HGOV5S3-FREQ [CONNOR-WINFIELD]
HCMOS Output Clock Oscillator, 20MHz Min, 80MHz Max;
| 型号： | HGOV5S3-FREQ |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | HCMOS Output Clock Oscillator, 20MHz Min, 80MHz Max 机械 振荡器 |
| 文件： | 总2页 (文件大小：214K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
14 PIN DIP 5.0V HCMOS STRATUM 3 OCVCXO
CW 0107
HGOV5S3
65.536M
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
Storage Temperature
Supply Voltage
-40
-0.5
-0.5
-
-
-
85
7.0
7.0
(Vcc)
(Vc)
Vdc
Vdc
Control Voltage
HGOV5S3
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
DESCRIPTION
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
Center Frequency
(Fo)
20
-
80
1.5
0.25
1.0
4.6
85
5.25
375
1
Frequ3ncy Calibration (Vc=2.18V)
Frequency Stability
Frequency Aging (1st Year)
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-1.5
-
ppm
1
2
The Connor-Winfield HGOV5S3
is a low profile hermetically
sealed 14 Pin DIP 5.0V Oven
Controlled Voltage Controlled
Crystal Oscillator (OCVCXO)
with an HCMOS output. The
HGOV5S3 is designed for high
frequency, industrial
-0.25
-
ppm
-1.0
-
ppm
-4.6
-
ppm
3
-40
-
°C
(Vcc)
(Icc)
4.75
5.00
Vdc
Supply Current
-
-
-
-
-
-
-
-
-
-
-
mA
Phase Jitter (BW =12KHz to 20MHz)
Phase Jitter (BW =10Hz to 20MHz)
Period Jitter
-
pS RMS
pS RMS
pS RMS
dBc/Hz
dBc/Hz
mS
-
3
-
3
temperature range, Stratum 3
applications requiring low jitter
and tight frequency stability.
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 10KHz offset
Start Up Time: Oscillator
Warm Up Time
-75
-
-130
-
-
-
-
-
10
5
Minute
nS
4
TDEV @ 1.0 Sec.
1
TDEV @ 4.0 Sec.
2
nS
FEATURES
INTPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
5.0V OPERATION
Control Voltage Range
Frequency at Vc=0.5 Vdc
Frequency at Vc=4.1 Vdc
Slope of Frequency Adjust
Input Impedance
(Vc)
0.5
-30
18
2.18
4.1
-18
30
-
-
-
-
-
ppm
5
5
FREQUENCY ADJUST
ppm
10
ppm/V
Ohm
LOW JITTER <1pS RMS
100k
-
FREQUENCY STABILITY: ±0.25ppm
TEMPERATURE RANGE: -40 to 85°C
HCMOS OUTPUT CHARACTERISTICS
PARAMETER
TABLE 4.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
pf
LOAD
-
4.0
-
-
-
-
15
-
FREQUENCY TOLERANCE OF: ±1.0ppm
OVER THE FIRST YEAR, ±4.6ppm OVER
TEN YEARS
Voltage
Current
(High)
(Low)
(High)
(Low)
(Voh)
(Vol)
(Ioh)
(Ioh)
Vdc
Vdc
mA
mA
%
0.4
-
-4
-
-
50
-
4
HERMETICALLY SEALED LOW PROFILE
PACKAGE
Duty Cycle measured at 1.5V
Rise / Fall Time 10% to 90%
45
-
55
6
nS
TABLE 5.0
PACKAGE CHARACTERISTICS
Package
14 pin DIP, hermetically sealed, grounded case, welded package
Notes:
ORDERING INFORMATION
1) Initial calibration at time of shipment after 48 hours of operation, @ 25°C, Vc = 2.18V.
2) Frequency vs. temperature stability referenced to 25°C, Vc = 2.18V.
3) Inclusive of calibration, operating temperature range, supply voltage change, load change, shock
and vibration, 10 years aging, Vc = 2.18V.
4) After five minute of operation at 25°C, the unit will be within +/-0.1ppm of its final stabilized
frequency. The final stabilized frequency is that which is measured after 30 minutes of continuous
operation at a stable 25°C ambient temperature.
HGOV5S3 - 65.536MHz
OCXO
SERIES
CENTER
FREQUENCY
5) Referenced to Fo @ 25°C, Positive Transfer Characteristic
Specifications subject to change without notice.
1/15/04
Cx066
1
2
00
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
ENVIRONMENTAL CHARACTERISTICS
Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1minute
transition.
Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20
seconds.
SOLDERING
Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage.
Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board-mount product, 260°C
±5°C for 20 Seconds.
MECHANICAL CHARACTERISTICS
Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15minute cycles 12 times each
perpendicular axis.
Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, halfsine, 3 shocks per direction.
Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C.
CONTROL VOLTAGE
TEST DIAGRAM
14
1
8
7
4.1Vdc
5.0Vdc
Specifications subject to change without notice.
1/15/04
Cx066
00
2
2
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
相关型号：
©2020 ICPDF网 联系我们和版权申明