GPM41-5 [SLPOWER]
Power Supply Module;
| 型号： | GPM41-5 |
| 厂家： | 
SL Power Electronics |
| 描述： | Power Supply Module 输出元件 |
| 文件： | 总2页 (文件大小：158K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
GPC41 Commercial/GPM41 Medical
41 Watt Global Performance Switchers
FEATURES:
• Ultra small (2.00" x 4.00" x 1.50")
• Wide-range ac input 85-264 Vac
• 2-year warranty
• Conducted EMI exceeds FCC Class B and CISPR 22
Class B (Commercial models) and CISPR 11 Class B
(Medical models)
• Commercial Approved to UL1950, IEC950, EN60950
and CSA22.2-234 L3
• Medical Approved to UL2601-1, IEC601-1
and CSA22.2 No. 601
•
marked to LVD
SPECIFICATIONS:
Ac Input
85-264 Vac, 47-63 Hz single phase.
Input Current
Output Noise
Maximum input current at 120 Vac, 60 Hz with full rated
output load: 1.3 A
0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential
mode. Measured with noise probe directly across output
terminals of the power supply.
Hold-UpTime
20 ms minimum from loss of ac input at full load, nominal
line (115 Vac).
Transient Response
Main output—500 µs typical response time for return to
within 0.5% of final value for a 50% load step change. ∆i/
∆t<0.2 A/µs. Maximum voltage deviation is 3.5%. Startup/
shutdown overshoot less than 3%.
Output Power
40 W continuous, 50 W peak. Peak ratings are for 60 s
maximum duration, 10% duty cycle. During peak load
condition, output regulation may exceed total regulation
limits.
EMI/EMC Compliance
All models include built-in EMI filtering to meet the
following emissions requirements:
Overload Protection
Fully protected against short circuit and output overload.
Short circuit protection is cycling type power limit.
Recovery after fault is automatic. Factory set to begin
power limiting at approximately 55 W. See output ratings
chart for additional notes or conditions.
EMI SPECIFICATIONS
Conducted Emissions GPC41 EN55022 Class B; FCC Class B
Conducted Emissions GPM41 EN55011 Class B; FCC Class B
COMPLIANCE LEVEL
Static Discharge
EN61000-4-2, 6 kV contact, 8 kV air
EN61000-4-3, 3 V/meter
EN61000-4-4, 2 kV, 5 kH
RF Field Susceptibility
Fast Transients/Bursts
Surge Susceptibility
Overvoltage Protection
See output ratings chart.
EN61000-4-5, 1 kV diff., 2 kV com.
Commercial Leakage Current
Efficiency
60 µA single fault; 60 Hz input.
69-77% at full rated load, nominal input voltage, depend-
ing on model.
Commercial Safety
Approved to UL1950, CSA22.2 No. 234 Level 3, IEC950
and EN60950. UL file #E135803 commercial; CSA
#LR46516 all models. The output is intended for safety
earthed Signal Output and Intermediate Circuits only. All
dc outputs are SELV under normal and single fault
conditions.
Turn-onTime
Less than 1 s at 120 Vac, 25°C (inversely proportional to
input voltage).
Input Protection
Requires external ac line fusing. A 2.5 A, 250 V rated fuse
with I2t > 20 is recommended.
Medical Leakage Current
35 µA , 254 Vac 10 Hz input.
Inrush Current
Inrush is limited by internal thermistor. Inrush at 240 Vac
under cold start conditions will not exceed 34 A.
Medical Safety
Approved to UL2601, CSA22.2 No. 601 Level 3, IEC601.
UL file E116994; CSA #LR46516. The output(s) are
intended for safety earthed Signal Output and Intermedi-
ate Circuits only. The output(s) are not acceptable for
patient connection without additional isolation. All dc
outputs are SELV under normal and single fault condi-
tions.
Temperature Coefficient
0.03%/°C typical on all outputs.
Environmental
Designed for 0 to 50°C operation at full rated output
power; derate output current and total output power by
2.5% per °C above 50°C. See Environmental and
Packaging Specifications on next page.
Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033
800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com
28
GPC41 Commercial/GPM41 Medical 41 Watt Single Output
Commercial
Model
Medical
Model
Minimum
Load
Load
Regulation
Initial Setpoint
Tolerance
OVP
Setpoint
Output
5.1 V
Current
6.0 A
Ripple and Noise
1%
GPC41-5
GPM41-5
0.15
0.03
0.03
0.01
0.01
0.75%
0.75%
0.75%
0.75%
0.75%
2%
2%
2%
2%
2%
6.2 ± 0.6 V
14 ± 1.0 V
19 ± 1.5 V
28 ± 2.5 V
34 ± 2.8 V
GPC41-12
GPC41-15
GPC41-24
GPC41-28
GPM41-12
GPM41-15
GPM41-24
GPM41-28
12 V
15 V
24 V
28 V
3.3 A
2.7 A
1.7 A
1.4 A
1%
1%
1%
1%
GPC41/GPM41 MECHANICAL SPECIFICATIONS
Environmental
Operating
Non-operating
Specification
Temperature (A)
Humidity (A)
Shock (B)
See individual specs
0 to 95% RH
-40 to +85oC
0 to 95% RH
40 gpk
A. Units should be allowed to warm up/operate under non-condensing conditions
before application of power.
20 gpk
B. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3
orthogonal axes.Tested for 10 min./axis operating and 1 hr./axis non-operating.
C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal axes,
total 6 shocks.
Altitude
-500 to 10,000 ft
1.5 grms, 0.003 g2/Hz
-500 to 40,000 ft
5 grms, 0.026 g2/Hz
Vibration (C)
Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033
800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com
29
相关型号：
©2020 ICPDF网 联系我们和版权申明