STEVAL-ISA053V1 [STMICROELECTRONICS]

Demonstration board for the PM6680 dual step-down controller with adjustable output voltage for notebook power system; 演示板可调节输出电压的笔记本电脑电源系统的PM6680双通道降压型控制器
STEVAL-ISA053V1
型号: STEVAL-ISA053V1
厂家: ST    ST
描述:

Demonstration board for the PM6680 dual step-down controller with adjustable output voltage for notebook power system
演示板可调节输出电压的笔记本电脑电源系统的PM6680双通道降压型控制器

电脑 控制器
文件: 总4页 (文件大小:189K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
STEVAL-ISA053V1  
Demonstration board for the PM6680 dual step-down controller  
with adjustable output voltage for notebook power system  
Data Brief  
Features  
Constant on-time control allows very fast load  
transients  
6 V to 28 V input voltage range  
5 V auxiliary output voltage  
Accurate current limit with sense resistor  
Adjustable switching outputs  
Lossless current sensing  
Negative current limit  
Soft-start internally fixed at 2.8 ms  
Soft-end for output discharge  
200 kHz / 300 kHz, 300 kHz / 400 kHz, 400 kHz  
/ 500 kHz (5 V / 3 V selectable switching  
frequency)  
STEVAL-ISA053V1  
Selectable pulse skip and no-audible skip  
modes at light loads  
Independent Power Good signals  
Description  
The PM6680 is a dual step-down controller with  
adjustable output voltages for notebook computer  
power systems. The STEVAL-ISA053V1  
demonstration board is designed to test the  
performance of the PM6680 by employing a  
typical application circuit which allows testing of  
all PM6680 device functions. The board features  
two switching sections, with (typically) 1.5 V and  
1.05 V outputs, from a 6 V to 28 V input battery  
voltage. The operating switching frequency of the  
two switching sections is 200 kHz / 300 kHz,  
respectively. Each switching section delivers more  
than 5 A of output current. Moreover, an internal  
linear regulator can provide 5 V @ 100 mA peak  
current.  
September 2008  
Rev 1  
1/4  
For further information contact your local STMicroelectronics sales office.  
www.st.com  
4
Circuit schematic  
STEVAL-ISA053V1  
1
Circuit schematic  
Figure 1.  
Schematic diagram  
3
1
2
2
1
1
2
8
7
6
5
8
7
6
5
3
2
1
3
2
1
4
3
2
1
4
3
2
1
L E S F S E  
P I K S K I  
F E R V  
1 N E  
3
N I  
V
9 1  
8 1  
1 3  
4 2  
2 3  
5 2  
4
5 O D L D O  
C C V  
2 N E  
5
6
7
8
4
3
2
1
4
3
2
5
6
7
8
1
2
3
5
6
7
8
1
2
3
1
1
2
2
1
3
1
2
2/4  
STEVAL-ISA053V1  
Revision history  
2
Revision history  
Table 1.  
Date  
29-Sep-2008  
Document revision history  
Revision  
Changes  
1
Initial release.  
3/4  
STEVAL-ISA053V1  
Please Read Carefully:  
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the  
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any  
time, without notice.  
All ST products are sold pursuant to ST’s terms and conditions of sale.  
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no  
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.  
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this  
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products  
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such  
third party products or services or any intellectual property contained therein.  
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED  
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED  
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS  
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.  
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT  
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING  
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,  
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE  
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.  
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void  
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any  
liability of ST.  
ST and the ST logo are trademarks or registered trademarks of ST in various countries.  
Information in this document supersedes and replaces all information previously supplied.  
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.  
© 2008 STMicroelectronics - All rights reserved  
STMicroelectronics group of companies  
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -  
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America  
www.st.com  
4/4  

相关型号:

STEVAL-ISA055V2

0.7 A / 3.3 V synchronous buck converter with enable function based on the ST1S12XX
STMICROELECTR

STEVAL-ISA056V1

6 rows - 30 mA LEDs driver with boost converter for LCD panels backlight evaluation board based on the PM6600
STMICROELECTR

STEVAL-ISA058V1

5 W single output SMPS demonstration board based on the VIPer17 off-line high voltage converter
STMICROELECTR

STEVAL-ISA062V1

6 W dual output SMPS demonstration board based on the VIPER17
STMICROELECTR

STEVAL-ISA067V1

Dual step-down controller with auxiliary voltages demonstration board based on the PM6681A for industrial system power
STMICROELECTR

STEVAL-ISA069V1

3 A / 1.5 MHz step-down synchronous switching regulator based on the ST1S31 in DFN 3x3 package
STMICROELECTR

STEVAL-ISA070V1

3 A / 1.5 MHz step-down synchronous switching regulator based on the ST1S31 in SO-8 package
STMICROELECTR

STEVAL-ISA071V1

4 W non-isolated, wide input-voltage range SMPS demonstration board based on the VIPER16
STMICROELECTR

STEVAL-ISA076V2

USB compatible battery charger demo board with integrated power switch for Li-Ion/Li-Polymer based on the L6924U
STMICROELECTR

STEVAL-ISA077V1

High efficiency synchronous rectifier step-up converter demonstration board based on the L6920DB
STMICROELECTR

STEVAL-ISA077V2

High efficiency synchronous rectifier step-up converter demonstration board based on the L6920D
STMICROELECTR

STEVAL-ISA079V2

High-efficiency monolithic synchronous step-down regulator based on the L6928
STMICROELECTR