MCR50JZHF1151 [ROHM]
Fixed Resistor, Metal Glaze/thick Film, 0.5W, 1150ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2010, CHIP;型号: | MCR50JZHF1151 |
厂家: | ROHM |
描述: | Fixed Resistor, Metal Glaze/thick Film, 0.5W, 1150ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2010, CHIP 电阻器 |
文件: | 总4页 (文件大小:154K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Thick Film Chip Resistors
MCR50 (2010 size : 1 / 2W)
zFeatures
1) Made of same material as the general purpose chip resistors (MCR10 / 18).
2) Highly reliable chip resistor
Ruthenium oxide dielectric offers superior resistance to the elements.
3) Electrodes not corroded by soldering
Suitable for re-flow soldering.
4) ROHM resistors have approved ISO9001- / ISO/TS 16949- certification. Design and specifications are subject to change
without notice.
Carefully check the specification sheet supplied with the product before using or ordering it.
zRatings
Item
Conditions
Specifications
0.5W (1 / 2W)
Rated power
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70˚C.
at 70°C
100
80
60
40
20
0
−55
0
70
100 125
155
AMBIENT TEMPERATURE (°C)
Fig.1
Rated voltage
The voltage rating is calculated by the following equation. If the value
obtained exceeds the limiting element voltage, the voltage rating is
equal to the maximum operating voltage.
E: Rated voltage (V)
P: Rated power (W)
R: Nominal resistance (Ω)
E= P × R
Limiting element voltage
200V
See Table 1.
Nominal resistance
Operating temperature
−55°C to +155°C
Table 1
Resistance range
(Ω)
Resistance temperature coefficient
Resistance tolerance
(ppm / °C)
F ( 1%)
J ( 5%)
(E24,96)
(E24)
10
≤
R
≤
180k
100
1.0
≤
R
<
2.0
9.1
500 350
500
Jumper type
2.2
≤
R
<
(E24)
Resistance
Max. 50mΩ
3A
10≤
R
≤
330k
560k
200
(E24)
Rated current
360k
<
R
≤
(E24)
350
−55°C to +155°C
Operating temperature
•Before using components in circuits where they will be exposed to transients such as pulse loads (short-duration, high-level loads), be certain to evaluate the
component in the mounted state. In addition, the reliability and performance of this component cannot be guaranteed if it is used with a steady state voltage that
is greater than its rated voltage.
www.rohm.com
2009.10 - Rev.G
1/3
c
○ 2009 ROHM Co., Ltd. All rights reserved.
MCR50
Data Sheet
zCharacteristics
Guaranteed value
Resistor type Jumper type
J : 5% Max. 50mΩ
Item
Test conditions (JIS C 5201-1)
JIS C 5201-1 4.5
Resistance
F : 1%
Variation of resistance
with temperature
JIS C 5201-1 4.8
Measurement : −55 / +25 / +125°C
See Table.1
JIS C 5201-1 4.13
Rated voltage (current) ×2.5, 2s.
Maximum Overload Voltage : 400V
Overload
(2.0%+0.1Ω)
Max. 50mΩ
A new uniform coating of minimum of
95% of the surface being immersed
and no soldering damage.
JIS C 5201-1 4.17
Rosin·Ethanol (25%WT)
Soldering condition : 235 5°C
Duration of immersion : 2.0 0.5s.
Solderability
(1.0%+0.05Ω)
No remarkable abnormality on the appearance.
Max. 50mΩ
JIS C 5201-1 4.18
Soldering condition : 260 5°C
Duration of immersion : 10 1s.
Resistance to
soldering heat
(1.0%+0.05Ω)
(3.0%+0.1Ω)
Max. 50mΩ
JIS C 5201-1 4.19
Test temp. : −55°C to +125°C 5cyc
Rapid change of
temperature
Max. 100mΩ
JIS C 5201-1 4.24
40°C, 93%RH
Test time : 1,000h to 1,048h
Damp heat, steady state
(3.0%+0.1Ω)
Max. 100mΩ
JIS C 5201-1 4.25.1
Rated voltage (current), 70°C
1.5h : ON − 0.5h : OFF
Test time : 1,000h to 1,048h
Endurance at 70°C
(3.0%+0.1Ω)
(1.0%+0.05Ω)
(1.0%+0.05Ω)
Max. 100mΩ
Max. 50mΩ
Max. 50mΩ
JIS C 5201-1 4.25.3
125°C
Endurance
Test time : 1,000h to 1,048h
JIS C 5201-1 4.29
23 5°C, Immersion cleaning, 5 0.5min.
Solvent : 2-propanol
Resistance to solvent
JIS C 5201-1 4.33
Bend strength of
the end face plating
Without mechanical damage such as breaks.
zDimensions (Unit : mm)
1
0.6 0.25
2
No.
Material
Resistive element (Oxide metal thick film)
Silver thick film electrode
1
3
4
2
3
4
5
6
0.6 0.25
Nickel electrode
Sn electrode
5.0 0.15
5
Alumina substrate
Overcoating (Glass)
6
www.rohm.com
2009.10 - Rev.G
2/3
c
○ 2009 ROHM Co., Ltd. All rights reserved.
MCR50
Data Sheet
zPackaging
Reel
Taping
P
0
P2
D
φ
A
B
D
K
A
0
P1
C
(Unit : mm)
Label
W
F
E
A
0
B0
EIAJ ET-7200B compliant
12.0 0.3
5.5 0.05
1.75 0.1
3.4 0.2
5.6 0.2
K
(Unit : mm)
D
A
B
C
D0
P0
P
1
P2
0
−1.5
+1
0
+1.0
0
+0.1
φ1.5
0
4.0 0.1
4.0 0.1
2.0 0.05
Max. 1.1
φ180
φ13 0.2
φ60
13
zPart No. Explanation
M C R 5 0 J Z H
J
Part No.
Resistance tolerance Nominal resistance
F
1%
Resistance code, 3 or 4 digits.
000 denotes jumper type.
J
5%
Resistance
tolerance
Resistance
code
J is also used
for jumper
F
J
:
:
4 digits
3 digits
Packaging Specifications Code
Resistance tolerance
J( 5%) F( 1%)
Part No.
Code
JZH
Packaging specifications
Embossed tape (4mm Pitch)
Reel
Basic ordering unit (pcs)
,
4 000
MCR50
φ180mm (7in.)
Reel (φ180) : JEITA ET-7200B
: Standard product
www.rohm.com
2009.10 - Rev.G
3/3
c
○ 2009 ROHM Co., Ltd. All rights reserved.
Notice
N o t e s
No copying or reproduction of this document, in part or in whole, is permitted without the
consent of ROHM Co.,Ltd.
The content specified herein is subject to change for improvement without notice.
The content specified herein is for the purpose of introducing ROHM's products (hereinafter
"Products"). If you wish to use any such Product, please be sure to refer to the specifications,
which can be obtained from ROHM upon request.
Examples of application circuits, circuit constants and any other information contained herein
illustrate the standard usage and operations of the Products. The peripheral conditions must
be taken into account when designing circuits for mass production.
Great care was taken in ensuring the accuracy of the information specified in this document.
However, should you incur any damage arising from any inaccuracy or misprint of such
information, ROHM shall bear no responsibility for such damage.
The technical information specified herein is intended only to show the typical functions of and
examples of application circuits for the Products. ROHM does not grant you, explicitly or
implicitly, any license to use or exercise intellectual property or other rights held by ROHM and
other parties. ROHM shall bear no responsibility whatsoever for any dispute arising from the
use of such technical information.
The Products specified in this document are intended to be used with general-use electronic
equipment or devices (such as audio visual equipment, office-automation equipment, commu-
nication devices, electronic appliances and amusement devices).
The Products specified in this document are not designed to be radiation tolerant.
While ROHM always makes efforts to enhance the quality and reliability of its Products, a
Product may fail or malfunction for a variety of reasons.
Please be sure to implement in your equipment using the Products safety measures to guard
against the possibility of physical injury, fire or any other damage caused in the event of the
failure of any Product, such as derating, redundancy, fire control and fail-safe designs. ROHM
shall bear no responsibility whatsoever for your use of any Product outside of the prescribed
scope or not in accordance with the instruction manual.
The Products are not designed or manufactured to be used with any equipment, device or
system which requires an extremely high level of reliability the failure or malfunction of which
may result in a direct threat to human life or create a risk of human injury (such as a medical
instrument, transportation equipment, aerospace machinery, nuclear-reactor controller,
fuel-controller or other safety device). ROHM shall bear no responsibility in any way for use of
any of the Products for the above special purposes. If a Product is intended to be used for any
such special purpose, please contact a ROHM sales representative before purchasing.
If you intend to export or ship overseas any Product or technology specified herein that may
be controlled under the Foreign Exchange and the Foreign Trade Law, you will be required to
obtain a license or permit under the Law.
Thank you for your accessing to ROHM product informations.
More detail product informations and catalogs are available, please contact us.
ROHM Customer Support System
http://www.rohm.com/contact/
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
R0039
A
相关型号:
MCR50JZHF1240
Fixed Resistor, Metal Glaze/thick Film, 0.5W, 124ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2010, CHIP
ROHM
MCR50JZHF1270
Fixed Resistor, Metal Glaze/thick Film, 0.5W, 127ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2010, CHIP
ROHM
MCR50JZHF12R7
Fixed Resistor, Metal Glaze/thick Film, 0.5W, 12.7ohm, 200V, 1% +/-Tol, 100ppm/Cel, Surface Mount, 2010, CHIP
ROHM
©2020 ICPDF网 联系我们和版权申明