VPLB434J3E-S4-167.3316MHZ [CONNOR-WINFIELD]
Oscillator;
| 型号： | VPLB434J3E-S4-167.3316MHZ |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | Oscillator |
| 文件： | 总2页 (文件大小：202K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
CW 0107
VPLB434J3E-S4
155.52M
3.3V SURFACE MOUNT LVPECL VCXO OSCILLATOR
WITH A SELECTABLE OUTPUT FREQUENCY
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
VPLB434J3E-S4
Storage Temperature
-40
-0.5
-0.5
-
-
-
85
7.0
7.0
Supply Voltage
(Vcc)
(Vc)
Vdc
Vdc
Control Voltage
OPERATING SPECIFICATIONS
PARAM ETER
TABLE 2.0
NOTE
DESCRIPTION
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
-
-
Center Frequency
Center Frequency
Center Frequency
Output Select “0x “
Output Select “10”
Output Select “11”
(Fo)
(Fo)
(Fo)
155.5200
-
-
166.6286
MHz
The Connor-Winfield
VPLB434J3E-S4 is a 3.3V
Voltage Controlled Crystal
-
-
167.3316
MHz
Frequency Calibration @ 25°C
Frequency vs. Temperature
Frequency vs. Supply Voltage
Frequency vs. Load
-20
-
20
ppm
-34
-
34
ppm
Oscillator (VCXO) with LVPECL
Differential outputs. Based on
fundamental strip crystal design,
the VPLB434J3E-S4 is designed
for use in Phased Lock Loop
SDH/SONET systems requiring
low jitter and tight stability. The
VPLB434J3E-S4 has a
-4
-
4
ppm
-2
-
-
2
ppm
Aging 1st year
-2
2
ppm
Operating Temperature Range
Supply Voltage
5
-
65
°C
(Vcc)
(Icc)
3.135
3.3
-
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
-
-
80
5
<1
-
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 80MHz)
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
SSB Phase Noise at 1MHz offset
SSB Phase Noise at 10MHz offset
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-80
-115
-140
-150
-150
-150
-
selectable output: 155.52MHz,
166.6286MHz or 167.3316MHZ.
-
-
-
-
INPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
NOTE
FEATURES
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
ppm
%
Control Voltage Range
(Vc)
0.3
1.65
3.0
Absolute Pull Range (APR)
Monotonic Linearity
+/-50
-
+/-100
1
SELECTABLE OUTPUT: 155.52MHz,
166.6286MHz or 167.3316MHz
-20
-
20
Input Impedance
-
50K
-
Ohm
KHz
Vdc
Vdc
Vdc
Vdc
-
-
-
-
Modulation Bandwidth (3dB)
Enable Input Voltage (High)
Disable Input Voltage (Low)
Output “0” Select Voltage (Low)
Output “1” Select Voltage (High)
10
-
LOW PROFILE, SURFACE MOUNT
PACKAGE
(Vih)
(Vil)
“0”
>70% Vcc
-
2
2
-
<30% Vcc
<30% Vcc
-
3.3V SUPPLY VOLTAGE
-
-
“1”
>70% Vcc
LOW JITTER <1pS RMS
LOW VOLTAGE PECL OUTPUT CHARACTERISTICS
PARAM ETER
TABLE 4.0
NOTE
3
MINIMUM NOMINAL MAXIMUM
UNITS
Ohms
Vdc
Vdc
%
FREQUENCY TOLERANCE ±34ppm
TEMPERATURE RANGE:-5° TO 65°C
DIFFERENTIAL LVPECLOUTPUTS
ENABLE/DISABLE FUNCTION
TAPEAND REEL PACKAGING
LOAD
-
-
-
50
-
Voltage
(High)
(Low)
(Voh)
(Vol)
2.275
-
45
-
-
1.68
55
Duty Cycle at 50% Level
50
0.6
Rise and Fall Times measured 20% to 80%
1.0
nS
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Non-hermetic package consisting of an FR4 substrat e with grounded metal
cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
The component solder used internal to this device has a m elting point of
221°C. The peak temperature inside the device should be less than or
equal to 220°C for a maximum of 10 seconds
ORDERING INFORMATION
Wash
Notes
Ultrasonic cleaning is not recommended.
1.0
2.0
3.0
Absolute pull range (APR) is the minimum guaranteed pull range of the VCXO under all conditions over lifetime operation.
The APR is referenced to Fo. Positive Transfer Function.
When the oscillator is disabled the true output is in a low state (Voi), the complementary output is in the high state (Voh).
The enable/disable input has an internal 75k ohm pull-down resistor.
VCXO
SERIES
CENTER
FREQUENCY
Output terminated into 50 ohms into Vcc – 2.0Vdc or Thevenin equivalent.
Specifications subject to change without notice.
2/28/03
Vx454
1
2
00
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
.140 MAX
(3.55mm)
Pin Function
1
Control Voltage
2
3
6
7
Output Select S1
Output Select S2
Enable / Disable
Ground
8
Output Q
9
14
Comp Output Q
Supply Voltage (Vcc)
Output Frequency
155.5200 MHz
166.6286 MHz
Pin 2 (S1)
Pin 3 (S2)
0
1
1
x
0
1
Dimensional Tolerance:
±.005 (.127mm)
167.3316 MHz
x = does not matter
3.3Vdc
3.3Vdc
14
9
8
1
2 3
6 7
CONTROL
VOLTAGE
S1
S2
E/D
Specifications subject to change without notice.
2/28/03
Vx454
00
2
2
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
相关型号：
VPLB54TEDS2-156.25MHZ
LVPECL Output Clock Oscillator, 156.25MHz Nom, SURFACE MOUNT PACKAGE-14
CONNOR-WINFIE
VPLB54TEDS3-138.8125MHZ
LVPECL Output Clock Oscillator, 138.8125MHz Nom, SURFACE MOUNT PACKAGE-14
CONNOR-WINFIE
VPLB54TEDS4-155.52MHZ
LVPECL Output Clock Oscillator, 155.52MHz Nom, SURFACE MOUNT PACKAGE-14
CONNOR-WINFIE
©2020 ICPDF网 联系我们和版权申明