GPC130A3 [SLPOWER]
Power Supply Module;
| 型号： | GPC130A3 |
| 厂家： | 
SL Power Electronics |
| 描述： | Power Supply Module |
| 文件： | 总2页 (文件大小：37K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
GPC130 GLOBAL PERFORMANCE SWITCHERS
FEATURES:
• Wide-range AC input 85-264VAC
• 2-year warranty
• Approved to UL1950, IEC950, EN60950 and CSA22.2-
234 L3
• Exceeds FCC and CISPR22 Class B conducted
emissions requirements
• Multiple outputs
• For medical version, see p. 92
marked to LVD
•
No-Load Turn-on/Standby
No degradation of reliability will occur.
SPECIFICATIONS:
AC Input
85-264Vac, 47-63Hz single phase.
Output Noise
0.5% RMS, 1% Pk-Pk, 20MHz bandwidth, differential mode. Measured
with noise probe directly across output terminals of the power supply.
Transient Response
Input Current
Maximum input current at 120Vac, 60Hz with full rated output load: 3.5A
Main output—500µSec typical response time for return to within 0.5% of
final value for a 50% load step change. ∆i/∆t<0.2A/µSec. Maximum
voltage deviation is 3.5%. Startup/shutdown overshoot less than 3%.
Hold-Up Time
20mSec minimum from loss of AC input at full load, nominal line (115Vac).
Output Power
Remote Sense
Provided as a standard feature on output 1.
Voltage Adjustment
Built-in potentiometer adjusts voltage ±5% on outputs 1 & 2.
100W continuous, 165W peak; 130 with 26 cfm air flow. Peak ratings are
for 60 sec. maximum duration, 10% duty cycle. During peak load
condition, output regulation may exceed total regulation limits.
Overload Protection
Reverse Voltage Protection
All outputs protected against inadvertent application of reverse voltage up
to 1 times rated current of the reverse output.
Fully protected against short circuit and output overload. Short circuit
protection is cycling type power limit on outputs 1 & 2; foldback type on
outputs 3 & 4. Recovery after fault is automatic. See output ratings chart
for additional notes or conditions.
Overload Protection
Overvoltage Protection
Factory set to begin power limiting at approximately 170W.
Main outputs: 124% ± 12% typical.
EMI/EMC Compliance
All models include built-in EMI filtering to meet the following emissions
requirements:
Efficiency
70% at full rated load, nominal input voltage, depending on model and
load distribution.
Turn-on Time
Less than 1 second at 120VAC, 25°C (inversely proportional to input
voltage and thermistor temperature).
EMI SPECIFICATIONS
Conducted Emissions
Static Discharge
RF Field Susceptibility
Fast Transients/Bursts
Surge Susceptibility
COMPLIANCE LEVEL
EN55022 Class B; FCC Class B
EN61000-4-2, 6 kV contact, 8 kV air
EN61000-4-3, 3 V/meter
EN61000-4-4, 2 kV, 5 kHz
EN61000-4-5, 1 kV diff., 2 kV com.
Input Protection
Internal AC fuse provided. Designed to blow only if a catastrophic failure
occurs in the unit.
Leakage Current
0.7mA. 254Vac @ 60Hz input.
Inrush Current
Inrush is limited by internal thermistors. Inrush at 240VAC under cold start
conditions will not exceed 34A.
Safety
Approved to UL1950, CSA22.2 No. 234 Level 3, IEC950 and EN60950.
UL file #E135803 commercial; CSA #LR46516 all models. The output(s)
are intended for safety earthed Signal Output and Intermediate Circuits
only. All DC outputs are SELV under normal and single fault conditions.
Temperature Coefficient
0.03%/ºC typical on all outputs.
Environmental
Designed for 0 to 50°C operation at full rated output power; derate
output current and total output power by 2.5% per °C above 50°C. See
Environmental and Packaging Specifications (p. 11) for additional
information.
Power Fail
TTL- or CMOS-compatible output goes low (< 0.5V) 5mSec before
output voltage drops more than 4% below nominal voltage upon loss of
AC power. The signal is factory set to trip on 84 to 94VAC brown-out
depending upon incoming line impedance and distortion. Other settings
are available to the user through adjustment of built-in potentiometer
(consult factory for assistance).
Condor D.C. Power Supplies, Inc./A subsidiary of SL Industries, Inc.
2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 805-486-4565 FAX 805-487-8911 • www.condorpower.com/
•
•
•
26
Output
Output
Output
Total
Model
Output No.
Output
Minimum
Maximum (B)
Maximum (C) Output Peak
Noise P-P
Regulation (A)
GPC130A
1
2
3
4
+5V
+12V
-12V
+12V
3A
0A
0A
0A
16A
5A
1.2A
1.2A
20A
5A
1.2A
1.2A
25A
8A
1.5A
1.5A
50mV
120mV
120mV
120mV
2%
2%
3%
3%
GPC130B
GPC130C
GPC130D
GPC130E
1
2
3
4
+ 5V
+12V
-5V
3A
0A
0A
0A
16A
5A
1.2A
1.2A
20A
5A
1.2A
1.2A
25A
8A
1.5A
1.5A
50mV
120mV
50mV
2%
2%
3%
3%
-12V
120mV
1
2
3
4
+5V
+12V
-15V
+15V
3A
0A
0A
0A
16A
5A
1.2A
1.2A
20A
5A
1.2A
1.2A
25A
8A
1.5A
1.5A
50mV
120mV
150mV
150mV
2%
2%
3%
3%
1
2
3
4
+5V
+24V
-12V
+12V
3A
0A
0A
0A
16A
3.5A
1.2A
1.2A
20A
3.5A
1.2A
1.2A
25A
5A
1.5A
1.5A
50mV
240mV
120mV
120mV
2%
2%
3%
3%
1
2
3
4
+5V
+24V
-15V
+15V
3A
0A
0A
0A
16A
3.5A
1.2A
1.2A
20A
3.5A
1.2A
1.2A
25A
5A
1.5A
1.5A
50mV
240mV
150mV
150mV
2%
2%
3%
3%
A. Total regulation is defined as the maximum deviation from the nominal voltage for all steady-state conditions of initial voltage setting, input line voltage and output load.
B. Unrestricted natural convection cooling.
C. Requires 26cfm moving air.
GPC130 MECHANICAL SPECIFICATIONS:
8.50 [215.90mm]
8.000 [203.20mm]
INPUT:
J1: AMP P.C.B. HEADER P/N 640445-5
PIN 1)
PIN 2)
PIN 3)
AC LINE
N/C
AC NEUTRAL
N/C
AC GROUND
PIN 4)
PIN 5)
3
1
5
TB2
1.278 ± 0.20
MATING CONNECTOR AMP P/N
[32.46 ± 0.51]
J1
1
J3
1
OUT 2
V.ADJ
TB1: 0.375 X 6-32 TERMINAL BLOCK
HOUSING 640250-5
CONTACTS 770522-1
1
TB1
16
PIN 1)
PIN 2)
PIN 3)
AC LINE
AC NEUTRAL
AC GROUND
1
F1
1.944
[49.38mm]
SIGNALS:J2 AMP P.C.B. HEADER P/N 640456-4
PIN 1)
PIN 2)
PIN 3)
PIN 4)
N/C
+ SENSE
- SENSE
POWER FAIL
4.50
8
9
[114.30mm]
T3
16
MATING CONNECTOR AMP P/N 640440-4
OUT1
V.ADJ
J2
1
4
OUTPUT:
6-32 MTG
AMP P.C.B. HEADER P/N 1-640445-6
J3:
(0.125 [3.18mm] MAX SCREW PENETRATION)
4 PLCS
PF ADJ
PIN 1)
PIN 2)
PIN 3)
PIN 4)
PIN 5)
PIN 6)
PIN 7)
PIN 8)
OUTPUT #4
OUTPUT #4
OUTPUT #3
OUTPUT #3
OUTPUT #2
OUTPUT #2
COMMON
PIN 9)
PIN 10)
PIN 11)
PIN 12)
PIN 13)
PIN 14)
PIN 15)
PIN 16)
COMMON
COMMON
COMMON
COMMON
OUTPUT #1
OUTPUT #1
OUTPUT #1
OUTPUT #1
0.25
[6.35mm]
0.12 [3.05mm]
6-32 MTG
4 PLCS
COMMON
XFMR (T3) PROTRUDES
IN THIS AREA ONLY.
2.00
[50.80mm]
MATING CONNECTOR AMP P/N
HOUSING 1-640250-6
CONTACTS 770522-1
1.278 ± 0.20
[32.46 ± 0.51]
TB2: 0.375 X 6-32 TERMINAL BLOCK
PIN 1)
PIN 2)
PIN 3)
PIN 4)
OUTPUT #4
OUTPUT #3
OUTPUT #2
COMMON
PIN 5)
PIN 6)
PIN 7)
PIN 8)
COMMON
COMMON
OUTPUT #1
OUTPUT #1
OPTIONAL COVER AVAILABLE, ORDER P/N 08-30466-1130
OPTION: ADD "-T" SUFFIX TO PART NUMBER FOR
6-32 SCREW TERMINAL BLOCK ON I/O
WEIGHT: 2.3 LBS MAX. [1.05 kg]
TOLERANCES: X.XX=0.030 [0.76mm]
X.XXX=0.010 [0.25mm]
Condor D.C. Power Supplies, Inc./A subsidiary of SL Industries, Inc.
2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 805-486-4565 FAX 805-487-8911
•
•
•
•
www.condorpower.com/
27
相关型号：
©2020 ICPDF网 联系我们和版权申明