TFS120A [VECTRON]

Filter specification; 过滤器规格
TFS120A
型号: TFS120A
厂家: Vectron International, Inc    Vectron International, Inc
描述:

Filter specification
过滤器规格

过滤器 LTE
文件: 总5页 (文件大小:77K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
Filename: tfs120a.doc  
Version 1.2  
04.09.2003  
VI TELEFILTER  
Filter specification  
TFS120A  
1/5  
Measurement condition  
Ambient temperature:  
Input power level:  
Terminating impedance: *  
Input:  
23  
0
°C  
dBm  
1180 || -7,1 pF  
1110 || -7,9 pF  
Output:  
2. Characteristics  
Remark:  
Reference level for the relative attenuation a of the TFS 120A is the insertion loss. The insertion loss a is defined as the insertion loss at the nominal  
rel  
e
frequency f . The centre frequency f is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the  
N
C
insertion loss a . The temperature coefficient of frequency Tcf is valid for both the reference frequency f and the frequency response of the filter on the  
e
c
operating temperature.  
D a t a  
typ. value  
tolerance / limit  
Insertion loss  
a
5,6  
-
dB  
max.  
10,5  
-
dB  
e
(reference level)  
Nominal frequency  
Centre frequency  
fN  
-
120  
MHz  
fC  
120  
MHz  
dB  
-
± 100  
1
Passband  
-
fN  
kHz  
dB  
Pass band ripple  
Relative attenuation  
fN  
0,6  
a
rel  
... fN  
±
100  
1,0  
25,0  
kHz  
0,6  
dB  
max.  
1
dB  
fN  
fN  
±
±
0,6  
1,0  
MHz ... fN  
MHz ... fN  
±
±
MHz  
MHz  
35  
50  
dB  
dB  
min.  
min.  
32,5  
37,5  
dB  
dB  
Group delay  
at fN  
1,8  
µs  
max.  
max.  
3,5  
µs  
Group delay ripple within PB  
60  
ns  
300  
ns  
Operating temperature range  
Storage temperature range  
OTR  
-
-
- 20 °C ... + 85 °C  
- 20 °C ... + 85 °C  
Frequency inversion temperature  
Temperature coefficient of frequency  
35  
°C  
-
-
TC **  
-0,04  
ppm/K²  
f
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values  
only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.  
**) f(Hz) = TC (ppm/K) x (T-T0)² x f (MHz).  
To  
f
Generated:  
Checked / Approved:  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs120a.doc  
Version 1.2  
04.09.2003  
VI TELEFILTER  
Filter specification  
TFS120A  
2/5  
3. Construction and pin connection :  
(all dimensions in mm)  
22,5 Max.  
13 max.  
5,0 max.  
5,6 max.  
0,45 Dia.  
7,62  
2,54 ± 0,2  
6x2,54 = 15,24  
Date-code:  
Year+week  
N
P
R
...  
2001  
2002  
2003  
TFS 120A  
R36  
Date-code  
1
2
7
Pin  
1
Input  
Pin 14  
Input RF Return  
Pin  
Pin  
8
7
Output  
Output RF Return  
Pin 2, 9  
Pakage Ground  
14  
9
8
4. 50 matching network :  
L1  
L2  
8
1
Input  
Output  
SAW  
C1  
50 Ohm  
C2  
50 Ohm  
2,7, 9 ,14  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs120a.doc  
Version 1.2  
04.09.2003  
VI TELEFILTER  
Filter specification  
TFS120A  
3/5  
5. Stability Characteristics  
After the following tests the filter shall meet the whole specification:  
1. Shock:  
500g, 18 ms, half sine wave, 3 shocks each plane;  
DIN IEC 68 T2 - 27  
2. Vibration:  
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;  
DIN IEC 68 T2 - 6  
3. Change of  
temperature:  
25 °C to 55°C / 95% r.H. / 10 cycles  
DIN IEC 68 - 2 – 30 Db  
4. Resistance to  
solder heat (reflow):  
max. 2 times reflow process;  
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs120a.doc  
Version 1.2  
04.09.2003  
VI TELEFILTER  
Filter specification  
TFS120A  
4/5  
6. Air reflow temperature conditions  
1st and 2nd air reflow profile  
Name:  
Temperature: 150 °C - 170 °C  
Time: 60 sec. - 90 sec.  
pre-heating periods  
main-heating periods  
over 200 °C  
20 sec. - 25 sec.  
peak temperature  
255 °C ± 5 °C  
Air reflow profile  
260  
240  
220  
200  
180  
160  
140  
120  
100  
80  
60  
40  
20  
0
0
20  
40  
60  
80  
100  
120  
140  
160  
180  
200  
220  
240  
time / sec.  
Table for temperature vs. time during the air reflow process  
Tolerance of temperatures: ± 5 °C  
time / sec.  
0
10  
20  
30  
40  
50  
60  
70  
80  
90  
100  
110  
120  
130  
temperature / °C  
time / sec.  
140  
150  
160  
170  
180  
190  
195  
200  
205  
210  
215  
220  
230  
240  
temperature / °C  
23  
34  
46  
60  
80  
103  
121  
134  
143  
150  
154  
156  
158  
159  
160  
161  
164  
170  
180  
205  
230  
255  
230  
205  
180  
165  
140  
120  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs120a.doc  
Version 1.2  
04.09.2003  
VI TELEFILTER  
Filter specification  
TFS120A  
5/5  
7. History  
Version  
1.0  
Reason of Changes  
generate specification according to customer requirements  
Name  
Date  
Pfeiffer  
Braun  
08.06.2001  
24.04.2003  
1.1  
change specification to actual format  
change package dimension  
1.2  
typical values and terminating impedance added  
auto format correction of first page  
Pfeiffer  
04.09.2003  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  

相关型号:

TFS120C

Filter specification
VECTRON

TFS120E

Filter specification
VECTRON

TFS121

Filter Specification
VECTRON

TFS121B

Filter specification
VECTRON

TFS1220

Filter specification
VECTRON

TFS1220B

VI TELEFILTER
VECTRON

TFS1220_03

The filter is single ended driven
VECTRON

TFS1237

Filter specification
VECTRON

TFS124

Filter Specification
VECTRON

TFS125A

Filter Specification
VECTRON

TFS125B

Filter Specification
VECTRON

TFS125C

Filter specification
VECTRON