US204XXG-S08-R [UTC]

100mΩ, 1/1.5A HIGH-SIDE POWER SWITCHES WITH FLAG; 为100mΩ , 1 / 1.5A高端电源开关, FLAG
US204XXG-S08-R
型号: US204XXG-S08-R
厂家: Unisonic Technologies    Unisonic Technologies
描述:

100mΩ, 1/1.5A HIGH-SIDE POWER SWITCHES WITH FLAG
为100mΩ , 1 / 1.5A高端电源开关, FLAG

开关 电源开关
文件: 总6页 (文件大小:244K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
UNISONIC TECHNOLOGIES CO., LTD  
US204  
Preliminary  
CMOS IC  
100mΩ, 1/1.5A HIGH-SIDE  
POWER SWITCHES WITH FLAG  
„
DESCRIPTION  
The UTC US204 series are 100mhigh-side power switches.  
There are internal duel low voltage N-Channel MOSFETS which  
whish is ideal all USB applications. These MOSFETS is driven by a  
charge pump circuitry inside, these switches on resistance are as  
low as 100mwhich and meet the drop voltage for USB  
applications.  
SOP-8  
The flag pins output an open-drain fault flag to next controller.  
There’re lots internal special ways for protecting the chip’s  
operation. There are also built-in protection circnits to ensure the  
chips function normally.  
When in hot-plug events, there’s large current which can create  
the upstream voltage droop to match the USB’s voltage droop  
requirements and soft-start for isolating the power source.  
As soon as the die temperature is higher than 130, the internal  
shutdown circuit will work.  
Only when there’s a normal input voltage in the VIN pin, the UVLO  
(under-voltage lockout, 2.1V typ.) can make sure the chip is in the  
off state.  
Because of the requirement of USB power, the fault current  
should be ensured to be less than 1.5A for UTC US204AH/AL and  
1.0A for UTC US204CH/CL.  
„
FEATURES  
* 100m(Typ) N-Channel MOSFET  
* Supply Current:  
Switch On : 60μA (Typ)  
Switch Off : 1μA (Typ)  
* Load Current 1.5A for US204AH/AL and 1.0A for US204CH/CL  
* Input Voltage from 2V ~ 5.5V  
* In Off-State: Output Voltage can be Higher than Input  
„
RDERING INFORMATION  
Ordering Number  
Package  
SOP-8  
Packing  
Tape Reel  
Lead Free  
Halogen Free  
US204XXG-S08-R  
US204XXL-S08-R  
www.unisonic.com.tw  
Copyright © 2011 Unisonic Technologies Co., Ltd  
1 of 6  
QW-R502-601.a  
US204  
Preliminary  
CMOS IC  
„
PIN CONFIGURATION  
„
PIN DESCRIPTION  
PIN NO  
PIN NAME  
GND  
DESCRIPTION  
1
2
3
4
Ground  
VIN  
Power input voltage  
CTL1  
CTL2  
Chip Enable turns on power switch in VOUT1  
Chip Enable turns on power switch in VOUT2  
.
.
5
Over current or over temperature status output, open-drain output, active low, in VOUT2.  
FLG2  
VOUT2  
VOUT1  
6
7
Power-Switch Output, in VOUT2  
Power-Switch Output, in VOUT1  
.
.
8
Over current or over temperature status output,, open-drain output, active low, in VOUT1  
.
FLG1  
UNISONIC TECHNOLOGIES CO., LTD  
2 of 6  
QW-R502-601.a  
www.unisonic.com.tw  
US204  
Preliminary  
CMOS IC  
„
BLOCK DIAGRAM  
UNISONIC TECHNOLOGIES CO., LTD  
3 of 6  
QW-R502-601.a  
www.unisonic.com.tw  
US204  
Preliminary  
CMOS IC  
„
ABSOLUTE MAXIMUM RATING(Ta=25°С, unless otherwise specified)  
PARAMETER  
SYMBOL  
RATINGS  
6.0  
UNIT  
V
Supply Voltage  
VCC  
+2 ~ +5.5 (Note 2)  
-0.3~ +6.0  
0 ~ +5.5 (Note 2)  
6.0  
V
V
CTL  
FLG  
VCTL  
Input/Output Pins  
V
V
FLG  
V
Power Dissipation (Ta=25°С)  
Junction Temperature  
PD  
0.3  
W
150  
TJ  
-20 ~ +100 (Note 2)  
-65 ~ +150  
Storage Temperature  
TSTG  
Notes:1.  
Absolute maximum ratings are those values beyond which the device could be permanently damaged.  
Absolute maximum ratings are stress ratings only and functional device operation is not implied.  
2. The device is not guaranteed to function when it’s beyond its operating conditions.  
„
ELECTRICAL CHARACTERISTICS  
PARAMETER  
SYMBOL  
TEST CONDITIONS  
MIN TYP MAX UNIT  
ENABLE INPUT  
Low  
VIL  
VIH  
VIN=2V~5.5V, Switch OFF  
VIN=2V~5.5V, Switch ON  
VCTL=0V~5.5V  
0.8  
V
V
CTL Threshold  
High  
2.0  
CTL Input Current  
II(CTL)  
0.01  
µA  
UNDER VOLTAGE LOCK  
Under-Voltage Lockout  
Under-Voltage Hysteresis  
SUPPLY CURRENT  
VUVLO  
VIN increasing  
2.1  
0.1  
V
V
VUVLO VIN decreasing  
ISW(ON) Switch on, VOUT=OPEN  
ISW(OFF) Switch off, VOUT=OPEN  
IO(LEAK) VCTL=0V, RLOAD=0ꢀ  
65  
0.1  
0.5  
90  
1
µA  
µA  
µA  
Supply Current  
Output Leakage Current  
1
CURRENT LIMIT  
US204Ax  
1.5  
1.1  
2.0  
1.5  
1.4  
1.0  
2.8  
2.1  
A
A
A
A
Current Limit  
ILIMIT  
ISC FB  
VOUTX=4V  
US204Cx  
US204Ax  
US204Cx  
VOUT=0V, measured prior to  
thermal shutdown  
(
)
Short Circuit Fold-Back Current  
POWER SWITCH  
US204Ax  
US204Cx  
IOUT=1.3A, VIN=5V,Each Channel  
IOUT= 1A, VIN=5V,Each Channel  
10% ~ 90% of VOUT rising  
100 110 mꢀ  
100 110 mꢀ  
Switch ON Resistance  
RDS(ON)  
tON RISE  
(
)
Output Turn-ON Rise Time  
OVER CURRENT FLAG  
FLAG OFF Current  
400  
µs  
I
FLG(OFF)  
FLG  
VFLG =5V  
0.01  
20  
1
µA  
R
FLAG Output Resistance  
I
SINK=1mA  
400  
From fault condition to FLG  
assertion  
FLAG Delay Time  
tD  
5
12  
15  
ms  
THERMAL SHUTDOWN  
Thermal Shutdown Protection  
Thermal Shutdown Hysteresis  
TSD  
130  
20  
TSD  
UNISONIC TECHNOLOGIES CO., LTD  
4 of 6  
QW-R502-601.a  
www.unisonic.com.tw  
US204  
Preliminary  
CMOS IC  
„
TEST CIRCUIT  
RFG  
VIN  
VIN  
FLG  
VFLG  
S1  
A
UTC  
US204  
CI  
VOUT  
Chip  
Enable  
VOUT  
CTL  
GND  
IOUT  
IL  
CO  
RL  
Turn-On & Off Response, Flag Response  
S2  
RFG  
VIN  
FLG  
VFLG  
UTC  
US204  
CI  
VOUT  
VIN  
IOUT  
A
VOUT  
CTL  
GND  
S3  
IL  
CO  
RL  
Current Limit vs. Input Voltage, Inrush Current Response,  
Current Limit Transient Response  
UNISONIC TECHNOLOGIES CO., LTD  
5 of 6  
QW-R502-601.a  
www.unisonic.com.tw  
US204  
Preliminary  
CMOS IC  
„
TYPICAL APPLICATION CIRCUIT  
VCC  
5.0V  
Ferrite  
Bead  
10k  
10k  
33μF  
VBUS  
4.50V 5.25V  
Upstream VBUS  
100mA max  
D+  
+
USB  
Port1  
USB Controller  
UTC US204  
LDO  
OUT  
0.01μF  
33μF  
D-  
VBUS  
D+  
VIN  
GND  
VIN  
FLG1  
VOUT1  
IN  
ON/OFF  
GND  
Overcurrent  
Overcurrent  
0.1μF  
D-  
GND  
CTL1 VOUT2  
1μF  
1μF  
VBUS  
GND  
CTL2  
ON  
FLG2  
GND  
D+  
D-  
+
USB  
Port2  
0.01μF  
33μF  
GND  
DATA  
DATA  
(Two Pair)  
to USB Controller  
UTC assumes no responsibility for equipment failures that result from using products at values that  
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or  
other parameters) listed in products specifications of any and all UTC products described or contained  
herein. UTC products are not designed for use in life support appliances, devices or systems where  
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in  
whole or in part is prohibited without the prior written consent of the copyright owner. The information  
presented in this document does not form part of any quotation or contract, is believed to be accurate  
and reliable and may be changed without notice.  
UNISONIC TECHNOLOGIES CO., LTD  
6 of 6  
QW-R502-601.a  
www.unisonic.com.tw  

相关型号:

US204XXL-S08-R

100mΩ, 1/1.5A HIGH-SIDE POWER SWITCHES WITH FLAG
UTC

US204_15

1/1.5A HIGH-SIDE POWER SWITCHES WITH FLAG
UTC

US205

100mΩ, 2A SLEW RATE CONTROLLED LOAD SWITCH
UTC

US205XG-S08-R

100mΩ, 2A SLEW RATE CONTROLLED LOAD SWITCH
UTC

US205XL-S08-R

100mΩ, 2A SLEW RATE CONTROLLED LOAD SWITCH
UTC

US205_15

2A SLEW RATE CONTROLLED LOAD SWITCH
UTC