SW-106PIN [TE]

High Power GaAs SPDT Switch DC - 3 GHz; 高功率砷化镓SPDT开关DC - 3 GHz的
SW-106PIN
型号: SW-106PIN
厂家: TE CONNECTIVITY    TE CONNECTIVITY
描述:

High Power GaAs SPDT Switch DC - 3 GHz
高功率砷化镓SPDT开关DC - 3 GHz的

开关 光电二极管
文件: 总3页 (文件大小:108K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
High Power GaAs SPDT Switch  
DC - 3 GHz  
SW-106, SW-276  
V 2.00  
SW-106 (CR-5)  
Features  
+39 dBm Typ. 1 dB Compression Point,  
-8V Control  
+65 dBm Typ. 3rd Order Intercept, -8V Control  
Insertion Loss of 0.4 dB Typical  
Low Power Consumption  
Fast Switching Speed  
Guaranteed Specifications1  
(–55°C to +85°C)  
SW-106 SW-276  
Frequency Range  
DC - 3.0 GHz  
Insertion Loss  
DC - 0.5 GHz  
DC - 1.0 GHz  
DC - 2.0 GHz  
DC - 3.0 GHz  
0.5 dB 0.4 dB Max  
0.6 dB 0.5 dB Max  
0.8 dB 0.7 dB Max  
1.2 dB 1.0 dB Max  
Isolation  
VSWR  
DC - 0.5 GHz  
DC - 1.0 GHz  
DC - 2.0 GHz  
DC - 3.0 GHz  
34 dB  
32 dB  
20 dB  
15 dB  
37 dB Min  
31 dB Min  
24 dB Min  
19 dB Min  
DC - 0.5 GHz  
DC - 1.0 GHz  
DC - 2.0 GHz  
DC - 3.0 GHz  
1.3:1  
1.5:1  
1.5:1  
1.6:1  
1.3:1 Max  
1.5:1 Max  
1.5:1 Max  
1.6:1 Max  
Operating Characteristics2  
Impedance  
50 Ohms Nominal  
Switching Characteristics  
Trise, Tfall (10% to 90% )  
Ton, Toff (50% CTL to 90%/10% RF)  
Transients (In-Band)  
30 ns Typ  
35 ns Typ  
12 mV Typ  
Input Power for Compression  
0.1 dB  
1.0 dB  
0.9 GHz  
0.9 GHz  
(-5VControl)  
(-8V Control)  
+32.5 dBm +35.5 dBm  
+35.5 dBm +39.5 dBm  
Typ  
Typ  
SW-276 (CR-2)  
Third Order Intercept Point (with two +10 dBm Input Tones)  
0.9 GHz  
0.9 GHz  
(-5V Control)  
(-8V Control)  
+61 dBm Typ  
+65 dBm Typ  
Control Voltages  
Vin Low  
0 to -0.2V @ 20 µA Max  
Vin High  
-5V @ 50 µA Typ to -10V @ 800 µA Max  
1. All specifications apply when operated with bias voltages of 0V for Vin Low  
and -5 to -10V for Vin High, and 50 ohm impedance at all RFports, unless  
otherwise specified.  
2. High power (greater than 1W) handling specifications apply to cold switching  
only. For input powers under 1W hot switching can be used.  
3. Contact the factory for standard or custom screening requirements.  
Ordering Information  
Part Number  
Package  
SW-106 PIN  
SW-276 PIN  
Surface Mount  
Ceramic  
For both switches: Bottom of Case is AC Ground  
Dimension in ( ) are in mm.  
Unless Otherwise Noted: .xxx = ± 0.010 (.xx = ± 0.25)  
.xx = ± 0.02 (.x = ± 0.5)  
V 2.00  
Two Tone IP Measurements  
Absolute Maximum Ratings  
3
Absolute Maximum1  
Input Power  
for each tone Intermodulation  
3rd Order  
Second  
Harmonic  
(dBc)  
Parameter  
Bias  
Voltage  
IP  
(dBm)  
3
Max. Input Power  
0.05 GHz  
(dBm)  
Products (dBc)  
+35 dBm  
0, –5V  
0, –6V  
0, –7V  
0, –8V  
+27  
+27  
+27  
+27  
–34  
–49  
–64  
–65  
+44  
+51  
+59  
+59  
-61  
-61  
-63  
-63  
0.5 - 2.0 GHz  
–5V Control  
–8V Control  
–10V Control  
+36 dBm  
+39 dBm  
+40 dBm  
0, –5V  
0, –6V  
0, –7V  
0, –8V  
+28  
+28  
+28  
+28  
–30  
–41  
–52  
–60  
+43  
+48  
+54  
+58  
-58  
-58  
-57  
-57  
Power Dissipation 2,3  
2.0 W  
–12V, +1V  
Control Voltage  
Operating Temperature  
Storage Temperature  
Maximum Junction Temperature  
–55˚C to +125˚C  
–65˚C to +150˚C  
+175˚C  
0, –5V  
0, –6V  
0, –7V  
0, –8V  
+29  
+29  
+29  
+29  
–28  
–34  
–44  
–52  
+43  
+46  
+51  
+55  
-54  
-54  
-54  
-54  
Thermal Resistance2: q  
+50˚C/W  
jc  
1. Operation of this device above any one of these parameters may cause  
permanent damage.  
0, –5V  
0, –6V  
0, –7V  
0, –8V  
+30  
+30  
+30  
+30  
–26  
–32  
–38  
–44  
+43  
+46  
+49  
+52  
-52  
-51  
-51  
-51  
2. T  
= 25˚C, where T  
is the temperature at the bottom  
case  
case  
of the case.  
3. Special consideration must be given to the mounting of the switch to  
minimize the thermal resistance. The bottom of the case should be  
thermally attached to the mounting surface to maintain the junction  
temperature under the absolute maximum rating.  
Truth Table  
Functional Schematics (Top View)  
Control  
Condition of Switch  
RF Common to Each RF Port  
SW-106  
A
B
RF1  
On  
RF2  
Off  
High Low  
Low High  
Off  
On  
Typical Performance  
SW-276  
V 2.00  
Typical Performances (cont'd.)  

相关型号:

SW-106SW-276

High Power GaAs SPDT Switch DC3 GHz
TE

SW-11-04-H-S-300-000-VS

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal,
SAMTEC

SW-11-04-H-S-890-000-VS

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal,
SAMTEC

SW-11-04-T-S-200-000-VS

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal,
SAMTEC

SW-11-04-T-S-250-200

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Solder Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-250-300-VS-P

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-300-000-VS

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal,
SAMTEC

SW-11-04-T-S-350-150

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Solder Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-350-150-VS-P

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-350-200

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Solder Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-350-200-VS

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Surface Mount Terminal, ROHS COMPLIANT
SAMTEC

SW-11-04-T-S-350-300

Board Stacking Connector, 11 Contact(s), 1 Row(s), Male, Straight, Solder Terminal, ROHS COMPLIANT
SAMTEC