HMJ5-PCB

更新时间:2024-09-18 06:01:44
品牌:WJCI
描述:High Dynamic Range FET Mixer

HMJ5-PCB 概述

High Dynamic Range FET Mixer 高动态范围FET混频器

HMJ5-PCB 数据手册

通过下载HMJ5-PCB数据手册来全面了解它。这个PDF文档包含了所有必要的细节,如产品概述、功能特性、引脚定义、引脚排列图等信息。

PDF下载
The Communications Edge
TM  
HMJ5  
High Dynamic Range FET Mixer  
Product Information  
Functional Diagram  
Product Features  
Product Description  
The HMJ5 is a high dynamic range GaAs FET  
mixer. This active FET mixer realizes a typical  
third order intercept point of +35 dBm at an LO  
drive level of +17 dBm. The HMJ5 comes in a  
low cost, J-Lead package. Typical applications  
xꢀ +35 dBm IIP3  
RF  
LO  
xꢀ No external matching element  
Required  
xꢀ RF 40 - 1000 MHz  
include  
frequency  
up/down  
conversion,  
xꢀ LO 30 - 900 MHz  
modulation and demodulation for receivers and  
transmitters used in communications systems.  
xꢀ IF 5 - 250 MHz  
+3Vdc  
IF  
xꢀ +17 dBm LO Drive Level  
xꢀ +3V at 35mA DC Power Supply  
xꢀ Low Cost Surface Mount J-Lead  
Package  
Function  
IF  
Pin No.  
2
LO  
13  
RF  
+3V  
21  
10  
Ground  
All other pins  
Specifications (1)  
Parameter  
Units  
Min  
Typ  
40 – 1000  
30 – 900  
5 – 250  
7.5  
Max  
Condition  
RF Frequency Range  
LO Frequency Range  
IF Frequency Range  
SSB Conversion Loss  
Noise Figure  
MHz  
MHz  
MHz  
dB  
9.0  
dB  
9.5  
LO-RF Isolation  
LO-IF Isolation  
Input IP3  
RF Return Loss  
LO Return Loss  
IF Return Loss  
Input P1dB  
LO Drive Level  
DC Current at +3V Bias  
dB  
dB  
dBm  
dB  
dB  
20  
24  
31  
28  
30  
35  
11.7  
6.0  
10.9  
+23  
+17  
RF = 900 MHz @ 0 dBm  
dB  
dBm  
dBm  
mA  
35  
60  
Notes:  
1. Test conditions unless otherwise noted: 25 ºC, RF = 905 MHz @ -10 dBm, LO = 900MHz @ +17 dBm, IF = 5 MHz.  
2. Measured in a 50-Ohm system with nominal LO drive in a downconverter application only, unless otherwise specified.  
3. LO frequency must be separated from IF frequency by a minimum of 2 MHz (i.e., | FLO FIF  
|
Absolute Maximum Rating  
Ordering Information  
Parameters  
Operating Case Temperature  
Storage Temperature  
Maximum Input Power  
Rating  
-40 to +85 qC  
-65 to +100 qC  
+25 dBm  
Part No.  
HMJ5  
HMJ5-PCB  
Description  
High Dynamic Range FET Mixer  
Fully Assembled Application Circuit  
Operation of this device above any of these parameters may cause permanent damage.  
Total sum of LO port and RF port power should not exceed 25 dBm.  
Specifications and information are subject to change without notice  
Page 1 of 3 March 2006  
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: sales@wj.com  
Web site: www.wj.com  
The Communications Edge
TM  
HMJ5  
High Dynamic Range FET Mixer  
Product Information  
Typical Performance Data  
Specifications and information are subject to change without notice  
Web site: www.wj.com Page 2 of 3 March 2006  
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: sales@wj.com  
The Communications Edge
TM  
HMJ5  
High Dynamic Range FET Mixer  
Product Information  
Outline Drawing  
Product Marking  
The component will be marked with an  
“HMJ7” designator with  
a
four-digit  
alphanumeric lot number XXXX.  
Tape and reel specifications for this part are  
located on the website in the “Application  
Notes” section.  
ESD Information  
ESD Rating:  
Value:  
Test:  
Standard:  
Class 2  
Passes at 2000 V  
Human Body Model (HBM)  
JEDEC Standard JESD22-A114  
ESD Rating:  
Value:  
Test:  
Standard:  
Class IV  
Passes at 2000 V  
Dimensions are expressed in Inches.  
TOLERANCE .XXX [ .015 .XX [ .02  
Drawing is illustrated at Max dimensions.  
Charged Device Model (CDM)  
JEDEC Standard JESD22-C101  
Mounting Config. Notes  
1. Ground vias are critical for thermal and RF grounding  
considerations.  
2. A minimum of 36 ground vias are required for 14 mil  
FR4 boards.  
3. If your PCB design rules allow, ground vias should be  
placed under the land pattern for better RF and thermal  
performance. Otherwise ground vias should be placed  
as close to the land pattern as possible.  
Land Pattern / Mounting Configuration  
4. Trace width depends on the PCB material.  
Specifications and information are subject to change without notice  
Web site: www.wj.com Page 3 of 3 March 2006  
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: sales@wj.com  

HMJ5-PCB 相关器件

型号 制造商 描述 价格 文档
HMJ7 WJCI High Dynamic Range FET Mixer 获取价格
HMJ7-1 WJCI High Dynamic Range FET Mixer 获取价格
HMJ7-1PCB WJCI High Dynamic Range FET Mixer 获取价格
HMJ7-PCB WJCI High Dynamic Range FET Mixer 获取价格
HMJ8 WJCI High Dynamic Range FET Mixer 获取价格
HMJ8-PCB WJCI High Dynamic Range FET Mixer 获取价格
HMJ8_07 WJCI High Dynamic Range FET Mixer 获取价格
HMJ9 WJCI The Communications Edge 获取价格
HMJ9-PCB WJCI The Communications Edge 获取价格
HMJE13001 HSMC HMJE13001 获取价格

HMJ5-PCB 相关文章

  • Bourns 密封通孔金属陶瓷微调电位计产品选型手册(英文版)
    2024-09-20
    6
  • Bourns 精密环境传感器产品选型手册(英文版)
    2024-09-20
    9
  • Bourns POWrTher 负温度系数(NTC)热敏电阻手册 (英文版)
    2024-09-20
    8
  • Bourns GMOV 混合过压保护组件产品选型手册(英文版)
    2024-09-20
    6