3896/32SOSF [3M]

3Mâ¢ Round, Jacketed, Flat Cable .025 30 AWG Stranded, Mass-Term, PVC/PVC;


型号：	3896/32SOSF
厂家：	3M ELECTRONICS
描述：	3Mâ¢ Round, Jacketed, Flat Cable .025 30 AWG Stranded, Mass-Term, PVC/PVC
文件：	总5页 (文件大小：752K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

3M^™Round, Jacketed, Flat Cable

.025" 30AWG Stranded, Mass-Term, PVC/PVC

3896 Series

•ꢀ Round construction permits easier routing

•ꢀ 30AWG wire on .025 inch centers permits mass

termination

•ꢀ Continuous split/bond allows for mass termination on

2.4 inch centers (approximate)

•ꢀ Close spacing permits higher signal density

•ꢀ Primary cable is zippable for branching or discrete

terminations

•ꢀ PVC insulation provides excellent ﬂexibility

•ꢀ Recommended for use with 3M™ Tripolarized

Wiremount Socket 82XXX-600X, .050" x .100";

3M^™Mini D Ribbon (MDR) Wiremount Plug

101XX-8X00EE, .050"; and 3M^™Pak 50 IDC

Sockets P25E-XXXs-XXX

•ꢀ See Regulatory InformationAppendix (RIA for

chemical compliance information

(RIA E1 & C1 apply)

Date Modiﬁed: May 14, 2009

TS-2173-D

Sheet 1 of 2

Physical

Jacket Material: Polyvinyl Chloride (PVC)

Jacket Color: Black

Primary Material: Polyvinyl Chloride (PVC)

Color Gray

Marking Standard: ULAWM 20596 105C 30VVW1 3M NU

Conductors: 30AWG, 7 × 38AWG [ 7 × Ø 0.102 ] Tinned Stranded Copper

Inner Wrap: Polyester Film

Electrical

USA: 30V

EU: <50V

Voltage Rating:

(Primary Cable) >1 x 10¹⁰Ω /10 ft [3 m]

Insulation Resistance:

Unbalanced

Characteristic Impedance: 73 Ω

Balanced

121 Ω

20.8 pF/ft [ 68.2 pF/m ]

12.0 pF/ft [ 39.4 pF/m ]

0.18 μH/ft [ 0.57 μH/m ]

1.45 ns/ft [ 4.76 ns/m ]

70%

Capacitance:

Inductance:

0.11 μH/ft [ 0.36 μH/m ]

1.51 ns/ft [ 4.95 ns/m ]

67%

Propagation Delay:

Velocity of Propagation:

Note: Unbalanced is measured between ground-signal-ground conductors.Balanced is measured between conductors within a pair.

Environmental

-20°C to + 105°C

USA:VW-1

Temperature Rating:

Canada: FT1

Flammability Rating:

UL File No.: E42769, Style No.: 20596

3M is a trademark of 3M Company.

For technical, sales or ordering information call

Electronic Solutions Division

Interconnect Solutions

800-225-5373

http://www.3M.com/interconnects/

3M^™Round, Jacketed, Flat Cable

.025" 30AWG Stranded, Mass-Term, PVC/PVC

3896 Series

Number of

Conductors

3M Part

Number

Diameter A ꢀ03

Dimension B

(See Note 2)

100

3896/20

3896/26

3896/30

3896/32

3896/34

3896/36

3896/40

3896/50

3896/52

3896/60

3896/68

3896/80

3896/100

0.26 [ 6.6 ]

0.27 [ 6.9 ]

0.30 [ 7.6 ]

0.33 [ 8.4 ]

0.37 [ 9.4 ]

0.39 [ 9.9 ]

0.44 [ 11.2 ]

0.475 +/- .004 [12.70]

0.625 +/- .004 [15.88]

0.725 +/- .006 [18.42]

0.775 +/- .006 [19.69]

0.825 +/- .006 [20.96]

0.875 +/- .006 [22.23]

0.975 +/- .006 [24.77]

1.225 +/- .006 [31.12]

1.275 +/- .009 [32.39]

1.475 +/- .009 [37.47]

1.675 +/- .009 [42.55]

1.975 +/- .011 [50.17]

2.475 +/- .025 [62.87]

Inch

[Imm]

Tolerance Unless Noted

Inch

.00

.000

±.1

±.05 ±.010

[ ] Dimensions for Reference Only

2.40

61.0

TYP

BONDED

1.00

25.4

SPLIT

"B"

Ø "A"

Paper [Mfg

Optional]

0.026 [.66] Min.

PVC Jacket

Thickness

.025

TYP

0.64

Polyester Film

PVC Primary Insulation

30 AWG, 7 X 38 AWG [7X Ø 0.102]

Notes:

1. Red marking on edge of primary cable designates wire #1.

2. Dimension B refers to bonded area only.

Ordering Information

3896/XX XX XX

Blank = Standard

SF = Splice Free

Number of Conductors

(See Table)

Blank = Standard, Repeating Split/Bonded Wires

SO = Continuously Bonded Wire (No Split)

Note:Available in standard 275 ft roll length. Contact 3M for availability

of additional conductor counts and/or custom roll lengths.

TS-2173-D

Sheet 2 of 2

3M is a trademark of 3M Company.

For technical, sales or ordering information call

Electronic Solutions Division

Interconnect Solutions

800-225-5373

http://www.3M.com/interconnects/

Regulatory Information Appendix

3M Electronic Solutions Division/Interconnect

EUROPE

Appendix E1: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product is RoHS Compliant 2005/95/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E2: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/747/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E3: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as

amended by Commission Decision 2005/618/EC.

This product contains lead in the solder tail area in excess of the maximum concentration value allowed.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E4: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC, as amended by EU Commission Decision 2005/717/EC, as amended by

EU Court of Justice Decision 2008/C 116/04

This product contains decaBDE in the insulating material in excess of the maximum concentration allowed for ﬁnished

products subject to EU RoHS that are placed on the EU market after June 30, 2008.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

RIA-2217B-E

Appendix E5: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains lead in excess of the maximum concentration value allowed but is compliant by exemption under

Item 6 of the Annex to the Directive.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

CHINA

Appendix C1: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for

Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means that the

product or part does not contain any of the following substances in excess of the following maximum concentration values in any

homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated

diphenyl ethers (excluding decaBDE); or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix C2: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for

Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means that

the product or part does contain a substance, as detailed in the chart below, in excess of the following maximum concentration

values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or

polybrominated diphenyl ethers (excluding decaBDE); or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in

writing, this information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an

extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform with

3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in accordance with the

product Warranty stated below.

RIA-2217B-E

Appendix C3: China RoHS