.5h : ON − 0.5h : OFF
Test time : 1,000h to 1,048h
Endurance at 70°C
(3.0%+0.1Ω)
(1.0%+0.05Ω)
(1.0%+0.05Ω)
Max. 100mΩ
Max. 50mΩ
Max. 50mΩ
JIS C 5201-1 4.25.3
125°C
Endurance
Test time : 1,000h to 1,048h
JIS C 5201-1 4.29
23 5°C, Immersion cleaning, 5 0.5min.
Solvent : 2-propanol
Resistance to solvent
JIS C 5201-1 4.33
Bend strength of
the end face plating
Without mechanical damage such as breaks.
zDimensions (Unit : mm)
1
0.6 0.25
2
No.
Material
Resistive element (Oxide metal thick film)
Silver thick film electrode
3
1
2
3
4
5
6
0.6 0.25
4
6.3 0.15
Nickel electrode
Sn electrode
5
Alumina substrate
Overcoating (glass)
6
Rev.C
2/3
MCR100
Resistors
zPackaging
Reel
Taping
P
0
P2
D0
φ
A
B
D
K
A0
P1
C
(Unit : mm)
Label
W
F
E
A
0
B0
EIAJ ET-7200B compliant
12.0 0.3
5.5 0.05
1.75 0.1
3.5 0.2
6.7 0.2
K
(Unit : mm)
D
A
B
C
D0
P
0
P
1
P2
+0
−1.5
+1
0
+1.0
−0
+0.1
0
φ180
φ13 0.2
φ60
4.0 0.1
4.0 0.1
2.0 0.05
Max. 1.1
13
φ1.5
zPart No. Explanation
M C R 1 0 0 J Z H
J
Part No.
Resistance tolerance Nominal resistance
F
1%
Resistance code, 3 or 4 digits.
000 denotes jumper type.
J
5%
Resistance
tolerance
Resistance
code
J is also used
for jumper
F
J
:
:
4 digits
3 digits
Packaging Specifications Code
Resistance tolerance
J( 5%) F( 1%)
Part No.
Code
JZH
Packaging specifications
Embossed tape (4mm Pitch)
Reel
Basic ordering unit (pcs)
,
4 000
MCR100
φ180mm (7in.)
Reel (
: Standard product
φ180) : JEITA ET-7200B
Rev.C
3/3
Appendix
Notes
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document are no antiradiation design.
The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level
of reliability and the malfunction of which would directly endanger human life (such as medical
instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers
and other safety devices), please be sure to consult with our sales representative in advance.
It is our top priority to supply products with the utmost quality and reliability. However, there is always a chance
of failure due to unexpected factors. Therefore, please take into account the derating characteristics and allow
for sufficient safety features, such as extra margin, anti-flammability, and fail-safe measures when designing in
order to prevent possible accidents that may result in bodily harm or fire caused by component failure. ROHM
cannot be held responsible for any damages arising from the use of the products under conditions out of the
range of the specifications or due to non-compliance with the NOTES specified in this catalog.
Thank you for your accessing to ROHM product informations.
More detail product informations and catalogs are available, please contact your nearest sales office.
THE AMERICAS / EUPOPE / ASIA / JAPAN
ROHM Customer Support System
Contact us : webmaster@ rohm.co.jp
www.rohm.com
TEL : +81-75-311-2121
FAX : +81-75-315-0172
Copyright © 2007 ROHM CO.,LTD.
21, Saiin Mizosaki-cho, Ukyo-ku, Kyoto 615-8585, Japan
Appendix1-Rev2.0
相关型号:
MCR100JZHF1300
Fixed Resistor, Metal Glaze/thick Film, 1W, 130ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2512, CHIP
ROHM
MCR100JZHF1301
Fixed Resistor, Metal Glaze/thick Film, 1W, 1300ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2512, CHIP
ROHM
MCR100JZHF13R0
Fixed Resistor, Metal Glaze/thick Film, 1W, 13ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2512, CHIP
ROHM
MCR100JZHF13R3
Fixed Resistor, Metal Glaze/thick Film, 1W, 13.3ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2512, CHIP
ROHM
©2020 ICPDF网 联系我们和版权申明