NTDM-4HS-110-72 [TECHNOLOGY]
N1 REDUNDANT HOT SWAP POWER SYSTEMS;
| 型号： | NTDM-4HS-110-72 |
| 厂家： | 
Technology Dynamics |
| 描述： | N1 REDUNDANT HOT SWAP POWER SYSTEMS |
| 文件： | 总2页 (文件大小：180K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
APPLIED POWER CONVERSION
Division of
TECHNOLOGY DYNAMICS INC.
NTDM-4HS SERIES
1500W-12,000W
N+1 REDUNDANT HOT SWAP POWER SYSTEMS
11.50” x 19” x 16.25”
APPLICATIONS
The NTDM-4HS Series of Hot Swap Rack
Power Supply systems offer (N+1) redundant
or high power paralleled outputs of 4 modules
per enclosure. This series is especially suitable
for critical telecom and wireless systems or
where bulk power is required. Modules may
be removed while system is active for ease
of replacement resulting in no down time.
STANDARD FEATURES
• MTBF > 150.000 Hours
• LED Indicators (Each Module):
Output Power Good; Input Power Good
• Tightly Regulated
SPECIFICATIONS
ELECTRICAL:
• Equipped with Isolation
Diodes for Redundancy/Parallel Operation
• Circuit Breaker Input
• OV/OL/OT Protection Main Output
• Floating Connectors for Hot Swap Insertion
• Remote Sensing Post Isolation Diodes
• Sturdy Fold Down Handle
Input:
(1500W) Module 85-132 - 175-265VAC, 47-63 Hz
(2000-3000W) Module 220VAC 1Phase or 115/208 3Phase
Regulation: Line ± .3%
Load ± 2%
Ripple: 1% Peak to Peak, Not to Exceed 200mV
Efficiency: 80% Typical
• Circular Input Connector MS-3102
Hold Up Time: 20ms Min.
In Rush Current: 60A max ½ Cycle/Module
Protections: OV,OL & OT
AVAILABLE OPTIONS
• Power Factor Correction
• Militarized Version: MIL-STD-810
• Low Voltage Battery Disconnect
(LVBD) for Battery Back-Up Operation
MECHANICAL & ENVIRONMENTAL
Operational Temperature: 0˚C to + 50˚C Standard
-40˚C to + 60˚C Optional
Storage Temperature: 0˚C to + 85˚C
Cooling: Internal DC Fan
Weight: Modules (15 lbs) Each, Rack (24.5 lbs)
Size: 11.50”(H) x 19” Std. Rack (W) x 16.25” (L)
•
Terminal Block Covers
• 3 Phase Input
•
400 Hz Operation
• IEEE Communications Port
• Militarized Version: MIL-STD-461
AS9100
Design Excellence since 1976!
Certificate No: US008267-1
MODEL SELECTION
1500 WATT MODULES
2000 WATT MODULES
3000 WATT MODULES
2500 WATT MODULES
Max. Volts/Amps
System Model
4 Modules
Max. Volts/Amps
Per Module
System Model
4 Modules
Max. Volts/Amps
Per Module
System Model
4 Modules
Max. Volts/Amps
Per Module
System Model
4 Modules
Per Module
12V@125A
15V@100A
42V@62A
28V@54A
48@31A
NTDM-4HS-12-500
NTDM-4HS-15-400
NTDM-4HS-24-248
NTDM-4HS-28-216
NTDM-4HS-48-124
NTDM-4HS-110-56
CONSULT FACTORY
CONSULT FACTORY
CONSULT FACTORY
24V@125A
28V@107A
48V@62A
110V@27A
24V@83A
28V@71A
48V@41A
110V@18A
NTDM-4HS-24-332
NTDM-4HS-28-284
NTDM-4HS-48-164
NTDM-4HS-110-72
24V@104A
28V@89A
48V@52A
110V@22A
NTDM-4HS-24-416
NTDM-4HS-28-356
NTDM-4HS-48-208
NTDM-4HS-110-88
NTDM-4HS-24-500
NTDM-4HS-28-428
NTDM-4HS-48-248
NTDM-4HS-110-108
110V@14A
6000W PARALLEL/4500 REDUNDANT
8000W PARALLEL/6000 REDUNDANT
12.000W PARALLEL/9000W REDUNDANT
10.000W PARALLEL/7500 REDUNDANT
Note: Model information assumes a fully populated rack (4 modules).
SFX.
Options Designations
Terminal Block Covers
Ruggedized/Militarized
Battery Back-Up
Low Voltage Battery Disconnect
-TBI
The LVBD module adds a new dimension to
battery backup power supplies. The power
supply simultaneously charges the battery and
powers the load. If the AC power fails, the
battery continues to support the load. However,
when the battery voltage drops below a pre-
determined level, the LVBD module disconnects
the battery from the load, thereby protecting the
battery from the damaging effects of complete
discharge.
-MIL
-LVBD
-PFC
-3PH
-IEEE
-4HZ
-EMI
Power Factor Correction
3 Phase Input
IEEE 488 Port
400 Hz Operation
Additional EMI Filtering
Meter (Volt/Amp)
-MTR
MECHANICAL OUTLINE
AIR ENTAKE
FROM THIS SIDE
REAR VIEW
SIDE VIEW
A3
A1
PERFOR
AIR FLOW
HANDLE
4" WIDE
42.93mm
1.690"
A4
A2
45°
115.06mm/4.530"
LOGIC CONNECTOR
217.55mm/8.565"
262.00mm/10.315"
358.65mm/14.120"
FRONT VIEW
482.60mm/19.00"
215.90mm
8.5"
143.92mm
5.67"
291.08mm
11.460"
14.22mm
0.56"
71.96mm
2.83"
37.60mm/1.48"
6.86mm
0.278"
461.01mm
18.150"
Rev. A
TECHNOLOGY DYNAMICS INC.
100 School Street, Bergenfield, NJ 07621
Phone: (201) 385-0500, Fax: (201) 385-0702
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.technologydynamicsinc.com
相关型号：
©2020 ICPDF网 联系我们和版权申明