A2SI-SR [ZMD]
Release Notes IC Revision C; 发行说明IC版本C型号: | A2SI-SR |
厂家: | Zentrum Mikroelektronik Dresden AG |
描述: | Release Notes IC Revision C |
文件: | 总4页 (文件大小:20K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
A²SI
Release Notes, IC Revision C
Technical Upgrades in A²SI Revision C
Effected part of the A²SI
Description of modification
UART
The telegram reception under worst case capacitive and worst
case inductive network conditions was improved in response to
suggestions of the technical committee of the AS-International
Association.
Telegram Checker
UART
The digital MAN-code communication channel does now support
a more cost effective two-wire data transfer between the A²SI
and the master control logic. It is not necessary to rely on the
additional ‘Receive_Strobe’ signal, which is supplied at the pa-
rameter port P2 in Master Mode to verify the correctness of the
MAN output signal at the LED port.
Master Mode
The MAN signal is now distinctively disturbed if an erroneous
telegram was detected at the AS-i input. This allows to spare at
least one opto coupler in between the A²SI and the master con-
trol.
Main State Machine
Slave Mode
Communication Watchdog
If running, the communication watchdog will now become turned
off as soon as the volatile slave address register is changed to
zero (0x0). This occurs after the reception of a Delete_Address
call or at a reset of the A²SI.
In all previous revisions, a running communication watchdog
could only be turned off by a reset of the A²SI (reception of Re-
set_Slave call or external reset).
In case the watchdog was running and a master did not submit a
Reset_Slave call prior to an address assignment, the write ac-
cess to the non-volatile E²PROM memory could have been inter-
rupted. Because a data corruption is likely in such an event, the
A²SI resumed to the fail save state of slave address zero (0x0)
and did not respond to the newly assigned address until the ad-
dress assignment call was repeated.
Oscillator
The loop gain of the oscillator was increased to support a
broader variety of 8MHz crystals.
Effected part of the A²SI
Description of modification
Infrared input channel
It appeared the infrared input channel (IRD) was sensitive against
coupled noise in some application circuits. In order to make the
photo current input more robust for a broad variety of designs, the
analog receiver circuit had been changed. This resulted in a
much better performance in terms of noise sensitivity but required
a slightly lower signal sensitivity as well. See the updated Data
Sheet for more information.
Slave Mode
Release Notes, A²SI Revision C, August 28, 2002
ZMD AG
1/4
A²SI
Release Notes, IC Revision C
The replacement of A²SI Revision B with Revision C neither has any impact to required external
components nor requires a change of the external circuitry. The CAP-Pin of an IC of Revision C
shall be connected to a series of one capacitor and one resistor, in the same manner like on Re-
vision B. Suggested values are C=4.7nF, R=430…680 Ohms. See the Data Sheet and the Appli-
cation Notes for more detailed information.
Package Marking
TOP VIEW
BOTTOM
A2SI
ZMD
LLLLLL
C-XXXXYZZ
+
PIN 1
PIN 1
Figure 1: Package Marking
Top Marking: A²SI Product name
ZMD
C-
XXXX
Y
Manufacturer
Revision code marking of A²SI Revision C
Date code (year and week)
Assembly location
ZZ
Traceability
Bottom Marking:
LLLLLL
ZMD Lot Number
The yellow dot indicating pre-programmed Master function is printed at the pin 1 marking Å.
Note: IC Revision A did not have a revision code marking. ICs without a Revision Code are equivalent to
Revision A. Revision B shows “B-“ .
Release Notes, A²SI Revision C, August 28, 2002
ZMD AG
2/4
A²SI
Release Notes, IC Revision C
Ordering Information
Ordering
Code
Description
Operating Tempera- Package Type
ture Range
Device
Marking
Shipping Form
A2SI-ST Standard version
-25°C to 85°C
-25°C to 85°C
-25°C to 85°C
-25°C to 85°C
28-pin SSOP
28-pin SSOP
28-pin SSOP
28-pin SSOP
A²SI
A²SI
Tubes
(47 parts/tube)
of A²SI
A2SI-SR Standard version
Tape-and-Reel
(1500 parts/reel)
of A²SI
A2SI-MT Pre-programmed
A²SI
+ yellow dot
Tubes
(47 parts/tube)
master function
A2SI-MR Pre-programmed
A²SI
Tape-and-Reel
master function
+ yellow dot (1500 parts/reel)
Sales Contacts
Sales Office Long Island
Sales Office Dresden
ZMD America Inc.
201 Old Country Road
Melville, NY 11747
USA
Zentrum Mikroelektronik Dresden AG
Grenzstraße 28
D-01109 Dresden
Germany
Phone +1-631-549-2666
Fax +1-631-549-2882
info@zmda.com
Phone +49-351-8822-310
Fax +49-351-8822-337
sales@zmd.de
Engineering Support
Design Office Dresden
Zentrum Mikroelektronik Dresden AG
Bertolt-Brecht-Allee 22
D-01309 Dresden
Germany
Phone +49-351-31530-86
Fax +49-351-31530-11
asi@zmd.de
Release Notes, A²SI Revision C, August 28, 2002
ZMD AG
3/4
A²SI
Release Notes, IC Revision C
Trademark:
A²SI™ is a trademark of AMI Semiconductor, Inc.
Life Support Policy
ZMD products are not designed, intended, or authorised for use as components in systems intended for surgical implant into the body,
or other applications intended to support or sustain life, or for any other application in which the failure of the ZMD product could
create a situation where personal injury or death may occur.
Components used in life-support devices or systems must be expressly authorised by ZMD for such purpose.
Limited Warranty
The information in this document has been carefully checked and is believed to be reliable. However Zentrum Mikroelektronik Dres-
den (ZMD) makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or
damage of whatever nature resulting from the use of, or reliance upon it. The information in this document describes the type of com-
ponent and shall not be considered as assured characteristics.
ZMD does not guarantee that the use of any information contained herein will not infringe the patent, trademark, copyright, mask work
right or other rights of third parties, and no patent or licence is implied hereby. This document does not in any way extent ZMDs war-
ranty on any product beyond that set forth in its standard terms and conditions of sale.
ZMD reserves terms of delivery and reserves the right to make changes in the products or specifications, or both, presented in this
publication at any time and without notice.
© 2002 Zentrum Mikroelektronik Dresden AG. All rights reserved.
Release Notes, A²SI Revision C, August 28, 2002
ZMD AG
4/4
相关型号:
©2020 ICPDF网 联系我们和版权申明