ACT1100 [ACT]
Standard Clock Oscillators; 标准时钟振荡器型号: | ACT1100 |
厂家: | ADVANCED CRYSTAL TECHNOLOGY |
描述: | Standard Clock Oscillators |
文件: | 总3页 (文件大小:220K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Tel :
Fax :
email :
0044 (0)118 979 1238
0044 (0)118 979 1283
info@actcrystals.com
ACT1100 / ACT1700 Standard Clock Oscillators
The ACT1100 is a full size through hole oscillator. The ACT1700 is a half size through hole oscillator. The
popularity of these families still remains even after the advent of smaller surface mount devices. With wide
frequency and operating temperature ranges, these series offer low cost & good reliability for ATM, Networking,
Microprocessor and Consumer applications. An option with a supply voltage of 2.5V is available please contact
our sales desk for details. For frequencies < 500KHz, >125MHz & ± 10ppm stability please refer to the
ACT1100HS/1700HS data.
Specification
Parameter
Symbol
fo
Specification
500KHz ~ 125.0MHz
±25ppm, ±50ppm and ±100ppm
0 ~ +70°, -10 ~ +70°C
-40~85°C
Condition
Please Specify
Please Specify
Please Specify
Frequency Range
Frequency Stability
Temp Operating Range
Temp Storage Range
Supply Voltage
Δf/fo
Topr
Tstg
VDD
Please Specify
0.5 - 27MHz
27 - 125MHz
3.3Vdc ±10%
15mA max
5.0Vdc ±10%
25mA max
35mA max
Supply Current
Iop
25mA max
40/60%, 45/55% TTL
Measured at +1.4Volts
Measured at 50% VDD
VDD = 3.3V
Duty Cycle
TW/t
VOL
40/60%, 45/55% HCMOS
TTL 0.4V max, HCMOS .33V max
TTL 0.4V max, HCMOS 0.5V max
TTL 2.4V min, HCMOS 2.97V min VDD
TTL 2.4V min, HCMOS 4.5V min VDD
TTL / HCMOS
Output Level ‘0’
VDD = 5.0V
VDD = 3.3V
Output Level ‘1’
VOH
VDD = 5.0V
Output Logic
Output Load
TTL 10 Gates
CMOS 15 pF
TTL
10nSec max, 3nSec typical
Measured between 0.4V ~ 2.4V (RL = 390Ω ; CL = 15pF)
CMOS 10nSec max, 3nSec typical
Measured between 10%~ 90% VDD (CL = 15pF)
4mSec max,
Rise & Fall Time
tr/tf
Start-up Time
Option on Pin 1
Aging
Please Specify
@25°C
Tri State or No Connection
±5ppm / year max
Plating Material on leads
SnAgCu
Soldering conditions
please refer to page 3
ACT1100 ( 'V' SERIES )
ACT1700 ( 'CL' SERIES )
Please note that all parameters can not necessarily be specified in the same device
Customer to specify : Frequency, Operating Temperature Range, Frequency Stability, Supply Voltage, Duty Cycle, Output Enable (Tristate) If required
In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice
ISO9001:2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK
http://www.actcrystals.com
Issue 5 C1A
Date 23/3/6
1 of 3
Tel :
Fax :
email :
0044 (0)118 979 1238
0044 (0)118 979 1283
info@actcrystals.com
ACT1100 / ACT1700 Standard Clock Oscillators
Reliability tests
Measurement
Requirements
Test
Test Method
Helium bomb: Pressure 200kpa Time 70 min
pressure release 5 min measure within 30min
-9
<4x10 pa.m3/s
Leak
750mm height.
3 drops.
Onto wood.
Drop
Shock
Peak acceleration 981m/s2 Pulse duration 6ms
Each of X, Y and Z axis.
3 shocks each axis
10 to 55Hz and return to 10Hzamplitude 1.5mm sweep time 1min.
2 hrs each of X, Y and Z axis.
Vibration
Total test time 6 hrs
Resistance to
Soldering Heat
As per profile fig.1 below and/or soldering iron applied for 5s max tip
temperature 350±10°C
Aging
85±3°C 30 days measurements after at least 1 hr at atmospheric conditions.
105±3°C 16 hrs measurements after at least 1 hr at atmospheric conditions
-55±3°C 2hrs measurements after at least 1 hr at atmospheric conditions
Specification as
per page 1 must be
met.
High Temperature
Storage
Low Temperature
Storage
100cycles to the temperature profile fig 2 below. Measurements after at least 1
hr at atmospheric conditions
Thermal Cycling
Damp Heat
Constant
Temperature 40±2°C RH 90~95% for 56 days. Measurements after at 1 hr at
atmospheric conditions
255±5°C for 10±0.5s using Rosin resin methyl alcohol flux Solvent (1:4) dipped
to a nominal depth of 0.5mm.
Solderability
In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice
ISO9001:2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK
http://www.actcrystals.com
Issue 5 C1A
Date 23/3/6
2 of 3
Tel :
Fax :
email :
0044 (0)118 979 1238
0044 (0)118 979 1283
info@actcrystals.com
ACT1100 / ACT1700 Standard Clock Oscillators
Application circuits
In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice
ISO9001:2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK
http://www.actcrystals.com
Issue 5 C1A
Date 23/3/6
3 of 3
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明