STVVGLNA [STMICROELECTRONICS]

General-purpose, variable-gain, low-noise, RF amplifier for broadcast receiver applications; 通用的,可变增益,低噪声,射频放大器,用于广播接收器的应用
STVVGLNA
型号: STVVGLNA
厂家: ST    ST
描述:

General-purpose, variable-gain, low-noise, RF amplifier for broadcast receiver applications
通用的,可变增益,低噪声,射频放大器,用于广播接收器的应用

射频放大器
文件: 总4页 (文件大小:79K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
STVVGLNA  
General-purpose, variable-gain, low-noise, RF amplifier  
for broadcast receiver applications  
Data brief  
Features  
75-Ω single-ended input impedance  
75-Ω single-ended or 150-Ω differential output  
impedance  
Dual differential or single-ended outputs  
Single 3.3-V DC supply  
Input frequency range 50 to 2150 MHz  
Fully integrated RF AGC with power monitoring  
Low external component count  
Package  
Low power consumption (145 mW typical)  
Temperature range -35 °C to 85 °C  
Compatible with 5-V and 3.3-V I2C bus  
I2C bus control (option)  
VFQFPN-16L 3x3x0.85 mm3 with exposed pad  
down (EPD)  
Environmentally friendly packaging, RoHS  
(2002/95/EC) compliant.  
Four selectable I2C addresses C8,CA,CC,CE  
Description  
Applications  
The STVVGLNA is a general-purpose, low-noise  
amplifier with a gain range of -17 dB to +15 dB. Its  
gain is regulated either autonomously by an  
integrated AGC loop or by software control.  
Satellite set-top boxes  
SMATV RF accessories  
LNBs  
DVB-T active indoor antennas  
It can be used, for example, as an input amplifier  
for a satellite set-top box.  
Figure 1.  
STVVGLNA block diagram  
STVVGLNA  
TV1  
tuner  
DVR  
tuner  
AGC loop  
F
I2C  
VAGCI VAGCO  
SCL  
SDA  
June 2011  
Doc ID 018892 Rev 1  
1/4  
For further information contact your local STMicroelectronics sales office.  
www.st.com  
4
Introduction  
STVVGLNA  
1
Introduction  
The STVVGLNA is a front-stage amplifier designed for set-top boxes. It has high input  
power dynamic range to allow the optimization of sensitivity and linearity requirements.  
The STVVGLNA has several operating modes suitable for different signal conditions:  
automatic wide-band mode, internal AGC (the default mode)  
semi-automatic wide-band mode, internal AGC  
fixed gain mode, no AGC  
variable gain with external AGC (driven by demodulator, for example)  
The mode of operation is programmable via the I2C bus.  
The STVVGLNA also provides a RF-signal-level indication which may be interrogated via  
the I2C bus. This is useful for installation and status information.  
At power-on, the STVVGLNA starts in automatic and autonomous AGC mode so that it can  
operate in satellite set-top boxes, LNBs or SMATV accessories without any software  
assistance.  
Features  
Benefits  
Active amplitude compensation and  
balanced/differential operation.  
Simplified RF layout and increased robustness to  
interference.  
Four AGC/Gain programmable operating  
modes.  
Flexible AGC strategy.  
Programmable via I2C bus.  
The device can be µP controlled.  
Wide range of input frequencies.  
Applications range from satellite receivers down to  
VHF antenna amplifiers.  
Low component count plus tiny package with  
exposed pad.  
Small BOM and minimal use of PCB area.  
Pre programmed automatic wide-band  
internal AGC mode.  
No micro processor is required if the STVVGLNA is  
to be used in default mode.  
2/4  
Doc ID 018892 Rev 1  
STVVGLNA  
Ordering information  
2
Ordering information  
Table 1.  
Device summary  
Temperature range  
Order code  
Package  
Packaging  
STVVGLNA  
-35 to 85 °C  
-35 to 85 °C  
VFQFPN-16L EPD  
VFQFPN-16L EPD  
Tray  
Reel  
STVVGLNAT  
3
Revision history  
Table 2.  
Date  
01-Jun-2011  
Document revision history  
Revision  
Changes  
1
Initial release.  
Doc ID 018892 Rev 1  
3/4  
STVVGLNA  
Please Read Carefully:  
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the  
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any  
time, without notice.  
All ST products are sold pursuant to ST’s terms and conditions of sale.  
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no  
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.  
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this  
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products  
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such  
third party products or services or any intellectual property contained therein.  
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED  
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED  
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS  
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.  
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT  
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING  
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,  
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE  
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.  
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void  
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any  
liability of ST.  
ST and the ST logo are trademarks or registered trademarks of ST in various countries.  
Information in this document supersedes and replaces all information previously supplied.  
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.  
© 2011 STMicroelectronics - All rights reserved  
STMicroelectronics group of companies  
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -  
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America  
www.st.com  
4/4  
Doc ID 018892 Rev 1  

相关型号:

STW-00-050-1111-201

Single Color LED Display Cluster, White
DIALIGHT

STW-00-050-1111-301

Single Color LED Display Cluster, White
DIALIGHT

STW-00-070-1111-212

DuroSite LED Area Light
DIALIGHT

STW-00-070-1111-312

DuroSite LED Area Light
DIALIGHT

STW-00-150-1111-212

DuroSite LED Area Light
DIALIGHT

STW-00-150-1111-312

DuroSite LED Area Light
DIALIGHT

STW-00-250-1111-212

DuroSite LED Area Light
DIALIGHT

STW-00-250-1111-312

DuroSite LED Area Light
DIALIGHT

STW0Q14A

Pb-Free Reflow soldering application RoHS copliant
SEOUL

STW10NA50

N - CHANNEL ENHANCEMENT MODE FAST POWER MOS TRANSISTOR
STMICROELECTR

STW10NB60

N - CHANNEL 600V - 0.69ohm - 10A - TO-247 PowerMESH MOSFET
STMICROELECTR

STW10NC60

N-CHANNEL 600V - 0.6ohm - 10A - TO-247/ISOWATT218 PowerMesh⑩II MOSFET
STMICROELECTR