APE2012 [APLUS]
very low cost voice and melody synthesizer with 4-bits CPU; 成本非常低的声音和旋律合成了4位CPU型号: | APE2012 |
厂家: | APLUS INTERGRATED CIRCUITS |
描述: | very low cost voice and melody synthesizer with 4-bits CPU |
文件: | 总6页 (文件大小:242K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
A
PLUS MAKE YOUR PRODUCTION A-PLUS
APExx12 Series
DATA SHEET
APLUS INTEGRATED CIRCUITS INC.
Address:
3 F-10, No. 32, Sec. 1, Chenggung Rd., Taipei,
Sales E-mail:
Taiwan 115, R.O.C.
sales@aplusinc.com.tw
(115)台北市南港區成功路㆒段 32 號 3 樓之 10.
Technology E-mail:
service@aplusinc.com.tw
TEL: 886-2-2782-9266
FAX: 886-2-2782-9255
WEBSITE : http: //www.aplusinc.com.tw
APExx12 Series
1.0 General Description
The APExx12 series are very low cost voice and melody synthesizer with 4-bits CPU. They have various
features including 4-bits ALU, ROM, RAM, I/O ports, timers, clock generator, voice and melody
synthesizer, and PWM (Direct drive) or D/A current outputs, etc. The audio synthesizer contains one
voice-channel and two melody-channels. Furthermore, they consist of 27 instructions in these devices.
With CMOS technology and halt function can minimize power dissipation. Their architectures are similar
to RISC, with two stages of instruction pipeline. They allow all instructions to be executed in a single
cycle, except for program branches and data table read instructions (which need two instruction cycles).
2.0 Features
(1) Single power supply can operate from 2.4V to 5.5V at 4MHz or 8MHz.
(2) Program ROM: 16k x 10 bits
(3) 1 set of 16-bits DPR can access up to 64k x 10 bits melody data memory space, and 1 set of 18-bits
VPR can access up to 256k x 10 bits voice data memory space.
Product
APE0612
APE1012
APE1512
APE2012
APE3112
APE4112
APE5212
APE6312
APE7312
APE8412
Voice Duration (sec) Voice Pointer (VPR) ROM Size (10-bit)
6
14-bits
15-bits
16-bits
16-bits
17-bits
17-bits
18-bits
18-bits
18-bits
18-bits
20k
32k
10
15
20
31
41
52
63
73
84
48k
64k
96k
128k
160k
192k
224k
256k
(4) Data Registers:
a). 128 x 4-bit data RAM (00-7Fh)
b). Unbanked special function registers (SFR) range: 00h-2Fh
(5) I/O Ports:
a). PRA: 4-bits I/O Port A (10h) can be programmed to input/output individually. (Register control)
b). PRB: 4-bits I/O Port B (13h) can be configured to input/output individually. (Mask option)
c). PRD: 4-bits I/O Port D (15h) can be programmed to input/output individually. (Register control)
(6) On-chip clock generator: Resistive Clock Drive (RM)
(7) Timer: 1-set Voice Interrupt (Timer0: a 9-bits auto-reload timer/counter).
(8) Stack: 2-level subroutine nesting.
(9) Built-in 4 Level Volume Control can be programmed.
1
Rev 1.3
2003/8/18
APExx12 Series
(10) Built-in 8 Level DAC current output can be configured. (Mask option)
(11) Built-in IR Carry Output: Port B[1] can be configured as IR pin by 38k / 56kHz. (Mask option)
(12) External Reset: Port B[3] can be configured as reset pin. (Mask opton)
(13) HALT and Release from HALT function to reduce power consumption
(14) Watch Dog Timer (WDT)
(15) Instruction: 1-cycle instruction except for table read and program branches which are 2-cycles
(16) Number of instruction: 27
(17) DAC: 1 channel voice and dual tone melody synthesizer (One 9-bits Cout or 8-bits PWM output).
FIGURE 1 : ROM Map of APExx12 Series
PC[13:0]
14-bit x 2 STACK
16-bit Data Pointer
18-bit Voice Pointer
Reset Vector
00000h
000FEh
000FFh-00400h
00401h
Reserved for Testing
00000h-03FFFh
Program ROM
00000h-0FFFFh
Data ROM for Melody
00000h-5FFFFh
Voice ROM for Voice
2
Rev 1.3
2003/8/18
APExx12 Series
3.0 Pin Description
Pad Name
PWM2/Cout
PWM1
Pin Attr.
Description
PWM2 output, or Current Output of Audio.
PWM1 output.
O
O
Vdd1~2
Power
Power supply during operation.
I/O port can be programmed to input/output individually.
Input type with weak pull-low or fix-input-floating capability.
Buffer Output type.
PRA0~3
PRD0~3
I/O
I/O
I/O port can be configured to input/output individually.
Input type with weak pull-low or fix-input-floating capability.
Buffer Output type.
PRB0, PRB2
PRB1 / IR
I/O port can be configured to input/output individually.
Input type with weak pull-low or fix-input-floating capability.
Buffer Output type.
I/O
I/O
Mask option selected as an IR Carrier Output with 38k / 56kHz
I/O port can be configured to input/output individually.
Input type with weak pull-low or fix-input-floating capability.
Buffer Output type.
PRB3 / Reset
Mask option selected as an external RESET pin with weak pull-low
capability.
OSC
I
RM mode Oscillator input
Ground Potential
GND1~3
Power
4.0 DC Characteristics
Symbol
Parameter
Vdd
Min.
Typ.
Max. Unit
Condition
Vdd
Operating voltage
2.4
3
5.5
1
1
V
depending on Freq.
3
4.5
3
4.5
3
4.5
3
4.5
3
4MHz, RM,
in HALT Mode
Isb
Iop
Iih
Standby
Supply
uA
current
2
7
3
10
-3
4MHz, RM,
IO Floating
Operating
mA
uA
Input current
(Internal pull low)
Input ports with weak
pull-low
Ioh
Iol
Output-high current
Output-low current
-10
7
19
0.8 ~ 4.8
0.9 ~ 6.5
4MHz, RM
(IO ports)
mA
4.5
3
4.5
DAC output current
(8-level option)
4MHz, RM
(Full scale)
Cout
mA
%
Fosc(3v- 2.4v)
Fosc (3v)
dF/F
dF/F
Frequency stability
Fosc lot variation
-5
5
Vdd=3V, Rosc=180k,
4MHz
-10
10
%
3
Rev 1.3
2003/8/18
APExx12 Series
FIGURE 2 : Frequency vs. Rosc (at 3V)
Resistor (Rosc ohms)
Frequency (MHz)
110k
200k
300k
430k
14.84
8.25
5.54
3.92
Rosc vs Freq.
20
15
10
5
14.84
8.25
5.54
3.92
0
0
100
200
300
400
500
Rosc (k ohm )
5.0 Application Circuit
4
Rev 1.3
2003/8/18
APExx12 Series
6.0 Bonding Diagram
ROM
1
PWM1
PRD3 20
PRD2 19
Y
2
Vdd2
Pad Size : 80 um x 80 um
18
17
16
PRD1
PRD0
* The IC substrate must be connected to GND.
PWM2/Cout
GND3
3
OSC
GND1 15
4
PRB0
10
GND2
5
PRA2
8
PRA3
9
PRA0
6
PRA1
7
PRB1
11
Vdd1
14
PRB2
12
PRB3
13
(0,0)
X
Pad #
Pad Name
PWM1
Vdd2
X
Y
Pad #
11
Pad Name
PRB1
PRB2
PRB3
Vdd1
X
Y
1
2
57
865
670
386
235
87
725
835
87
12
58
87
3
13
PWM2/ Cout
GND3
58
945
87
4
58
14
1055
1059
1059
1059
1059
1059
1059
87
5
15
GND2
65
GND1
OSC
241
351
461
571
681
791
6
PRA0
175
285
395
505
615
87
16
7
17
PRA1
87
PRD0
PRD1
PRD2
PRD3
8
18
PRA2
87
9
19
PRA3
87
10
20
PRB0
87
Chip Size :
APE0612 : 1230 um x 1530 um,
APE1512 : 1230 um x 1758 um,
APE3112 : 1230 um x 2210 um,
APE5212 : 1230 um x 3116 um,
APE7312 : 1230 um x 3116 um,
APE1012 : 1230 um x 1530 um
APE2012 : 1230 um x 1758 um
APE4112 : 1230 um x 2210 um
APE6312 : 1230 um x 3116 um
APE8412 : 1230 um x 3116 um
5
Rev 1.3
2003/8/18
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明