HSHM-RAH176D4-8CP1-TG30 [3M]

176 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, PRESS FIT;


型号：	HSHM-RAH176D4-8CP1-TG30
厂家：	3M ELECTRONICS
描述：	176 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, PRESS FIT PC 连接器
文件：	总5页 (文件大小：1887K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

3M™ MetPak™ HSHM Press-Fit Header

2 mm Type RAH, 176 Signal Contacts, 8 Rows, Right Angle

HSHMSeries

• Up to 5 Gb/s data rates

• Low crosstalk at high frequencies

• 50/100 Ω (single-ended /differential)

impedance

• Modular/scalable format IEC 61076-4-101

• 101 mated lines per linear inch

• For high speed coplanar applications

• Multi-purpose center (MPC) for keying

and guidance

• Ships with protective caps which also serv

as a termination tool

• Integrated guide pins

• Mates with HSHM D sockets

• See Regulatory Information Appendix (RIA)

for chemical compliance information

TS-2081-02

Sheet 1 of 3

Date Modified: March 13, 2007

Physical

Insulation

Material:

High Temperature Thermoplastic (LCP)

Flammability:

Contact

UL 94V-0

Material:

Copper Alloy

Plating:

See Ordering Information

Performance

Mechanical

Normal Force (Nominal):

Engagement Force (Nominal):

Separation Force (Nominal):

Wipe (Nominal, Shortest Contact):

Durability:

0.57 N [ 58 g ] Signal, 0.74 N [ 75 g ] Shield

0.32 N [ 33 g ] Signal, 0.22 N [ 22 g ] Shield

0.20 N [ 20 g ] Signal, 0.20 N [ 20 g ] Shield

2.67 mm [ 0.105 in. ] Signal, 1.57 mm [ 0.062 in ] Shield

250 cycles with TR40B plating

Application:

This module is suitable for stand-alone use. (Refer to IEC-61076-4-101.)

Electrical

Data Rate:

5 Gb/s

Characteristic Impedance:

urrent Rating (Fully Loaded):

50 W Single-ended, 100 W Differential

C1 A at 70× C Signal

Insulation Resistance:

Withstanding Voltage:

10 MW at 100 V

750 V

RMS

Environmental

Temperature Rating:

-55×C to +125×C

MetPak is a trademark of 3M Company.

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

3M™ MetPak™ HSHM Press-Fit Header

2 mm Type RAH, 176 Signal Contacts, 8 Rows, Right Angle

HSHM Series

Interstitial

Ground

Contacts

49.85

1.963

2.00

.079

35.80

1.409

2.00

.079

Signal

Contacts

13.40

.528

Pin positions

2.00

.079

2.00

.079

10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

3.30

.130

5.00

.197

2.80

.110

21.40

.843

18.00

.709

5.70

.224

15.60

.614

11.80

.465

48.00

1.890

0.75

.030

5.30

.209

13.70

.539

[inch]

Tolerance Unless Noted

0.0

0.00

±3

±0.3 ±0.13

[ ] Dimensions for Reference Only

Ordering Information

HSHM - RAH176DX - 8CP1 - XXXXX

High Speed Option:

4 =Coaxial, column differential and

stripline (75W) applications

Plating μm [ μ″ ]:

TG30 = 0.76 [ 30 ] Min. Au Contact Area

2.54 [ 100 ] Min. SnPb Terminal Area

1.27 [ 50 ] Min. Ni All over

5 =Row differential applications

(RIA E2 & C2 apply)

TR40B = 0.127 [ 5 ] Min. Hard Au Contact Area, Lubricated

1.02 [ 40 ] Min. PdNi Contact Area

0.10 [ 4 ] Min. Pd Strike Contact Area

2.54 [ 100 ] Min. SnPb Terminal Area

1.27 [ 50 ] Min. Ni all over

(RIA E2 & C2 apply)

TS-2081-02

Sheet 2 of 3

For non-standard configurations contact sales representative

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

3M™ MetPak™ HSHM Press-Fit Header

2 mm Type RAH, 176 Signal Contacts, 8 Rows, Right Angle

HSHM Series

48.00

20.00

1.00

2.00

0.75

1.50

2.00

I, Z

10.50

-C-

10 11

15 16 17 18 19 20 21 22 23 24 25

1.50

O DIM A 226X

SEE TABLE

Recommended PCB hole mounting pattern for

coaxial, column differential and stripline applications.

l O 0.10 M A

-A-

I, Z

10 11

15 16 17 18 19 20 21 22 23 24 25

Recommended PCB hole mounting pattern for row

differential applications.

(Same geometry without ground vias)

HOLE PLATING TABLE mm [in.]

FINISHED HOLE DIA. “A”

Cu. THICKNESS

0.025 - 0.045 [.0010 - .0018]

SnPb THICKNESS

0.008 -0.018 [.0003 - .0007]

DRILLED HOLE DIA.

0.584 - 0.625 [.0230 - .0246]

0.457 - 0.559 [.0180 - .0220]

TS-2081-02

Sheet 3 of 3

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

Regulatory Information Appendix

3M Electronic Solutions Division/Interconnect

EUROPE

Appendix E1: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product is RoHS Compliant 2005/95/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E2: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC

This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/747/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E3: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as

amended by Commission Decision 2005/618/EC.

This product contains lead in the solder tail area in excess of the maximum concentration value allowed.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon

information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E4: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains decaBDE in the insulating material in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/17/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision

2005/618/EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in

writing, this information represents 3M’s best knowledge and belief based upon information provided by third party

suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

RIA-2217-B

CHINA

Appendix C1: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does not contain any of the following substances in excess of the following maximum

concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium,

polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise

stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information provided by

third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix C2: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does contain a substance, as detailed in the chart below, in excess of the following

maximum concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent

chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless

otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an

extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform

with 3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in

accordance with the product Warranty stated below.

Name and Content of Hazardous Substances or Elements

Important Notice

All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the

accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended

application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M’s

current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in

writing, by an authorized officer of 3M.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER

WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to

replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any

indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

Electronic Solutions Division

6801 River Place Blvd.

Austin, TX 78726-9000

800/225-5373

www.3M.com/interconnects

RIA-2217-B

HSHM-RAH176D4-8CP1-TG30 [3M]

相关型号：

SI9130DB

SI9135LG-T1

SI9135LG-T1-E3

SI9135_11

SI9136_11

SI9130CG-T1-E3

SI9130LG-T1-E3

SI9130_11

SI9137

SI9137DB

SI9137LG

SI9122E