TA8227P [UTC]

LOW FREQUENCY POWER AMPLIFIER; 低频功率放大器
TA8227P
型号: TA8227P
厂家: Unisonic Technologies    Unisonic Technologies
描述:

LOW FREQUENCY POWER AMPLIFIER
低频功率放大器

消费电路 商用集成电路 音频放大器 视频放大器 功率放大器 光电二极管
文件: 总9页 (文件大小:184K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
LOW FREQUENCY POWER  
AMPLIFIER  
DESCRIPTION  
The UTC TA8227P is an audio power IC with built-in two  
channels developed for portable radio cassette tape recorder  
with power ON / OFF switch.  
Because of the parts reduction and DIP, space merit is  
remarkable.  
Thermal shut down protection circuit is built in.  
FEATURES  
*Wide operating supply voltage: Vcc=5~12V  
*Low popping noise at power ON  
DIP-12H  
*Best for supply voltage 9V  
*Output power  
Po=2.5W/CH at Vcc=9V, RL=4, f=1kHz, THD=10%  
Po=3.0W/CH at Vcc=9V, RL=3, f=1kHz, THD=10%  
*Soft Clip  
*Built-in Thermal shut-down protection circuit  
*Stand-by Switch  
BLOCK DIAGRAM  
1
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
APPLICATION INFORMATION AND APPLICATION METHOD  
1. Adjustment of voltage gain  
The voltage gain Gv is obtained as follows by R1, R2 and Rf in Fig.1  
When Rf=0Ω  
When Rf=120Ω  
Gv=56.5 dB (Typ.)  
Gv=45 dB (Typ.)  
By increasing Rf, reduction of Gv is possible. However, since the feedback increase is liable to produce  
oscillation, it is recommended to use this at 40dB or over.  
2. Thermal shut-down circuit  
The thermal shut-down circuit is built in for the purpose of preventing the destruction of IC due to the abnormal  
temperature rise when the heat radiation is insufficient.  
The operation temperature is set at radiation Fin temperature 175°C (Typ.)  
At this temperature or over the bias is interrupted to prevent the destruction of IC.  
3. Input stage  
The input circuit of this IC is as shown in fig.2. PNP Tr : Q1 is provided in the input circuit so as to make its usage  
possible without the input coupling capacitor.  
However, at pin 6 and pin 7, max 60mV offset voltage is produced.  
Application after checking volume slide noise is recommended.  
For cutting the volume slide noise, insert the input capacitor: CIN in series to interrupt the DC component.  
2
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
4. Oscillation preventive measures  
For oscillation preventive capacitor C6 and C7 between the output terminal and GND, it is recommended to use  
polyester film capacitor having good characteristics for temperature and for high frequency.  
Since the characteristics of the capacitor is liable to be influenced by the temperature, use this capacitor after the  
temperature test to check the oscillation allowance.  
In addition, as the position of the electrolytic capacitor has a remarkable influence on the oscillation, connect C10  
to Vcc at the nearest possible position from power GND.  
At using this application wth the voltage gain reduced, oscillation is liable to be produced. Apply the capacitor  
after checking enough for its capacity, type and mounting position.  
5. Power ON / OFF switch  
There is power ON / OFF switch at Pin1. However, output power is changed by Pin1 supply voltage when Pin1  
supply voltage is not same Pin12 supply voltage, after referring to attached date, select Pin1 supply voltage.  
6. Input voltage  
When the excessive signal is input, turning-up is produced in the clip waveform. The turning-up point is  
Vin=300mVrms (Typ.) : Vcc=9V, RL=4, f=1kHz : Enough care must be taken for this phenomenon.  
3
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
ABSOLUTE MAXIMUN RATINGS (Ta=25°C)  
PARAMETER  
SYMBOL  
Vcc  
VALUE  
20  
UNIT  
V
Supply Voltage  
Output Current (peak / CH)  
Power Dissipation  
Io (peak)  
Pd  
2.5  
4.0  
A
W
Operating Temperature  
Storage Temperature  
Topr  
Tstg  
-25~75  
-55~150  
°C  
°C  
ELECTRICAL CHARACTERISTICS  
(Ta=25°C, Vcc=9V, RL=4, Rg=600, f=1kHz, unless otherwise specified)  
PARAMETER  
Quiescent Current  
Output Power  
SYMBOL  
ICCQ  
Pout(1)  
Pout(2)  
THD  
TEST CONDITIONS  
Vin=0  
THD=10%  
THD=10%, RL=3Ω  
MIN TYP MAX  
UNIT  
mA  
W
21  
2.5  
3.0  
0.2  
45  
45  
2.0  
43  
Total Harmonic Distortion  
Voltage Gain  
Pout=0.4W/CH  
Rf=120,Vout=0.775Vrms (0 dBm)  
1.0  
47  
%
dB  
Gv1  
Gv2  
Rin  
Rf=0, Vout=0.775Vrms (0 dBm)  
56.5  
30  
Input Impedance  
Output Noise Voltage  
Ripple Rejection Ratio  
Cross Talk  
Input Offset Voltage  
Standby Current  
kΩ  
mVrms  
dB  
dB  
mV  
Vno  
R.R.  
C.T  
V6, V7  
1stb  
Rg=10k,BW=20Hz~20kHz  
Rg=600, fripple=100Hz  
Rg=600,Vout=0.775Vrms (0 dBm)  
0.3  
-52  
-50  
30  
1.0  
60  
Sw1:OFF  
1
µA  
TYP. DC VOLTAGE OF EACH TERMINAL (Vcc=9V, Ta=25°C )  
TERMINAL NO.  
DCVOLTAGE(V)  
1
2
3
4
5
6
7
8
0.7  
9
5.0  
10  
8.7  
11  
4.5  
12  
Vcc  
Vcc  
4.5  
8.7  
GND  
0.7  
0.03  
0.03  
4
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
TEST CIRCUIT  
Note 1: This IC can be used without coupling capacitor (CIN). If volume slide noise noise occurred by input offset  
voltage is undesirable, it needs to use the capacitor (CIN).  
Note 2: The condenser between the pin4 and the GND (C11) is for reducing pop noise when the power ON / OFF  
switch (SW1) is set to ON / OFF.  
5
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
6
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
7
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
8
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  
UTCTA8227P LINEAR INTEGRATED CIRCUIT  
PACKAGE DIMENSION  
Remark: The “” means quality inspection range.  
UTC assumes no responsibility for equipment failures that result from using products at values that  
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or  
other parameters) listed in products specifications of any and all UTC products described or contained  
herein. UTC products are not designed for use in life support appliances, devices or systems where  
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in  
whole or in part is prohibited without the prior written consent of the copyright owner. The information  
presented in this document does not form part of any quotation or contract, is believed to be accurate  
and reliable and may be changed without notice.  
9
UTC UNISONIC TECHNOLOGIES CO., LTD.  
QW-R107-011,B  

相关型号:

TA8229

LOW FREQUENCY POWER AMPLIFIER
UTC

TA8229(14HSIP)

Audio Amplifier, 2 Func, Bipolar
UTC

TA8229(15HSIP)

Audio Amplifier, 2 Func, Bipolar
UTC

TA8229K

LOW FREQUENCY POWER AMPLIFIER
TOSHIBA

TA8231

42W BTL x 2CH AUDIO POWER IC
TOSHIBA

TA8231L

42W BTL x 2CH AUDIO POWER IC
TOSHIBA

TA8231LQ

42W BTL 】 2CH Audio Power IC
TOSHIBA

TA8231LQ_06

42W BTL 】 2CH Audio Power IC
TOSHIBA

TA8232F

BATTERY CHARGER IC
TOSHIBA

TA8232P

BATTERY CHARGER IC
TOSHIBA

TA8233AH

30W BTL x 2CH AUDIO POWER AMPLIFIER
TOSHIBA

TA8233BH

30W BTL X 2ch Audio Power Amplifier
TOSHIBA