MTC-353-0515 [SLPOWER]
250, 350 WATTS MULTIPLE OUTPUT; 250 , 350瓦多输出型号: | MTC-353-0515 |
厂家: | SL Power Electronics |
描述: | 250, 350 WATTS MULTIPLE OUTPUT |
文件: | 总2页 (文件大小:96K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
2 5 0 , 3 5 0 WATTS
MULTIP LE OUTP UT
MAX-250 MAX-350
MTC-250 MTC-350
MTX-250 MSC-350
Featuring:
• Over 3 watt/in3 power density
• 80% overall efficiency
• Meets international safety agency
requirements
• All outputs regulated ± 1%
• High peak currents for motor
starting
• System air or self-cooling
options
• AC automatic line
selection option
• Available in 24, 28,
or 48 Vdc input
Option C
STANDARD MAX SERIES
MODEL
PWR OUTPUT #1
OUTPUT #2
OUTPUT #3
OUTPUT #4
MAX-254-1205
MAX-353-0512
MAX-354-1205
MAX-354-1212
MAX-354-1224
250
350
350
350
350
+5V @ 35A
+5V @ 50A
+5V @ 50A
+5V @ 50A
+5V @ 50A
+12V @ 8/12A pk
+12V @ 8/12A pk
+12V @ 8/12A pk
+12V @ 8/12A pk
+12V @ 8/12A pk
-12V @ 4A
-12V @ 4A
-12V @ 4A
-12V @ 4A
-12V @ 4A
-5.2V @ 2A
-5.2V @ 2A
12V @ 2A
+24V @ 1.5A
TELECOM MTC SERIES
MODEL
PWR
OUTPUT #1
OUTPUT #2
OUTPUT #3
Option V
MTC-253-0515
MTC-353-0512
MTC-353-0515
250
350
350
+5V @ 30A
+5V @ 45A
+5V @ 45A
+15V @ 4A
+12V @ 6A
+15V @ 5A
-15V @ 4A
-12V @ 6A
-15V @ 5A
The appropriate MTC, MAX, or MTX in
your telecom product gives you the out-
puts you need for ISDN, LAN, and T1
applications and standard voice and data
networks. High-current auxiliary outputs
provide regulation characteristics for prop-
er operation of line drivers, network inter-
faces and RS232-type outputs. Or, use
a 9-inch MSC in your computer-based
product for needed output regulation,
power for 50 Amps of logic and four hard
disk drives.
MASS STORAGE MSC SERIES
MODEL
PWR
OUTPUT #1
OUTPUT #2
OUTPUT #3
MSC-353-0512
350
+5V @ 30A
+12V @ 20/2 A pk
-12V @ 4A
SMALL COMPUTER MTX SERIES
MODEL
PWR
OUTPUT #1
OUTPUT #2
OUTPUT #3
OUTPUT #4
MTX-253-0512
MTX-254-1205
MTX-254-1212
250
250
250
+5V @ 35A
+5V @ 35A
+5V @ 35A
+12V @ 8/12A pk
+12V @ 8/12A pk
+12V @ 8/12A pk
-12V @ 2A
-12V @ 2A
-12V @ 2A
+5V @ 1.5A
+12V @ 2A
And, you can increase power by 40%
as you add peripherals – without
redesigning for a larger power supply –
by upgrading from the MDT 160/220
series.
Check the specifications of these low-
profile, 9-inch switchers that give you
more design freedom.
Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com
2 5 0 , 3 5 0 WATTS
9 ” x 5 ” x 2 .5 ”
MAX, MS C, MTC, MTX
MAX, MSC, MTC, MTX
MAX, MSC, MTC, MTX with Option F
3.4 lbs - 1.5 kgs
3.9 lbs - 1.8 kgs
Dimensions:
Inches
Millimeters
*9.05
229.87
for MTX
SPECIFICATIONS: ALL MODELS
INPUT
AC Input: 90-132 Vac/180-264 Vac, 47 to 63 Hz. User selectable. See option “A” for
automatic line selection. Internally fused for 10 A.
Inrush: Cold start AC current is less than 10 A at 115 Vac and 18 A at 230 Vac. For MTX
models, 10 A at 115 Vac and 20 A at 230 Vac. Limited by thermistor.
Holdup Time: 16 ms minimum after removal of power, at nominal line, full load.
Efficiency: 80% typical.
Option “P”, AC Power Fail: Provides TTL “0” 5 ms before output voltage goes out of
regulation band upon loss of AC power. VMEbus compatible, provides 48 mA sink current
capability. Not available if option “G” is selected.
Option “V”, Fan/Cover Assembly: Low profile, end venting cover with integral ball-bearing
fan.
Brownout Protection: Holds regulation to 85 Vac or 170 Vac.
Consult factory for other available options.
OUTPUT
Adjustability: User adjustable ±5% minimum.
Line & Load Reg: ±1% over AC input range and 0 to 100% load change. Output #1 requires
minimum load of 10%.
Ripple & Noise: Less than 1% p-p or 100 mV, whichever is greater.
Remote Sense (Output #1): Compensates for 250 mV total line drop. Open sense lead
protection.
AC INPUT
FUNCTION
Input Select
115 VAC
230 VAC
CONNECTOR
Short
Line
Open
0.187 Male Fastons
Temperature Coefficient: 0.02% per degree C.
Stability: 0.1% over 8 hours after 30 minutes warm-up.
Transient Response (Output #1): Output voltage returns to within 1% in less than 500 µs for
a 50% load change. Peak transient does not exceed 5%.
TB1- (L)
TB1- (N)
Line 1
Line 2
Barrier strip
#6-32 screws
3/8” centers
Neutral
TB1- (
)
Safety Ground
Safety Ground
Overload Protection: All outputs are protected against overload and short circuit. Automatic
recovery upon removal of fault.
Overvoltage Protection (Output #1): Protects load against power supply induced overvoltage.
Trip point is factory set so that output voltage cannot exceed 136% of nominal.
Remote Inhibit: Contact closure to the negative sense line drops output power to nominal zero.
Reverse Voltage: Protected against reverse voltage up to supply current rating.
DC OUTPUT
FUNCTION
MAX, MTC, MTX
MSC
CONNECTOR
Output #1
Terminal marked +V
Bus bars
#10/32 screws
Terminal marked COM
TB2-3 (+) TB2-2 (+)
Output #2
Output #3
ENVIRONMENTAL
TB2-4 Rtn (Common) TB2-1 Rtn (Common) Barrier strip
#6-32 screws
Thermal Protection: Shuts down power supply if overheated. Automatic recovery.
Temperature Range: 0° to 50°C at full ratings. Derate to half power at 70°C.
Safety Agencies: Most models are approved to UL1950; CSA 22.2 #234; IEC 950 and TÜV
EN60950, Class 1 SELV., CE 72/23/EEC/93/68EEC (low voltage directive).
Conducted RFI: Meets FCC Part 15, Subpart J, Class A; EN55022 Class B; CISPR 22 Class B.
Cooling: 30 CFM required to achieve full ratings.
TB2-5 (–)
TB2-3(–)
3/8” centers
TB2-4 Rtn (Common) TB2-1 Rtn (Common)
Output #4*
TB2-1 (+)
TB2-2 (–)
(If provided)
Output Isolation: Isolated from ground 50 Vdc.
*Rtn connected to common only if output is polarized in product selection chart
OPTIONS:
STATUS AND CONTROL
FUNCTION
LOCATION
NOTES
CONNECTOR
Option “A”, AC Auto-Range: Automatically selects proper AC line voltage range to enable
power operation at either 115 or 230 Vac without user intervention.
Option “C”, Cover: Limits contact with power supply interior.
Option “F”, Fan/Cover Assembly: Cover with integral ball-bearing fan provides proper cooling
to achieve full ratings at 50°C ambient temperature.
J1-1(+ S)
Output #1 Sense
Output #1 Sense Rtn
Reference to J1-2
AMP MTA type
#640456-4 pin
header (locking)
Remote Sense
J1-2 (– S)
J1-3 (PF)
AC Power Fail or
DC Power Good*
Inhibit
Option “G”, DC Power Good: Provides a TTL “1” open collector when output #1 is above
4.6 V nominal. Not available if option “P” is selected.
J1-4 (IH)
Short to J1-2
*Optional function
Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com
相关型号:
MTC-4015-2R
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-2R010U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-2R350U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-2R650U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-POER
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-POER010U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-POER350U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015-POER650U
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
MTC-4015P
Projected Capacitive Multi-Touch Screen with 7H Anti-Scratch Surface, up to 20-point Multi-touch
VECOW
©2020 ICPDF网 联系我们和版权申明