U74LVC2G07 [UTC]
BUFFERS WITH OPEN-DRAIN OUTPUTS; 缓冲器具有漏极开路输出型号: | U74LVC2G07 |
厂家: | Unisonic Technologies |
描述: | BUFFERS WITH OPEN-DRAIN OUTPUTS |
文件: | 总5页 (文件大小:189K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
UNISONIC TECHNOLOGIES CO., LTD
U74LVC2G07
CMOS IC
BUFFERS WITH OPEN-DRAIN
OUTPUTS
DESCRIPTION
The U74LVC2G07 provides two non-inverting buffers with
open-drain output and can be connected to other open-drain
outputs to implement active-LOW wired-OR or active-HIGH
wired-AND functions.
This device has power-down protective circuit to preventing
device from destruction when it is powered down.
FEATURES
* Wide Supply Voltage Range From 1.65V To 5.5V.
* Inputs Can Be Driven From Either 3.3V or 5V Devices.
* Low Power Dissipation: Ptot =300mW(Max)
* -24mA Output Drive(VCC=3.0V)
* Power Down Protection
* Latch-Up Performance Exceeds 250mA.
* High Noise Immunity
* Direct Interface With TTL Levels
ORDERING INFORMATION
Ordering Number
Package
SOT-363
Packing
U74LVC2G07G-AL6-R
Tape Reel
MARKING
www.unisonic.com.tw
Copyright © 2010 Unisonic Technologies Co., Ltd
1 of 5
QW-R502-402.A
U74LVC2G07
CMOS IC
PIN CONFIGURATION
FUNCTION TABLE (Each Gate)
INPUT(nA)
OUTPUT(nY)
H
L
Z
L
Note: H = HIGH voltage level
L = LOW voltage level
Z = High-impedance OFF-state
LOGIC DIAGRAM (Positive Logic)
UNISONIC TECHNOLOGIES CO., LTD
2 of 5
QW-R502-402.A
www.unisonic.com.tw
U74LVC2G07
CMOS IC
ABSOLUTE MAXIMUM RATING (unless otherwise specified)
PARAMETER
SYMBOL
VCC
RATINGS
-0.5~6.5
-0.5~6.5
-0.5~6.5
-0.5~6.5
-50
UNIT
Supply Voltage
Input Voltage
V
V
V
VIN
Output Voltage(Active Mode)
VOUT
Output Voltage(Power-Down Mode)
Input Clamp Current(VIN<0)
Output Clamp Current(VOUT<0)
Output Current
VOUT
IIK
V
mA
mA
mA
mA
℃
IOK
-50
IOUT
ICC
TOPR
±50
VCC or GND Current
±100
-40 ~ +125
Operating Ambient Temperature
Storage Temperature
TSTG
-65 ~ +150
℃
Note: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
2. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
3. When VCC =0V(Power-Down Mode),the output voltage can be 5.5V in normal operation.
RECOMMENDED OPERATING CONDITIONS
PARAMETER
SYMBOL
VCC
MIN
1.65
0
0
0
TYP
TYP
MAX
5.5
5.5
Vcc
5.5
UNIT
V
V
Supply Voltage
Input Voltage
VIN
Active Mode
Vcc=0V; Power-Down Mode
Output Voltage
VOUT
V
STATIC CHARACTERISTICS (TOPR =-40℃ to +85℃)
PARAMETER
SYMBOL
TEST CONDITIONS
VCC =1.65V~1.95V
MIN
0.65*VCC
1.7
2.0
0.7* VCC
MAX
UNIT
V
VCC =2.3V~2.7V
VCC =3.0V~3.6V
High-Level Input Voltage
Low-Level Input Voltage
VIH
VCC =4.5V~5.5V
0.35* VCC
0.7
0.8
0.3* VCC
VCC =1.65V~1.95V
VCC =2.3V~2.7V
VCC =3.0V~3.6V
VIL
V
V
VCC =4.5V~5.5V
VCC =1.65V ~ 5.5V, IOL=100μA
VCC =1.65V, IOL=4mA
VCC =2.3V, IOL=8mA
VCC =2.7V, IOL=12mA
0.1
0.45
0.3
Low-Level Output Voltage
VOL
0.4
VCC =3.0V, IOL=24mA
0.55
VCC =4.5V, IOL=32mA
VCC =1.65V ~ 5.5V, VIN=5.5V or 0
0.55
±5
Input Leakage Current
II(LEAK)
IOFF
IQ
±0.1
±0.1
0.1
μA
μA
μA
Power OFF Leakage Current
VCC =0V, VIN or Vo=5.5V
±10
10
Quiescent Supply Current
Additional Quiescent Supply
Current per pin
VCC =5.5V, VIN=VCC or GND, IOUT=0
VCC =2.3V ~ 5.5V, VIN=Vcc-0.6V, Io=0A
5
500
±10
μA
μA
ΔIQ
VCC =5.5V, VIN=VIH or VIL
Vo = VCC or GND
Output OFF-state current
IOZ
±0.1
UNISONIC TECHNOLOGIES CO., LTD
3 of 5
QW-R502-402.A
www.unisonic.com.tw
U74LVC2G07
CMOS IC
DYNAMIC CHARACTERISTICS
PARAMETER
SYMBOL
TEST CONDITION
MIN
TYP
MAX UNIT
TOPR=-40℃ to +85℃(note)
VCC = 1.65 ~ 1.95
VCC = 2.3 ~ 2.7
VCC = 2.7
VCC = 3.0 ~ 3.6
VCC = 4.5 ~ 5.5
1.0
0.5
1.0
0.5
0.5
3.5
2.4
2.3
2.6
1.5
6.7
4.3
4.3
3.7
2.9
Propagation delay from input
(nA) to output(nY)
t
PLZ/tPZL
ns
Note: All typical values are measured at TOPR =25℃ and at Vcc=1.8V, 2.5V, 2.7V, 3.3V and 5.0V respectively.
OPERATING CHARACTERISTICS (TA=25℃)
PARAMETER
Power Dissipation Capacitance Per Gate
Input Capacitance
SYMBOL
CPD
TEST CONDITIONS
VCC=3.3V (Notes 1, 2)
TYP
6.5
2.5
UNIT
pF
pF
CI
C
PD is used to determine the dynamic power dissipation (PD in µW).
Notes: 1.
PD = CPD * Vcc2 * fi * N + Σ(CL *Vcc2* fo)where:
fi = Input Frequency in MHz;
fo= Output Frequency in MHz;
CL= Output Load Capacitance in PF;
VCC = Supply Voltage in Volts;
N= Total Load Switching Outputs.
Σ(CL * Vcc2 * fo)= Sum of Outputs.
The Condition is VIN = GND to Vcc.
2.
UNISONIC TECHNOLOGIES CO., LTD
4 of 5
QW-R502-402.A
www.unisonic.com.tw
U74LVC2G07
CMOS IC
TEST CIRCUIT AND WAVEFORMS
Note 1: CL includes probe and jig capacitance.
VCC
VIN
VCC
VCC
2.7V
3 V
tR / tF
≤2ns
VM
VLOAD
2* VCC
2* VCC
6V
CL
RL
Vx
1.8V±0.15V
2.5V±0.2V
2.7V
VCC/2
VCC/2
1.5V
1.5V
VCC/2
30pF
30pF
50pF
50pF
50pF
1KΩ
VOL + 0.15V
VOL + 0.15V
VOL + 0.3V
VOL + 0.3V
VOL + 0.3V
≤2ns
500Ω
500Ω
500Ω
500Ω
≤2.5ns
≤2.5ns
≤2.5ns
3.3V±0.3V
5V±0.5V
6V
VCC
2* VCC
Note: VΔ= Vx - VoL
VI
VM
VM
nA Input
GND
tPLZ
tPZL
Vcc
VM
nY Output
VOL
Vx
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
5 of 5
QW-R502-402.A
www.unisonic.com.tw
相关型号:
©2020 ICPDF网 联系我们和版权申明