PQ-34L5 [AEROFLEX]
RF/Microwave Phase Shifter, 1000 MHz - 2000 MHz, 360 deg RF/MICROWAVE PHASE SHIFTER;型号: | PQ-34L5 |
厂家: | AEROFLEX CIRCUIT TECHNOLOGY |
描述: | RF/Microwave Phase Shifter, 1000 MHz - 2000 MHz, 360 deg RF/MICROWAVE PHASE SHIFTER 射频 微波 |
文件: | 总2页 (文件大小:154K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
ANALOG DIODE
PHASE SHIFTERS
SERIES PQ
CONTINUOUSLY VARIABLE — 0.1–18 GHz
GENERAL INFORMATION
An analog phase shifter continuously changes the phase of a
microwave signal by varying a D.C. voltage. Since the D.C. voltage
applied to the diode is a reverse bias, the current drain is negligible
(typically less than 10 microamps). A balanced stripline configuration
keeps the VSWR and amplitude ripple to a minimum for all values of
phase.
GENERAL SPECIFICATIONS
Frequency Coverage:
RF impedance:
D.C. Voltage:
0.1 to 18.0 GHz
50 OHMS.
0 volts to +28 volts (standard), or 0 volts
to –28 volts (optional) will vary the phase
of any of the models over the minimum
phase shift listed
RF Power:
10 mW peak or CW, operating. Destruct
level is 1 W, CW, 100 W peak.
150
120
1.0
.8
Temperature Information:
The units can be used over a –55°C to
+85°C temperature range. However, the
phase will change either ±5° or ±5%,
whichever is greater. If temperature com-
pensation is required, this can be done on
request. With compensation, the variation
can be held to ±1° or ±1%, whichever is
greater, from –55°C to +85°C. The size
remains the same. If compensation is
desired, add a suffix T to the model num-
ber (e.g., PQ-17T).
.6
.4
.2
90
60
30
INSERTION
LOSS
PHASE
SHIFT
0
0
5
10
15
20
25
30
VOLTAGE (V)
Switching Speed:
Series PQ phase shifters can be driven
from any phase value to any other value
in 10 nanoseconds. With linearizers, the
response time is 50 nanoseconds. With
temperature compensation the response
time is 100 nanoseconds.
Fig. 1
Typical Phase & Insertion Loss vs. Voltage Curves for PQ-31
Connectors:
SMA
Notes:
160
1. LINEARIZATION: For phase shifters with linearizers add a suffix L
to the model number (e.g., PQ-23L). Linearity is ±2.0° for phase
shifters for 150° or less, and ±4° for phase shifters between 150°
and 360°. With linearization, DC voltages of ±15V at ±30mA are
required.The control voltage is 0–10 volts. A control voltage of 0–5
volts can be supplied at no additional cost, by adding a suffix 5 to
the model number (e.g. PQ-23L5). Linearity is measured at fc.
2. PHASE FLATNESS: The phase shift varies with frequency at any
voltage setting. This variation, referenced to 0° at 0 volts for each
frequency, is approximately ±15% for octave models, ± 10% for
models with 25% bandwidth, and ±7.5% for models with a 10%
bandwidth.
100
40
0.4
1.0
1.6
BIAS VOLTAGE VB (V)
3. A connector, (SMA Female) is available in place of the bias pin at
no extra charge. This will be placed at the center of the surface
marked F on the drawing. This is the 0.38 × A surface. If a SMA
Female is desired, add suffix C to the model number (e.g., PQ-
23C).
Fig. 2
Phase shift characteristic of PQ-45.
4. Monotonicity guaranteed for all models.
KEY: Inches[Millimeters] .XX .ꢀ0 .XXX .ꢀꢁꢀ [.X ꢀ.ꢂ .XX ꢀ.ꢃ2]
60 South Jefferson Road, Whippany, NJ 07981
Tel: 973-887-8100 • Fax: 973-884-0445
email: sales@mcekdi-integrated.com
See us on the web @ www.mcekdi-integrated.com
11-5-02
ANALOG DIODE
PHASE SHIFTERS
SERIES PQ
CONTINUOUSLY VARIABLE — 0.1–18 GHz
F SURFACE
E
C.V.
+15V
GND
–15V
0.25[6,3]
0.25[6,3]
E
GROUND
BIAS PIN
SMA
FEMALE
TYP.
SMA
FEMALE
TYP.
D
B
D
B
RF
RF
RF
0.20
[5,1]
F
F
C
C
0.40
[10,2]
0.10[2,5]
TYP.
0.10[2,5]
TYP.
A
0.38[9,7]
TYP.
A
0.38[9,7]
TYP.
1.00
[25,4]
0.093[2,36]
0.125[3,18]
DIA. THRU
3 MOUNTING
HOLES
DIA. THRU
3 MOUNTING
HOLES
OUTLINE WITHOUT LINEARIZER
OUTLINE WITH LINEARIZER
MECHANICAL OUTLINES
ELECTRICAL PERFORMANCE
Phase
Shift
Note 2
A
in
[mm]
B
in
[mm]
C
in
[mm]
D
in
[mm]
2.050
E
in
[mm]
2.250
F
in
[mm]
0.53
Insertion Amplitude
Loss Ripple
Out-
line
Outline
No
Maximum Linearizer Linearizer
Frequency Minimum Maximum Maximum
Model No.* Range GHz Degrees
VSWR
With
2.75
2.25
1.38
1
2
dB
0.6
0.6
4.5
3.0
4.5
1.2
0.8
4.5
0.7
3.0
5.0
2.0
1.2
8.0
12.0
12.0
2.0
5.0
17.0
2.0
dB
0.15
0.15
1.25
0.4
[69,91] [57,15] [35,05] [52,07] [57,15] [13,46]
PQ-12
PQ-14
PQ-17
PQ-27
PQ-28
PQ-31
PQ-33
PQ-34
PQ-39
PQ-44
PQ-45
PQ-49
PQ-59
PQ-60
PQ-65
PQ-66
PQ-72
PQ-73
PQ-74
PQ-94
0.1–0.2
0.2–0.4
0.25–0.5
0.5–1.0
0.5–1.0
0.95–1.25
1.0–2.0
1.0–2.0
1.7–2.4
2.0–4.0
2.0–4.0
2.2–2.3
4.0–8.0
4.0–8.0
6.0–18.0
7.0–12.4
8.0–12.4
8.0–10.0
8.0–18.0
16.0–17.0
50
50
1.35
1.35
1.70
1.50
1.75
1.40
1.50
1.80
1.40
1.60
1.90
1.50
1.60
1.90
2.5
1
1
10
3
4
1
2
8
2
3
5
3
2
9
7
9
2
7
9
2
1
1
10
3
4
1
6
4
6
3
5
3
6
9
7
9
6
7
9
6
1.25
[31,75] [50,8] [16,0] [45,7] [19,1]
5.00 2.00 N/A 1.800 4.500
2.00
0.63
1.800
0.750
0.25
[6,4]
0.25
360
180
360
120
60
3
[127,0] [50,8] 4 holes [45,7] [114,3] [6,4]
7.75 2.50 N/A 2.300 7.250 0.25
[196,8] [63,5] 4 holes [58,42] [184,15] [6,4]
6.50 2.00 N/A 1.800 6.000 0.25
[165,1] [50,8] 4 holes [45,7] [152,4] [6,4]
1.25
0.15
0.15
1.5
4
5
360
15
0.05
0.50
1.5
2.00
[50,8] [50,8] [25,4] [45,7] [38,1]
3.00 2.00 1.50 1.800 2.500
[76,2] [50,8] [38,1] [45,7] [63,5]
6.50 2.50 N/A 2.300 6.000
2.00
1.00
1.800
1.500
0.25
[6,4]
0.25
[6,4]
0.25
6
180
360
180
40
7
0.30
0.25
1.5
8
360
180
360
60
[165,1] [63,5] 4 holes [58,42] [152,4] [6,4]
5.00 2.00 N/A 1.800 4.500 0.50
[127,0] [50,8] 4 holes [45,7] [114,3] [12,7]
7.75 2.50 N/A 2.300 7.250 0.75
[196,8] [63,5] 4 holes [58,42] [184,15] [19,1]
2.0
9
2.0
2.20
1.75
1.75
2.50
1.65
0.50
1.0
10
180
360
50
3.5
0.20
*OPTIONS: (Add to Model No.)
T
L
ϭ
ϭ
Temp. Comp.
Linearization
C ϭ Bias Connector — SMA
0 to 5 Volts Control Voltage for Linearized Models.
5
ϭ
KEY: Inches[Millimeters] .XX .03 .XXX .010 [.X 0.8 .XX 0.25]
60 South Jefferson Road, Whippany, NJ 07981
Tel: 973-887-8100 • Fax: 973-884-0445
E-Mail: kdisales@aol.com
See us on the web @ www.kditriangle.com
TRIANGLE
An MCE Company
C O R P O R A T I O N
10/98
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明