STEVAL-ISA014V1 [STMICROELECTRONICS]

VIPer12A travel adaptor 3.6W output; VIPer12A的旅行充电器输出3.6W
STEVAL-ISA014V1
型号: STEVAL-ISA014V1
厂家: ST    ST
描述:

VIPer12A travel adaptor 3.6W output
VIPer12A的旅行充电器输出3.6W

文件: 总5页 (文件大小:96K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
STEVAL-ISA014V1  
VIPer12A travel adaptor 3.6W output  
Data Brief  
Features  
Switch mode general purpose power supply  
Input: 85 to 264Vac @ 50/60Hz  
Output: 6V @ 600mA  
Output power : 3.6W  
Switching frequency 60kHz  
Current mode control  
65% efficiency  
9V to 40V wide range VDD voltage  
Auxiliary undervoltage lockout with hysteresis  
High voltage start up current source  
STEVAL-ISA014V1  
Overtemperature, overcurrent and overvoltage  
ST Components  
protection.  
VIPer12AS  
Reference design genaral  
description  
SMBY01-200  
The travel adaptor design presented here has  
been made with the aim of minimizing overall cost  
for a secondary voltage and current regulated  
adapter topology widely used in cellular phone  
adapters. Thanks to the VIPer12A low power  
consumption, it is possible to achieve 100mW  
standby power in a wide range of operations, as  
recommended by the "European Commission of  
Energy".  
March 2006  
Rev 1  
1/5  
For further information contact your local STMicroelectronics sales office  
www.st.com  
5
General circuit description  
STEVAL-ISA014V1  
1
General circuit description  
The circuit is a standard fly-back converter with secondary current and voltage regulation  
driving the VIPer12A feedback pin through an optocoupler.  
The power losses are distributed at 6V / 600mA output power as follows:  
400mW in the output diode  
700mW in the VIPer12A  
300mW in the transformer  
380mW in the shunt resistor  
Overall efficiency is 67%.  
If the losses in the shunt resistor are considered as available power, the converter efficiency  
becomes 74%. This is possible by using a secondary controller like ST's TSM101.  
In standby, the demo board consumes less than 100mW at 100Vdc and 120mW at 380Vdc.  
The major contribution to the standby consumption is the VIPer12A own consumption and is  
independent from input voltage.  
2/5  
STEVAL-ISA014V1  
Board schematic  
2
Board schematic  
Figure 1. Scheme  
3/5  
Revision history  
STEVAL-ISA014V1  
3
Revision history  
Table 1.  
Date  
Revision history  
Revision  
Changes  
23-Mar-2006  
1
Initial release.  
4/5  
STEVAL-ISA014V1  
Please Read Carefully:  
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the  
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any  
time, without notice.  
All ST products are sold pursuant to ST’s terms and conditions of sale.  
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no  
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.  
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this  
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products  
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such  
third party products or services or any intellectual property contained therein.  
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED  
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED  
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS  
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.  
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZE REPRESENTATIVE OF ST, ST PRODUCTS ARE NOT DESIGNED,  
AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS,  
NOR IN PRODUCTS OR SYSTEMS, WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR  
SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE.  
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void  
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any  
liability of ST.  
ST and the ST logo are trademarks or registered trademarks of ST in various countries.  
Information in this document supersedes and replaces all information previously supplied.  
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.  
© 2006 STMicroelectronics - All rights reserved  
STMicroelectronics group of companies  
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -  
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America  
www.st.com  
5/5  

相关型号:

STEVAL-ISA019V3

80 W ESBT quasi-resonant wide-range SMPS demonstration board based on the L6565 for 3-phase applications
STMICROELECTR

STEVAL-ISA020V1

3.5 W battery charger demonstration board based on the VIPer12AS-E and TSM101
STMICROELECTR

STEVAL-ISA023V2

Flyback AC-DC converter evaluation board based on the VIPer53-E with 24 W negative output
STMICROELECTR

STEVAL-ISA024V1

20 A step-down DC-DC converter demonstration board with 3.3 Vout and 250 kHz switching frequency, based on the L6725
STMICROELECTR

STEVAL-ISA029V1

Compact power supply for DVD/set top box evaluation board with three Vout (-30 V, 3.3 V, 12 V)
STMICROELECTR

STEVAL-ISA032V1

60 W forward converter demonstration board for fiscal cash register based on the L5991 and STP10NK60Z
STMICROELECTR

STEVAL-ISA033V1

55 W flyback SMPS demonstration board for alarm system based on the L5991 and STP12NK80Z
STMICROELECTR

STEVAL-ISA034V1

10 W 3-phase auxiliary power supply based on the L6565 and STW3N150
STMICROELECTR

STEVAL-ISA036V1

5 W wide range SMPS demonstration board for metering and motor control based on the ESBT® STC04IE170HP
STMICROELECTR

STEVAL-ISA042V2

1.5 A / 3.3 V step-down DC-DC converter demonstration board based on the ST1S03
STMICROELECTR

STEVAL-ISA043V1

1.5 A /1.2 V high frequency synchronous buck converter demonstration board based on the ST1S06
STMICROELECTR

STEVAL-ISA043V2

1.5 A /1.2 V high-frequency synchronous buck converter demonstration board based on the ST1S06
STMICROELECTR